·详细说明：使用凌阳单片机的多命令语音识别范例- The use insults the positive monolithic integrated circuit the multi- orders speech recognition model 文件列表: Recognise_SD ............\bsrSD.h ............\
上传时间： 2013-04-24
上传用户：moshushi0009
·详细说明：双音多频（DTMF）信号发生器的使用源程序，vc 编写，与《双音多频（DTMF）接收器的使用源程序》联合用- The double sound multi- frequencies (DTMF) the signal generating device use source program, the vc compilation, (DTMF) Receiver Use Source p
上传时间： 2013-07-23
上传用户：tianjinfan
·详细说明：双音多频的DTMF信号编码程序，产生DTMF信号进行编码。- The double sound multi- frequencies DTMF signal coded program, produces the DTMF signal to carry on the code.
上传时间： 2013-04-24
上传用户：yangzhiwei
With more and more multi-frequency clocks being used in today's chips, especially in the communications field, it is often necessary to switch the source of a clock line while the chip is running.
上传时间： 2013-10-10
上传用户：1214209695
This document presents design techniques and reference circuits that power Virtex™-4 FXRocketIO™ multi-gigabit transceivers (MGTs) operating at data rates below 3.125 Gb/s.When using multiple transceivers, it is sometimes preferred to power them from a switchingpower supply. However, switching power supplies generate noise that affects transceiver
上传时间： 2013-11-18
上传用户：huang111
Power over Ethernet (PoE) is a new development thatallows for the delivery of power to Ethernet-based devicesvia standard Ethernet CAT5 cable, precluding the need forwall adapters or other external power sources. The PoEspecification defines a hardware detection protocol wherePower Sourcing Equipment (PSE) is able to identify PoEPowered Devices (PDs), thus allowing full backwardscompatibility with non-PoE-aware (legacy) Ethernetdevices.
上传时间： 2013-11-11
上传用户：daoyue
For a variety of reasons, it is desirable to charge batteriesas rapidly as possible. At the same time, overchargingmust be limited to prolong battery life. Such limitation ofovercharging depends on factors such as the choice ofcharge termination technique and the use of multi-rate/multi-stage charging schemes. The majority of batterycharger ICs available today lock the user into one fixedcharging regimen, with at best a limited number ofcustomization options to suit a variety of application needsor battery types. The LTC®1325 addresses these shortcomingsby providing the user with all the functionalblocks needed to implement a simple but highly flexiblebattery charger (see Figure 1) which not only addressesthe issue of charging batteries but also those of batteryconditioning and capacity monitoring.
上传时间： 2013-10-19
上传用户：royzhangsz
目录： 1. Character Type Functions － 字符类型函数 2. Standard C Input/Output Functions － 标准输入输出函数 3. Standard Library Functions － 标准库和内存分配函数 4. Mathematical Functions － 数学函数 5. String Functions － 字符串函数 6. BCD Conversion Functions － BCD 转换函数 7. Memory Access Functions － 存储器访问函数 8. Delay Functions － 延时函数 9. LCD Functions － LCD函数 10. LCD Functions for displays with 4x40 characters － 4×40 字符型LCD函数 11. LCD Functions for displays connected in 8 bit memory mapped mode －以8 位外部存储 器模式接口的LCD显示函数 12. I2C Bus Functions － I2C 总线函数 13. National Semiconductor LM75 Temperature Sensor Functions － LM75 温度传感器函数 14. Dallas Semiconductor DS1621 Thermometer/Thermostat Functions － DS1621 温度计函 数 15. Philips PCF8563 Real Time Clock Functions － PCF8563 实时时钟函数 16. Philips PCF8583 Real Time Clock Functions － PCF8583 实时时钟函数 17. Dallas Semiconductor DS1302 Real Time Clock Functions － DS1302 实时时钟函数 18. Dallas Semiconductor DS1307 Real Time Clock Functions － DS1307 实时时钟函数 19. 1 Wire Protocol Functions － 单线通讯协议函数 20. Dallas Semiconductor DS1820/DS1822 Temperature Sensors Functions － DS1820/1822 温度传感器函数 21. SPI Functions － SPI 函数 22. Power Management Functions － 电源管理函数 23. Gray Code Conversion Functions － 格雷码转换函数
上传时间： 2013-10-22
上传用户：归海惜雪
为解决当前计算机串行通讯接口只有USB，难以满足旧型号设备或某些单片机要求RS232通讯的问题，设计出两款RS232/USB电路。采用CH341A与MAX223集成电路芯片构建标准9线RS232/USB通用接口转换器，无需编程。采用CH341A与PIC16F877A构建单片机与计算机之间的USB通讯电路，软件遵循RS232通讯协议，硬件进行电平转换。实际使用表明，这两款产品与计算机端Windows 操作系统下的串口应用程序完全兼容，且通讯过程中无握手失败现象。 Abstract: To solve the problem that current computer serial communication only with USB interface can not satisfy with the old type equipments or MCU to communicate with RS232， two kinds of RS232/USB circuit were designed.CH341A and MAX223 integrated circuit chips were used to create a standard 9-line RS232/USB universal interface convertor without programme. CH341A and PIC16F877A chips were adopted to build the USB communication circuit between computers and MCU. The software follows RS232 communication protocol， and the hardware converts electrical levels. Actual practices indicate that the two manufactures are compatible with serial application program of Windows operation system completely，and get avoid of handshake lost.
上传时间： 2013-11-03
上传用户：siying
以太网和CAN总线应用广泛，但由于其通信协议不同，两种总线器件间无法进行数据通信，因此，设计了基于CP2200与C8051F040的以太网总线与CAN总线接口转换电路，并给出部分相关硬件电路与软件设计分析。在保证数据完整和协议可靠的前提下，通过握手协议和简化的以太网协议，不仅实现了以太网数据与CAN数据的转发，同时还顺利的解决了以太网的高速性与CAN的低速率冲突，以及两者数据包之间的大小不同的矛盾。 Abstract: In the development of actual application， Ethernet and CAN bus are used very extensively. Owing to its various communication protocols， the communicating between two kinds of bus device can’t be carried out. Therefore， in order to solve this problem， the Ethernet-CAN bus interface circuit based on CP2200 and C8051F040 was designed in this paper， and part of the related hardware circuit and software design analysis were given. On the condition of data’s integrity and protocols’reliability， through the handshaking protocols and the simplified the Ethernet protocol， not only the data switching between CAN and Ethernet was realized， but also the differ in velocity and packet size was solved.
上传时间： 2013-10-15
上传用户：Ants
