UART to USB Bridge CKT.
上传时间： 2013-12-22
上传用户：yd19890720
This is a PCI to USB bridge schematic that i was draw by hand from a PCI to USB card, the schematic use VT6212L to make bridge, the idear is that we can use microcontroler interface to PC through PCI slot by USB, ha ha it is too easy.
上传时间： 2017-04-12
上传用户：13188549192
Bridge PNE 3.3 source code, running at more than vxworks6.x version.
标签： running vxworks version Bridge
上传时间： 2017-05-14
上传用户：youke111
control step motor (use for CNC machine), use chip dspic30f4011, include interpolation
标签： interpolation use control machine
上传时间： 2017-05-27
上传用户：R50974
Wishbone to LPC (Low-Pin Count) Bridge, includes master and slave modules. Supports 8-bit I/O Read and Write cycles, 8-bit Memory Read/Write cycles, DMA cycles, and up to 32-bit Firmware memory read/write cycles. Serial IRQ support is also provided. None of this has been tested (yet) with a third-party LPC Peripheral or Host.
标签： Wishbone Supports includes Low-Pin
上传时间： 2014-12-20
上传用户：古谷仁美
This is is a bridge IP core to interface the Tensilica PIF bus protocol with the OpenCores WishBone. It currently supports single-cycle as well as burst transfer operations. The core has been tested in a master-PIF slave-WB configuration.
标签： Tensilica OpenCores interface the
上传时间： 2013-12-21
上传用户：gonuiln
Cypress公司开发的2.4G无线键盘鼠标及其Bridge源代码，对于开发无线鼠标键盘的人来说是很好的参考例子！
上传时间： 2017-07-18
上传用户：thuyenvinh
老外用VB写的CNC仿真程序源码，可以载入G Code，还有OpenGL的3D图
上传时间： 2017-07-22
上传用户：爱死爱死
NS-CNC步进电机驱动器.................
上传时间： 2017-08-06
上传用户：jiahao131
userial is an Free project building an USB to I2C/SPI/GPIO bridge, using the Atmel AT90USB647 chip. Hardware and Software are released under an Open Source licence. It supports the following interfaces: * USB interface (serial emulation) * JTAG * I2C (TWI) * SPI * 8 General purpose digital I/O * 4 Analog to Digital converters (currently no firmware support)
标签： USB building userial project
上传时间： 2013-12-25
上传用户：小鹏
