摘 要:用一种新的思路和方法,先计算低通、再计算高通滤波器的有关参数,然后组合成带通滤波器.关键词:滤波器;参数;新思路中图分类号: TN713. 5 文献识别码:B 文章编号:1008 - 1666 (1999) 04 - 0089 - 03A New Consideration of the Band Filter’s CalculationGuo Wencheng( S hao Yang B usiness and Technology school , S haoyang , Hunan ,422000 )Abstract :This essay deals with a new method of calculating the band filters - first calculatingthe relevant parameters of low - pass filters ,then calculating the ones of high - pass filters.Key words :filter ; parameters ;new considercation八十年代后,信息产业得到了迅猛发展. 带通滤波器在微波通信、广播电视和精密仪器设备中得到了广泛应用. 带通滤波器性能的优劣,对提高接收机信噪比,防止邻近信道干扰,提高设备的技术指标,有着十分重要的意义.我在长期的教学实践中,用切比雪夫型方法设计、计算出宽带滤波器集中参数元件的数据. 该滤波器可运用在检测微波频率的仪器和其他设备中. 再将其思路和计算方法介绍给大家,供参考.
上传时间： 2014-12-28
上传用户：Yukiseop
The NCV7356 is a physical layer device for a single wire data linkcapable of operating with various Carrier Sense Multiple Accesswith Collision Resolution (CSMA/CR) protocols such as the BoschController Area Network (CAN) version 2.0. This serial data linknetwork is intended for use in applications where high data rate is notrequired and a lower data rate can achieve cost reductions in both thephysical media components and in the microprocessor and/ordedicated logic devices which use the network.The network shall be able to operate in either the normal data ratemode or a high-speed data download mode for assembly line andservice data transfer operations. The high-speed mode is onlyintended to be operational when the bus is attached to an off-boardservice node. This node shall provide temporary bus electrical loadswhich facilitate higher speed operation. Such temporary loads shouldbe removed when not performing download operations.The bit rate for normal communications is typically 33 kbit/s, forhigh-speed transmissions like described above a typical bit rate of83 kbit/s is recommended. The NCV7356 features undervoltagelockout, timeout for faulty blocked input signals, output blankingtime in case of bus ringing and a very low sleep mode current.
上传时间： 2013-10-24
上传用户：s蓝莓汁
The NXP LPC314x combine a 270 MHz ARM926EJ-S CPU core, High-speed USB 2.0OTG, 192 KB SRAM, NAND flash controller, flexible external bus interface, three channel10-bit A/D, and a myriad of serial and parallel interfaces in a single chip targeted atconsumer, industrial, medical, and communication markets. To optimize system powerconsumption, the LPC314x have multiple power domains and a very flexible ClockGeneration Unit (CGU) that provides dynamic clock gating and scaling.
上传时间： 2013-10-11
上传用户：yuchunhai1990
The NXP LPC315x combine an 180 MHz ARM926EJ-S CPU core, High-speed USB 2.0OTG, 192 KB SRAM, NAND flash controller, flexible external bus interface, an integratedaudio codec, Li-ion charger, Real-Time Clock (RTC), and a myriad of serial and parallelinterfaces in a single chip targeted at consumer, industrial, medical, and communicationmarkets. To optimize system power consumption, the LPC315x have multiple powerdomains and a very flexible Clock Generation Unit (CGU) that provides dynamic clockgating and scaling.The LPC315x is implemented as multi-chip module with two side-by-side dies, one fordigital fuctions and one for analog functions, which include a Power Supply Unit (PSU),audio codec, RTC, and Li-ion battery charger.
上传时间： 2014-01-17
上传用户：Altman
Rotating shafts experience a an elliptical motion called whirl. It is important to decompose this motion into a forward and backward whil orbits. The current function makes use of two sensors to generate a bi-directional spectrogram. The method can be extended to any time-frequency distribution ％ ％ compute the forward/backward Campbell/specgtrogram ％ ％ INPUT: ％ y (n x 2) each column is measured from a different sensor ％ /////// ％ __ ％ |s1| y(:,1) ％ |__| ％ __ ％ / \ ________|/ ％ | | | s2 |/ y(:,2) ％ \____/ --------|/ ％ ％ Fs Sampling frequnecy ％ ％ OUTPUT: ％ B spectrogram/Campbel diagram ％ x x-axis coordinate vector (time or Speed) ％ y y-axis coordinate vector (frequency [Hz])
标签： experience elliptical decompose important
上传时间： 2015-06-23
上传用户：372825274
LibTorrent is a BitTorrent library written in C++ for *nix, with a focus on high performance and good code. The library differentiates itself from other implementations by transfering directly from file pages to the network stack. On high-bandwidth connections it is able to seed at 3 times the speed of the official client. The client uses ncurses and is ideal for use with screen or dtach. It supports saving of sessions and allows the user to add and remove torrents.
标签： performance LibTorrent BitTorrent library
上传时间： 2015-07-24
上传用户：冇尾飞铊
通过MP（代表其中一个P口）的高4位来控制，AA`BB`-4，5，6，7脚。12细分，没行数组里面分4对，每对数第一个加到P口控制电流方向，第二个数控制通电时间。正转AA`-BB`-A`A-B`B,数组由1到12行的读取，反转B`B-A`A-BB`-AA`,数组由12到1行的读取。参数POWER表示电机启动还是不启动，DIRECT参数表示方向，SPEED表示速度等级，每项通电时间用数组中的植/SPEED。本程序没考虑要走多少步的情况，调用一次就走一步。
标签： 控制
上传时间： 2015-12-07
上传用户：hopy
16 relay output channels and 16 isolated digital input channels LED indicators to show activated relays Jumper selectable Form A/Form B-type relay output channel Output status read-back Keep relay output values when hot system reset High-voltage isolation on input channels(2,500 VDC) Hi ESD protection(2,00VDC) High over-voltage protection(70VDC) Wide input range(10~50VDC) Interrupt handling capability High-density DB-62 connector Board ID
标签： channels indicators activated isolated
上传时间： 2016-02-15
上传用户：dongbaobao
Fraqtive is a program for drawing Mandelbrot and Julia fractals. It uses a very fast algorithm and generates high quality, smooth images.
标签： Mandelbrot and algorithm Fraqtive
上传时间： 2016-04-12
上传用户：独孤求源
主要介绍了如何使用E8仿真器在以Renesas芯片为MCU的开发板上进行仿真调试。 第1 章 概要 第2 章 E8 仿真器功能 第3 章 使用前的准备 第4 章 调试的准备 第5 章 调试 第6 章 教程示例 附录A E8 仿真器的构成 附录B 窗口功能一览 附录C 命令行功能 附录D High-performance Embedded Workshop 的注意事项 附录E 有关硬件诊断程序 E.1 为了执行诊断程序的系统设置 E.2 诊断程序的执行 E.3 错误发生时的处理
上传时间： 2013-12-26
上传用户：chens000
