基于HT46R46E/HT46C46E经济A/D型八位单片机 HT46R46E/HT46C46E 是8 位高性能精简指令集单片机，专门为需要A/D 转换的产品而设计，例如传感器信号输入。掩膜版本HT46C46E 与OTP 版本HT46R46E 引脚和功能完全相同。在HT46R46E/HT46C46E 封装片里包含两颗芯片：一颗是HT46R46E/HT46C46E 单片机，另一颗是作为通用数据存储器的128×8 位的EEPROM。这两颗芯片邦定在一起封装为HT46R46E/HT46C46E。
上传时间： 2013-10-31
上传用户：fdfadfs
HT45R35VC/R-F型八位OTP单片机 HT45R35V 是一款C/R-F 型具有8 位高性能精简指令集的单片机，专门为需要VFD 功能的产品而设计。 秉承HOLTEK MCU 一般特性，该单片机带有暂停和唤醒功能，振荡器选项等等，这些都保证使用者的应用只需极少的外部元器件便可实现。这款单片机专门为直接与VFD 面板相连的VFD 应用而设计。集成C/R-F 功能，外加功耗低、性能良好、I/O 使用灵活、成本低等优势，使这款单片机可以广泛应用于VFD 相关产品中，例如家电定时产品，各种消费产品，子系统控制器，其他家电应用等方面。
上传时间： 2013-11-07
上传用户：semi1981
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
标签： Pulsoximeter Single-Chip Des
上传时间： 2013-10-27
上传用户：黑漆漆
DAC0832是一个8位D/A转换器芯片，单电源供电，从+5V～+15V均可正常工作，基准电压的范围为±10V，电流建立时间为1μs，CMOS工艺，低功耗20mW。其内部结构如图9.1所示，它由1个8位输入寄存器、1个8位DAC寄存器和1个8位D/A转换器组成和引脚排列如图1所示。 • DAC0832工作方式• ADC0809工作方式要求掌握：• MCS-51单片机与D/A转换器的接口连接• MCS-51单片机与A/D转换器的接口连接• 初始化编程及应用了解：• 典型D/A转换器芯片DAC0832的管脚功能• 典型A/D转换器芯片ADC0809的管脚功能
上传时间： 2014-01-14
上传用户：zl520l
ADC0809是带有8位A/D转换器、8路多路开关以及微处理机兼容的控制逻辑的CMOS组件。它是逐次逼近式A/D转换器，可以和单片机直接接口。 adc0809 datasheet
上传时间： 2013-10-11
上传用户：kz_zank
This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
上传时间： 2013-11-21
上传用户：zhaoke2005
The PCA9540B is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register.
上传时间： 2014-12-28
上传用户：nshark
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
标签： 4channel transla level 9519
上传时间： 2013-11-19
上传用户：jisiwole
The PCA9544A provides 4 interrupt inputs, one for each channeland one open drain interrupt output. When an interrupt is generated byany device, it will be detected by the PCA9544A and the interruptoutput will be driven LOW. The channel need not be active fordetection of the interrupt. A bit is also set in the control byte.Bits 4 – 7 of the control byte correspond to channels 0 – 3 of thePCA9544A, respectively. Therefore, if an interrupt is generated byany device connected to channel 2, the state of the interrupt inputs isloaded into the control register when a read is accomplished.Likewise, an interrupt on any device connected to channel 0 wouldcause bit 4 of the control register to be set on the read. The mastercan then address the PCA9544A and read the contents of thecontrol byte to determine which channel contains the devicegenerating the interrupt. The master can then reconfigure thePCA9544A to select this channel, and locate the device generatingthe interrupt and clear it. The interrupt clears when the deviceoriginating the interrupt clears.
标签： 4channel multiple 9544A 9544
上传时间： 2014-12-28
上传用户：潜水的三贡
The PCA9542A is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register. Two interrupt inputs, INT0 and INT1, one for each of theSCx/SDx downstream pairs, are provided. One interrupt output, INT, which acts as anAND of the two interrupt inputs, is provided.
上传时间： 2013-12-07
上传用户：europa_lin
