虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

STANDARD-ISOIEC

  • PW2601_2.0.pdf规格书下载

    The PW2601 is a charger front-end integrated circuit designed to provide protection to Li-ionbatteries from failures of charging circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree

    标签: pw2601

    上传时间: 2022-02-11

    上传用户:

  • PW2162_2.0.pdf规格书下载

    The PW2162 is a fully integrated, high– efficiency 2A synchronous rectified step-down converter.The PW2162 operates at high efficiency over a wide output current load range. This device offerstwo operation modes, PWM control and PFM Mode switching control, which allows a high efficiencyover the wider range of the load. The PW2162 requires a minimum number of readily availablestandard external components and is available in an 6-pin SOT23 ROHS compliant package.

    标签: pw2162

    上传时间: 2022-02-11

    上传用户:d1997wayne

  • 高清电子书-C++ Primer Plus 第6版英文版 1438页

    高清电子书-C++ Primer Plus, 第6版英文版 1438页Learning C++ is an adventure of discovery, particularly because the language accommodates several programming paradigms, including object-oriented programming, generic programming, and the traditional procedural programming.The fifth edition of this book described the language as set forth in the ISO C++ standards, informally known as C++99 and C++03, or, sometimes as C++99/03. (The 2003 version was largely a technical correction to the 1999 standard and didn’t add any new features.) Since then, C++ continues to evolve.As this book is written, the international C++ Standards Committee has just approved a new version of the standard.This standard had the informal name of C++0x while in development, and now it will be known as C++11. Most contemporary compilers support C++99/03 quite well, and most of the examples in this book comply with that standard. But many features of the new standard already have appeared in some implementations, and this edition of C++ Primer Plus explores these new features. C++ Primer Plus discusses the basic C language and presents C++ features, making this book self-contained. It presents C++ fundamentals and illustrates them with short, to-the-point programs that are easy to copy and experiment with.You learn about input/output (I/O), how to make programs perform repetitive tasks and make choices, the many ways to handle data, and how to use functions.You learn about the many features C++ has added to C, including the followi

    标签: C++

    上传时间: 2022-02-19

    上传用户:trh505

  • S32K1xx Series Reference Manual 用户手册--2029页

    S32K1xx Series Reference Manual 用户手册--2029页 Supports S32K116, S32K118, S32K142, S32K144, S32K146, and S32K148S32K是一款符合AEC-Q100规范、基于32位ARM Cortex-M4F和Cortex-M0+内核的MCU,适用于通用汽车和高可靠性工业应用。The S32K1xx product series further extends the highly scalable portfolio of Arm® Cortex®-M0+/M4F MCUs in the automotive industry. It builds on the legacy of the KEA series, while introducing higher memory options alongside a richer peripheral set extending capability into a variety of automotive applications. With a 2.70–5.5 V supply and focus on automotive environment robustness, the S32K product series devices are well suited to a wide range of applications in electrically harsh environments, and are optimized for cost-sensitive applications offering low pin-count options. The S32K product series offers a broad range of memory, peripherals, and package options. It shares common peripherals and pin counts, allowing developers to migrate easily within an MCU family or among the MCU families to take advantage of more memory or feature integration. This scalability allows developers to use the S32K product series as the standard for their end product platforms, maximizing hardware and software reuse and reducing time to market

    标签: S32K116 S32K118 S32K142 S32K144

    上传时间: 2022-04-16

    上传用户:jason_vip1

  • 915MHz超高频RFID阅读器射频前端电路设计

    为了提高超高频RFID系统中阅读器在低信噪比的情况下仍具有较高的识别能力,提出一种基于FPGA系统结合软件无线电方法实现超高频RFID射频前端电路方案。超高频射频识别系统必须符合EPC Class 1generation 2标准,所设计的电路系统以Xilinx公司的XC6SLX16-2CSG324FPGA芯片为硬件基础,将数字基带调制解调和中频滤波电路在FPGA系统中设计实现,重点阐述了射频前端电路的设计结构、AD/DA转换电路,以及数字滤波器的设计。实验结果表明,所设计的超高频RFID阅读器简化了前端电路系统结构,提升了稳定性,增强了抗干扰能力。该电路系统在信噪比较低的情况下,能够较好地实现915MHz频率的射频接收和发送。In order to improve the reader UHF RFID system still has a higher ability to identify,in the case of low signal-to-noise ratio.The UHF RFID systems must comply with EPC Class 1 generation 2 standard.In this paper,the design of the circuit system based on Xilinx's XC6SLX16-2CSG324 FPGA chip,and presents UHF RFID RF front-end circuit with software radio based on FPGA system.Digital baseband modem and IF filter circuit is designed and implemented in the FPGA system,and focused on designing the structure of the RF front-end circuit,AD/DA conversion circuits,and digital filter.Experimental results show that the UHF RFID reader de...

    标签: 915mhz 超高频 rfid 阅读 射频 前端 电路 设计

    上传时间: 2022-04-17

    上传用户:shjgzh

  • IEC 61000-4-2-2018

    INTERNATIONAL STANDARD NORME INTERNATIONALEPart 4-2: Testing and measurement techniques – Electrostatic discharge immunity test.About the IEC The International Electrotechnical Commission (IEC) is the leading global organization that prepares and publishes International Standards for all electrical, electronic and related technologies.About IEC publications The technical content of IEC publications is kept under constant review by the IEC. Please make sure that you have the latest edition, a corrigenda or an amendment might have been published.

    标签: IEC

    上传时间: 2022-04-19

    上传用户:fliang

  • 基于Multisim的高精度数字频率计的设计和仿真

    数字频率计是电工电子中常用的测量仪器,数字频率计通过用输入待测信号对一特定长度的信号进行计数,从而得出频率并通过数码管直观的显示出来。本文提出了一种与输入同步的数字频率计的设计,提高了频率计的精度,设计采用Multisim软件进行设计和仿真的过程,介绍了其工作原理,硬件电路设计和仿真的过程。设计采用了Multisim软件进行设计和仿真,设计结果得到的验证。Digital frequency counter is used to measure the frequency of a signal.It is common to use a multivibrator to generate a standard 1 second time base signal and count input signal gated by this signal.However,the asynchronous of this time base signal with input signal will bring errors.In this paper,a high precision frequency counter which use synchronized time base signal generator is proposed.This frequency counter is designed and simulated by Multisim tools and result is verified.

    标签: multisim

    上传时间: 2022-05-08

    上传用户:

  • vpx规范 American National Standard for VPX Baseline Standard

    vpx基本规范,ANSI/VITA 46.0-2007 (R2013) 。

    标签: vpx规范

    上传时间: 2022-06-16

    上传用户:

  • 音响功放测试方法

    說明:1,测试交流电源(Test AC Power Supply):A.中国(China):AC 220V+/-2%50Hz+/-2%B.美国(United States of America):AC 120V+/-2%60Hz+/-2%。C.英国(Britain):AC 240V+/-2%50Hz+/-2%D.欧洲(Europe):AC 230V+/-2%50Hz+/-2%E.日本(Japan):AC 100V+/-2%60Hz+/-2%F.墨西哥(Mexico):AC 127V+/-2%60Hz+/-2%2,测试温度条件(Test Temperature Conditions):25℃+/-2℃。3,测试以右声道为准(Standard Test Use Right Channell)4,信号由AUX插座输入(Signal From AUX Jack Input)。5,测试以音量最大,音调和平衡在中央位置(电子音调在正常状态)。(Test Volume Setup Max,Equalizer And Balance Setup Center)。6,标准輸出(Standard Output):A.输入1 KHz频率信号(Input 1 KHz Frequency Signal)B.左右声道输入信号测试右声道(L&R Input Signal Test Use R Channel)C.额定输出功率満(Rating Output Power Full)10 W,标准输出定为1w.(Rating Output Power Full 10 w,Standard Output Setup 1 W)D.额定输出功率1W到10w,标准输出定为500 mW(Rating Output Power 1 W To 10 W,Standard Output Setup 500 mW)E.额定输出功率小于1w,标准输出定为50 mW(Rating Output Power Not Full 1 W,Standard Output Setup 50 mW)F.标准輸出电压以V-VPR为准(Standard Output Voltage Use V-V/PR)。G.V-V/PR中P为额定输出功率,R为喇叭标称阻抗。

    标签: 音响功放

    上传时间: 2022-06-18

    上传用户:

  • 基于AES算法的数据加密与解密硬件设计

    21世纪是信息快速发展的时代,随着计算机网络的应用越来越广泛,网络安全也逐渐成为人们普遍关注的课题。可以预言,今后的社会将进入全面的网络时代和信息共享时代,因此,网络安全极其重要,只有安全的网络才能保证网络生活能够有序进行、网络系统不遭破坏、信息不被窃取、网络服务不被非法中断等。为了保证计算机网络的可靠性、可用性、完整性、保密性和真实性等安全性,不仅要保证计算机网络设备安全和计算机网络系统安全,还要保护数据的安全。对数据实施安全的加密算法是保护数据安全的有效手段。AES(advanced encryption standard)是美国国家标准和技术研究所宣布采用的高级加密标准,可以预测,AES在今后很长的一段时间内将会在信息安全中扮演重要的角色,因此对AES算法实现的研究成为国内外的热点,它将会在信息安全领域得到广泛的应用。AES在实现方面具有速度快、可并行处理、对处理器的结构无特殊要求,算法设计相对简单,分组长度可以改变,而且具有很好的可扩充性。AES算法的这些特点使得选用FPGA来实现AES算法具有很好的优越性,本文就是针对AES算法的FPGA实现进行研究。本文介绍了用FPGA实现AES算法所用的开发工具、开发语言和所选用的芯片,还具体介绍了AES算法的硬件实现方式,在此基础上,着重阐述了AES算法FPGA实现的总体设计框图,并对各个部分的设计分别给与介绍,给出了实现加密解密的时序仿真和设计结果。

    标签: AES算法 数据加密

    上传时间: 2022-06-18

    上传用户:shjgzh