The PCA9548A is an octal bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to eight downstream pairs, or channels. Any individualSCx/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.An active LOW reset input allows the PCA9548A to recover from a situation where one ofthe downstream I2C-buses is stuck in a LOW state. Pulling the RESET pin LOW resets theI2C-bus state machine and causes all the channels to be deselected as does the internalPower-on reset function.
上传时间： 2013-10-13
上传用户：bakdesec
Luminary Micro Stellaris™ microcontrollers that are equipped with an analog-to-digital converter(ADC), use an innovative sequence-based sampling architecture designed to be extremely flexible,yet easy to use. This application note describes the sampling architecture of the ADC. Sinceprogrammers can configure Stellaris microcontrollers either through the powerful StellarisFamilyDriver Library or through direct writes to the device's control registers, this application note describesboth methods. The information presented in this document is intended to complement the ADCchapter of the device datasheet, and assumes the reader has a basic understanding of howADCsfunction.
标签： Microcontr Stellaris Using the
上传时间： 2013-10-14
上传用户：blans
The Philips family of Multiplexers and Switches consists of bi-directional translating switches controlled via the I2C or SMBus to fan out an upstream SCL/SDA pair to 2, 4 or 8 downstream channels of SCx/SDx pairs. The Multiplexers allow only one downstream channel to be selected at a time, while the Switches allow any individual downstream channel or combination of downstream channels to be selected, depending on the content of the programmable control register. Once one or several channels have been selected, the device acts as a wire, allowing the master on the upstream channel to send commands to devices on all the active downstream channels, and devices on the active downstream channels to communicate with each other and the master. External pull-up resistors are used to pull each individual channel up to the desired voltage level. Combined interrupt output and hardware reset input are device options that are featured.
上传时间： 2013-10-11
上传用户：dianxin61
8051单片机系统扩展与接口技术:第一节 8051 单片机系统扩展概述第二节 单片机外部存储器扩展第三节 单片机输入输出（I/O）口扩展及应用第四节 LED显示器接口电路及显示程序第五节 单片机键盘接口技术第六节 单片机与数模（D／A）及模数（A／D）转换1、地址总线（Address Bus，简写为AB）地址总线可传送单片机送出的地址信号，用于访问外部存储器单元或I/O端口。A 地址总线是单向的，地址信号只是由单片机向外发出。B 地址总线的数目决定了可直接访问的存储器单元的数目。例如N位地址，可以产生2N个连续地址编码，因此可访问2N个存储单元，即通常所说的寻址范围为 2N个地址单元。MCS—51单片机有十六位地址线，因此存储器展范围可达216 = 64KB地址单元。C 挂在总线上的器件，只有地址被选中的单元才能与CPU交换数据，其余的都暂时不能操作，否则会引起数据冲突。2、数据总线（Data Bus，简写为DB）数据总线用于在单片机与存储器之间或单片机与I/O端口之间传送数据。A 单片机系统数据总线的位数与单片机处理数据的字长一致。例如MCS—51单片机是8位字长，所以数据总线的位数也是8位。B 数据总线是双向的，即可以进行两个方向的数据传送。3、控制总线（Control Bus，简写为CB）控制总线实际上就是一组控制信号线，包括单片机发出的，以及从其它部件送给单片机的各种控制或联络信号。对于一条控制信号线来说，其传送方向是单向的，但是由不同方向的控制信号线组合的控制总线则表示为双向的。总线结构形式大大减少了单片机系统中连接线的数目，提高了系统的可靠性，增加了系统的灵活性。此外，总线结构也使扩展易于实现，各功能部件只要符合总线规范，就可以很方便地接入系统，实现单片机扩展。
上传时间： 2013-10-18
上传用户：assef
基于PIC单片机的脉冲电源:设计了一种金属凝固过程用脉冲电源。该电源采用PIC16F877作为主控芯片，实现对窄脉冲电流幅值的检测，以及时电流脉冲幅值根据模糊PID算法进行闲环控制。使用结果表明：该电源的输出脉冲波形良好，电流幅值稳定，满足合金材料凝固过程的工艺要求且运行稳定可靠。关键词：脉冲电源；PIC16F877单片机；模糊PID；闲环控制 Abstract：A kind of pulse power supply was designed which uses in the metal solidification process ．．I11is power supply used PIC16F877 to take the master control chip reali on to the narrow pulse electric current peak-to-peak value examination，carried on the closed-loop control to the electric current pulse peak-to-peak value basis fuzzy PID algorithm．The use result indicated ，this power supply output se profile is good，and the electric current peak-to-p~k value is stable，It satisfies the alloy material solidification process the technological requirement and movement stable reliable，Key words：p se po wer supply；PIC16F877single-chip microcontroller；f r PID；closed-loop control
上传时间： 2013-10-27
上传用户：xcy122677
基于单DSP的VoIP模拟电话适配器研究与实现:提出和实现了一种新颖的基于单个通用数字信号处理器(DSP)的VoIP模拟电话适配器方案。DSP的I/O和存储资源非常有限，通常适于运算密集型应用，不适宜控制密集型应用[5]。该系统高效利用单DSP的I/O和片内外存储器资源，采用μC/OS-II嵌入式实时操作系统，支持SIP和TCP-UDP/IP协议，通过LAN或者宽带接入，使普通电话机成为Internet终端，实现IP电话。该系统软硬件结构紧凑高效，运行稳定，成本低，具有广阔的应用前景。关键词：模拟电话适配器；IP电话；数字信号处理器；μC/OS-II 【Abstract】This paper presents a VoIP ATA solution based on a single digital signal processor (DSP). DSPs are suitable for arithmetic-intensiveapplication and unsuitable for control-intensive application because of the limitation of I/O and memory resources. This solution is based on a 16-bitfixed-point DSP and μC/OS-II embedded real-time operating system. It makes good use of the limited resources, supports SIP and TCP-UDP/IPprotocol. It can connect the analog telephone to Internet and realize the VoIP application. This system has a great future for its high efficiency andlow cost.【Key words】Analog telephone adapter (ATA); Voice over Internet protocol (VoIP); Digital signal processor (DSP); μC/OS-II Research and Implementation of VoIPATA Based on Single DSP
上传时间： 2013-11-20
上传用户：Wwill
基于单片机的步进电机开环控制系统:通过ATMEL89C51单片机对步进电机进行控制,主要介绍了步进电机控制器、驱动电路和LED显示电路的设计,实现了步进电机的开环控制。在步进电机控制器的设计中,重点阐述了脉冲产生电路以及对速度的控制。该系统具有成本低、控制方便的特点。关键词: 单片机; 步进电机; 开环控制 Abstract: The design using ATMEL89C51 single chip to control the step2motor with its controller, driving circuit and LED disp lay circuit to realize step motor open2loop controlwere introduced. For the controller in this design,the circuit to p roduce pulse and the speed controlwere expatiated emphatically. This system possesses features of lower cost, easier control.Key words: single ch ip; step2motor; open2loop con trol
上传时间： 2013-10-13
上传用户：cicizoe
本文简单介绍了MCGS 组态软件和SPCE061A 单片机的特点，即北京昆仑通态自动化软件科技有限公司的工控组态软件MCGS(Monitor and Control Generated System )和台湾凌阳科技推出的16 位微控制器SPCE061A，重点介绍了如何一步步开发SPCE061A 单片机的驱动程序，并简单介绍了下位机程序的设计，最后给出了测试情况。计算机技术的飞速发展为工业自动化开辟了广阔的发展空间，人们可以快捷地开发和组建高效的控制系统。笔者设计的液体点滴监控模型,可以对液体点滴情况实现远程监控和现场监控，终端和上位机均可人工设定所需的液体点滴速度并动态显示。在这方面，MCGS 工控组态软件提供了强有力的支持，它是一套Windows 环境下快速构造和生成上位机监控系统的组态软件系统，可快速构造和生成数据采集、报警处理、流程控制、动画显示、报表输出等界面,实现各种工程曲线的绘制、报表输出、远程通信等功能 [1]。MCGS 作为一种方便有效的通用工控软件,它提供了国内外各种常用的工控设备的驱动程序。但在实际应用中,因为所用设备的特殊性,允许用户根据需要来定制设备驱动程序。MCGS 用Active DLL 构件实现设备驱动程序,通过规范的OLE 接口挂接到MCGS 中,使其构成一个整体。鉴于Visual Basic 语言的通用性和简单性,使用VB 来开发单片机驱动,MCGS 的实现方法和原理与标准的Active DLL 完全一致,但MCGS 规定了一套接口规范,只有遵守这些接口规范的Active DLL 才能用作MCGS 的设备驱动构件。利用具有语音和 DSP 功能的SPCE061A 单片机作为液体点滴监控模型的核心控制器，SPCE061A 是台湾凌阳科技推出的16 位微控制器，提供了丰富的软、硬件资源，开发灵活方便。除此之外SPCE061A 的最高时钟频率可达到49MHz,具有运算速度高的优势，这为语音的录制和播放提供了条件[4]。
上传时间： 2013-12-19
上传用户：leesuper
摘要：本水位监测报警器使用5V低压直流电源（也可以用3节5号电池代替）就可以对5~15厘米的水位进行监测，用LED显示和数码管显示水位，并可以对不再此范围内的水位发出报警。主要采用CD4066、74LS86、74LS32、CD4511芯片，再加上数码管、蜂鸣器、发光二极管、电阻这些器件组成一个简单而灵敏的监测报警电路，操作简单，接通电源即可工作。因为大部分电路采用数字电路，所以本水位监测报警器还具有耗能低、准确性高的特点。关键字：译码电路 报警电路 监测电路 Abstract: The water level alarm monitoring the use of 5 V low-voltage DC power (can also use three batteries replaced on the 5th) will be able to 5 to 15 centimeters of water level monitoring, with LED display and digital display of water level, and this can no longer Within the scope of a water level alarm. Mainly CD4066, 74LS86, 74LS32, CD4511 chips, coupled with digital control, buzzer, light-emitting diode, the resistance of these devices composed of a simple and sensitive monitoring alarm circuits. Because the majority of circuits using digital circuitry, so the water level monitored alarm system also has low energy consumption, high accuracy of the characteristics. Keyword: Decoding circuit alarm circuit monitoring circuit
上传时间： 2013-11-05
上传用户：王庆才
一种实用的微机自动配料秤系统:介绍一种由单片机构成的配料秤。叙述了秤的传感器、变送器、信号的变换、硬件原理、软件流程以及和DCS 系统构成的单回路调节系统,此系统可广泛地应用于各行业的配料控制中。关键词:配料秤 单片机 单回路调节系统 DCS 系统 Abstract :A proportioning weigher based on single chip computer is introduced. Sensors , transmitters , signal converting , principle of hardware ,software flowchart of proportioning weigher and single loop control system composed with DCS system are emphasized ,this system can be used in proportioning control of various trades extensively.Key Words :Proportioning Weigher ,Single Chip Computer ,Single Loop Control System ,Distributed Control System
上传时间： 2013-10-12
上传用户：zwei41
