A Single-Chip Pulsoximeter Des - 免费下载
单片机编程资源
文件大小：241 K
📋 资源详细信息
💡 温馨提示：本资源由用户 xxjjyy1237 上传分享，仅供学习交流使用。如有侵权，请联系我们删除。
资源简介
This application report discusses the design of non-invasive optical plethysmography
also called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). The
pulsoximeter consists of a peripheral probe combined with the MCU displaying the
oxygen saturation and pulse rate on a LCD glass. The same sensor is used for both
heart-rate detection and pulsoximetering in this application. The probe is placed on a
peripheral point of the body such as a finger tip, ear lobe or the nose. The probe
includes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) and
the other in the infrared spectrum (940nm). The percentage of oxygen in the body is
worked by measuring the intensity from each frequency of light after it transmits
through the body and then calculating the ratio between these two intensities.
also called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). The
pulsoximeter consists of a peripheral probe combined with the MCU displaying the
oxygen saturation and pulse rate on a LCD glass. The same sensor is used for both
heart-rate detection and pulsoximetering in this application. The probe is placed on a
peripheral point of the body such as a finger tip, ear lobe or the nose. The probe
includes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) and
the other in the infrared spectrum (940nm). The percentage of oxygen in the body is
worked by measuring the intensity from each frequency of light after it transmits
through the body and then calculating the ratio between these two intensities.
立即下载此资源
提示：下载后请用压缩软件解压，推荐使用 WinRAR 或 7-Zip
资源说明
下载说明
- 下载需消耗 2积分
- 24小时内重复下载不扣分
- 支持断点续传
- 资源永久有效
使用说明
- 下载后用解压软件解压
- 推荐 WinRAR 或 7-Zip
- 如有密码请查看说明
- 解压后即可使用
积分获取
- 上传资源获得积分
- 每日签到免费领取
- 邀请好友注册奖励
- 查看详情 →