Abstract: With its small size and large load (10W) capability, the MAX13256 H-bridge transformer driver is an attractive solution forcharging supercapacitors (supercaps). However, a large capacitance on the output of the circuit can force the driver into fault modeat startup, due to the high initial charge current. This application note presents a solution that allows users to charge a largecapacitance without going into fault.
上传时间： 2013-10-20
上传用户：2728460838
该文介绍了填谷式无源功率因数校正( PFC)电路的工作原理及其在基于离线式电源开关IC的LED驱动器中的应用。
上传时间： 2013-11-08
上传用户：84425894
功率场效应晶体管由于具有诸多优点而得到广泛的应用；但它承受短时过载的能力较弱，使其应用受到一定的限制。分析了MOSFET器件驱动与保护电路的设计要求；计算了MOSFET驱动器的功耗及MOSFET驱动器与MOSFET的匹配；设计了基于IR2130驱动模块的MOSFET驱动保护电路。该电路具有结构简单，实用性强，响应速度快等特点。在驱动无刷直流电机的应用中证明，该电路驱动能力及保护功能效果良好。
上传时间： 2013-12-18
上传用户：ccclll
介绍了以PIC16F690单片机为核心的控制系统实现方法,给出了设计的总体框图,部分硬件电路和控制软件流程图。该驱动器现已投入生产,经实际应用表明,该设计具有结构简单、精确、高效等特点,能够满足实际工程应用的要求。
上传时间： 2013-11-24
上传用户：xiaohuanhuan
The makers of handheld medical, industrial and consumerdevices use a wide variety of high resolution, small tomedium sized color TFT LCD displays. The power supplydesigners for these displays must contend with shrinkingboard area, tight schedules, and variations in displaytypes and feature requirements. The LTC®3524 simplifi esthe designer’s job by combining a versatile, easily programmed,TFT LCD bias supply and white LED backlightdriver in a low profi le 4mm × 4mm QFN package.
上传时间： 2013-10-26
上传用户：chens000
Piezoelectric motors are used in digital cameras for autofocus,zooming and optical image stabilization. Theyare relatively small, lightweight and effi cient, but theyalso require a complicated driving scheme. Traditionally,this challenge has been met with the use ofseparatecircuits, including a step-up converter and an oversizedgeneric full-bridge drive IC. The resulting high componentcount and large board space are especially problematicin the design of cameras for ever shrinking cell phones.The LT®3572 solves these problems by combining astep-up regulator and a dual full-bridge driver in a 4mm× 4mm QFN package. Figure 1 shows a typical LT3572Piezo motor drive circuit. A step-up converter is usedto generate 30V from a low voltage power source suchas a Li-Ion battery or any input power source within thepart’s wide input voltage range of 2.7V to 10V. The highoutput voltage of the step-up converter, adjustable upto 40V, is available for the drivers at the VOUT pin. Thedrivers operate in a full-bridge fashion, where the OUTAand OUTB pins are the same polarity as the PWMA andPWMB pins, respectively, and the OUTA and OUTB pinsare inverted from PWMA and PWMB, respectively. Thestep-up converter and both Piezo drivers have their ownshutdown control. Figure 2 shows a typical layout
上传时间： 2013-11-18
上传用户：hulee
Once relegated to the hinterlands of low cost indicatorlights, the LED is again in the spotlight of the lightingworld. LED lighting is now ubiquitous, from car headlightsto USB-powered lava lamps. Car headlights exemplifyapplications that capitalize on the LED’s clear advantages—unwavering high quality light output, tough-assteelrobustness, inherent high effi ciency—while a USBlava lamp exemplifi es applications where only LEDs work.Despite these clear advantages, their requirement forregulated voltage and current make LED driver circuitsmore complex than the venerable light bulb, but some newdevices are closing the gap. For instance, the LTM®8040μModule™ LED driver integrates all the driver circuitryinto a single package, allowing designers to refocus theirtime and effort on the details of lighting design criticalto a product’s success.
上传时间： 2013-10-16
上传用户：togetsomething
Abstract: This article discusses future trends in the design of smartphones and other consumer products. The discussion focuses onthe importance of integration, which saves valuable PCB space and drives down costs.
上传时间： 2014-01-13
上传用户：lhw888
介绍一款逆变器主要由MOS 场效应管，普通电源变压器构成。其输出功率取决于MOS 场效应管和电源变压器的功率，免除了烦琐的变压器绕制，适合电子爱好者业余制作中采用。
上传时间： 2013-10-13
上传用户：黑漆漆
电源电路是指车载功放的电源部分的设计，使用的电路形式和特点。对于一个功放来说，其电源部分非常重要，专业功放的电源电路的容量往往是根据放大器的实际消耗，再加足够的富裕量，因此比同样标称功率的普通功放的容量大得多，因此电源电路可以从一个侧面反映出整个功放的好坏。常见的电源电路有D级放大器电路、MOS
上传时间： 2014-01-14
上传用户：我叫李小进
