uninstall the device in the "Computer Management" pannel.在设备管理器中卸载已有驱动install PL2303-Prolific_DriverInstaller_v1200安装压缩包中的PL2303-Prolific_DriverInstaller_v1200restart your computer.重启计算机
上传时间： 2022-03-13
上传用户：jiabin
M.NT68676.2A is a monitor control board, which is suitable for Asia-Pacific market. It can supportLED/LCD panels which resolution is up to 2048×1152.M.NT68676.2A can synchronize with computer automatically. Synchronization requires thesynchronous signal which horizontal and vertical sync are separated.M.NT68676.2A can support dynamic contrast control, headphone input and Digital volume controlsimultaneously.
标签： 乐华驱动板
上传时间： 2022-03-13
上传用户：kent
本系统采用电动机电枢供电回路串接采样电阻的方式来实现对小型直流有刷电动机的转速测量。该系统主要由二阶低通滤波电路,小信号放大电路、单片机测量显示电路、开关稳压电源电路等组成。同时自制电机测速装置,用高频磁环作为载体,用线圈绕制磁环,利用电磁感应原理检测电机运行时的漏磁,将变化的磁场信号转化为磁环上的感应电流。用信号处理单元电路将微弱电信号转化为脉冲信号,送由单片机检测,从而达到准确测量电机的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
标签： 直流电动机
上传时间： 2022-03-26
上传用户：
以仓库智能改造为背景,主要介绍单片机和上位机之间通信网络和通信协议的选择,MODBUS协议通信指令和功能码使用,重点阐述了基于RS-485总线的MODBUS通信协议在上位机和单片机之间的串行通信,实现上位机对单片机设备的远程控制和信息采集的功能。Based on the intelligent warehouse transformation as the background,mainly introduces between MCU and PC communication network and the choice of communication protocol,instruction and the function code using the MODBUS protocol communication,expounds the MODBUS communication protocol based on RS-485 bus serial communication between PC and single chip microcomputer,PC remote control of single chip computer equipment and the function of information collection.
上传时间： 2022-03-26
上传用户：
以AT89S52单片机为控制核心,采用电容降压技术,Buck电路拓扑,PWM驱动模块和功率器件散热设计,通过高速的数据采集、主功率输入输出模块和控制模块,设计一种新型智能车载充电器.在充电过程中,通过负脉冲瞬间放电实现对铅酸蓄电池的再生修复,提高电池的有效容量,延长使用寿命.该充电器体积小、速度快、效率高、可靠性好.With AT89S52 single chip computer as the control core,a new type of intelligent car-carried charger was designed by using capacitance step-down technology,Buck circuit topology,PWM driving module and power device heat dissipation design,through high-speed data acquisition,main power input and output module and control module.In the charging process,the regeneration and repair of lead-acid batteries are realized by instantaneous discharge of negative pulse,which improves the effective capacity of batteries and prolongs their service life.The charger has the advantages of small size,fast speed,high efficiency and good reliability.
标签： 车载充电器
上传时间： 2022-03-27
上传用户：
静电放电（Electrostatic Discharge，ESD）是构成集成电路可靠性的主要因素之一，存在于生产到使用的每一个环节，并成为开发新一代工艺技术的难点之一，近年来，对ESD的研究也因而越来越受到重视，仿真工具在ESD领域的应用使得ESD防护的研究变得更为便利，可大幅缩短研发周期然而，由于ESD现象复杂的物理机制，极端的电场及温度条件，以及ESD仿真中频繁的不收敛现象，都使得FSD的仿真变得极为困难本文详细阐述了ESD的来源、造成的危害以及如何测试集成电路的防静电冲击能力，并基于 Sentaurus软件，对ESD防护器件展开了的分析、研究，内容包括1）掌握ESD保护的基本理论、测试方法和防护机理2）研究了工艺仿真流程的步骤以及网格定义在工艺仿真中的重要性，并对网格定义的方法进行了探讨3）硏究了器件仿真流程以及器件仿真中的物理模型和模型函数，并对描述同一物理机制的的各种不同模型展开对比分析.主要包括传输方程模型、能帶模型、各种迁移率退化模型、雪崩离化模型和复合模型4）研究了双极型晶体管和可控硅（Silicon Controlled rectifier，SCR）防护器件的仿真，并通过对仿真结果的分析，研究了ESD保护器件在ESD应力作用下的工作机理关键词：静电放电；网格；器件仿真；双极型晶体管；可控硅
上传时间： 2022-03-30
上传用户：
在传统智能小车驱动电路设计中,较多考虑使用直流电机还是步进电机,电机功率、能耗等性能参数。使用具有armCortexM4内核的STM32嵌入式平台控制四轮的4个直流电机。文章基于PWM技术及PID算法,对四轮进行精准地速度、转向及启停控制,实验表明此小车具有优越各种地形适应能力。In the traditional intelligent car drive circuit design,DC motor or stepping motor,motor power,energy consumption and other performance parameters are considered.The four DC motors with four wheels are controlled by STM32 embedded platform with arm Cortex M4 kernel.Based on the PWM technology and PID algorithm,the accurate ground speed,steering,and start-stop control of the four wheels are carried out.The experiment shows that the vehicle has the superior adaptability to all kinds of terrains.
上传时间： 2022-04-02
上传用户：
以单片机控制A/D转换器TLC549为例,对A/D转换器的主要技术指标进行了分析研究,在Proteus平台下,完成了A/D转换电路的构建,采用器件工作时序方式进行程序编写,借助仿真图表、虚拟仪器等工具对A/D转换的数据进行测量并对失调误差、增益误差、微分非线性、积分非线性和转换时间等重要参数进行了详细分析。结果表明:使用Proteus软件可对A/D转换过程进行定性分析,将抽象的A/D转换器技术指标直观化、形象化展现出来,有助于学生更好地理解A/D转换过程。The main technical indicators of A/D converter were analyzed and studied with an example from A/D converter TLC2543 which is controlled by using SCM.It was completed the construction of the A/D converter circuit under the Proteus software.The programming based on the operation sequence of the chip is put forward.With the aid of the simulation tools such as virtual instrument,simulation charts provided by Proteus,the important parameters of circuit such as offset error,gain error,differential nonlinearity(DNL),integral nonlinearity (INL) and conversion time are analyzed detailedly.Simulation results show that the A/D conversion process can be qualitatively analyzed and visualized the abstract indicators of A/D.The system can help students better to understand the SCM conversion process.
上传时间： 2022-04-04
上传用户：
为解决移相全桥电路驱动及相角控制问题,设计了一种数字控制的移相全桥驱动电路.以TPL521为光耦隔离、IR2110为栅极驱动芯片.由DSP产生PWM信号,经过光耦隔离和逻辑电路后送至IR2110进行相角控制.文章对IR2110驱动电路原理进行分析及参数进行设计,对TMS320F28335进行设置并给出部分代码.实验结果表明：通过TMS320F28335可产生的不同相角的PWM波形,满足了移相全桥对不同相角控制的要求.In order to solve the problem of phase-shifted full-bridge circuit driving and phase angle control,a digitally controlled phaseshifted full-bridge driving circuit was designed. TPL521 optocoupler isolation,IR2110 gate driver chip. PWM signals are generated by the DSP and sent to the IR2110 for phase angle control after optocoupler isolation and logic circuits. This text carries on the analysis to the principle of IR2110 drive circuit and parameter design,set up and give out some code to TMS320F28335. The experimental results show that the PWM waveforms with different phase angles generated by TMS320F28335 can meet the requirements of phase-shifted full-bridge control for different phase angles.
上传时间： 2022-05-03
上传用户：zhanglei193
Algebra, Topology, Differential Calculus, and Optimization Theory For Computer Science and Machine Learning一本数学大全书，由Jean Gallier and Jocelyn Quaintance合著。
上传时间： 2022-05-05
上传用户：默默
