The PCA9674/74A provide general purpose remote I/O expansion for most microcontroller families via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plus (Fm+) family.
上传时间： 2013-10-28
上传用户：linyao
The PCA9536 is an 8-pin CMOS device that provides 4 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-10-27
上传用户：w230825hy
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-11-17
上传用户：vodssv
SAE J1939协议是由汽车工程协会(SAE)定义的，SAE J1939协议在商用车辆、舰船、轨道机车、农业机械和大型发动机中是应用最广泛的应用层协议，基于传输可靠性能优越的CAN-bus总线，可达到250Kbps的通讯速率。在协议中，不仅指定了传输类型、报文结构及其分段、流量检查等，而且报文内容本身也做了精确的定义，SAE J1939协议由美国SAE( Society of Automotive Engineer)组织维护和推广
上传时间： 2013-12-02
上传用户：lyson
NEC 16位MCU参考手册 The 78K0R/IC3 is a 16-bit single-chip microcontroller that uses a 78K0R CPU core and incorporates peripheral functions, such as ROM/RAM, a multi-function timer, a multi-function serial interface, an A/D converter, a programmable gain amplifier (PGA), a comparator, a real-time counter, and a watchdog timer.
上传时间： 2013-11-02
上传用户：努力努力再努力
The CAT25128 is a 128−Kb Serial CMOS EEPROM device internally organized as 16Kx8 bits. This features a 64−byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through a Chip Select (CS) input. In addition, the required bus signals are clock input (SCK), data input (SI) and data output (SO) lines. The HOLD input may be used to pause any serial communication with the CAT25128 device. The device featuressoftware and hardware write protection, including partial as well as full array protection.
上传时间： 2013-11-15
上传用户：fklinran
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
标签： Pulsoximeter Single-Chip Des
上传时间： 2013-10-27
上传用户：黑漆漆
1.1 微型计算机的组成及工作原理1.1.1 微型计算机中的基本概念1. 微处理器2. 微型计算机 (1)单片微处理机 (2)通用微型计算机3. 微型计算机系统1.1.2 微机基本结构 微型计算机的基本组成如图1.1所示，它由中央处理器（CPU）、存储器（Memory）、输入输出接口（I/O接口）和系统总线（BUS）构成。 1.1.3 微型计算机的基本工作过程 微型计算机的基本工作过程是执行程序的过程，也就是CPU自动从程序存放的第1个存储单元起，逐步取出指令、分析指令，并根据指令规定的操作类型和操作对象，执行指令规定的相关操作。如此重复，周而复始，直至执行完程序的所有指令，从而实现程序的基本功能，这就是微型计算机的基本工作原理。 1.2 典型单片机产品简介1.2.1 MCS-51单片机系列 MCS-51可分为两个子系列和4种类型，如表1-1所示。按资源的配置数量，MCS-51系列分为51和52两个子系列，其中51子系列是基本型，而52子系列属于增强型。表1-1 MCS-51系列单片机分类
上传时间： 2013-11-07
上传用户：debuchangshi
数字时钟应用资料 单片计算机即单片微型计算机。（Single-Chip Microcomputer ）,是 集CPU ,RAM ,ROM ,定时，计数和多种接口于一体的微控制器。他体积小，成本低，功能强，广泛应用于智能产品和工业自动化上。而51 单片机是各单片机中最为典型和最有代表性的一种。这次毕业设计通过对它的学习，应用，从而达到学习、设计、开发软、硬的能力。
上传时间： 2013-10-13
上传用户：zhqzal1014
HCS12微控制器MC9S12DP256 第一步： 1) HCS12 技术概述2) Operating Modes工作模式3) Resource Mapping资源映射4) External Bus Interface外部总线接口5) Port Integration Module端口集成模块6) Background Debug Mode背景调试模块
上传时间： 2013-12-20
上传用户：源码3
