虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

传输链路

  • 8路遥控抢答器

    8路遥控抢答器

    标签: 8路 遥控 抢答器

    上传时间: 2013-11-17

    上传用户:sunjet

  • 基于GSM无线传输的远程抄表终端设计论文

    基于GSM无线传输的远程抄表终端设计论文

    标签: GSM 无线传输 远程抄表 终端设计

    上传时间: 2013-10-21

    上传用户:JIEWENYU

  • 基于DMA控制器的UART串行通信设计

    针对大数据量的串口间通信,在常规的UART串行数据通信的基础上,结合Cortex-M3微控制器中DMA控制器的作用,实现DMA控制的UART串口数据包收发。设计链表项缓存,最终实现DMA的分散/聚集模式的数据传输过程,主要是发送过程。提高了串行数据通信过程的MCU独立性和MCU利用的效率。

    标签: UART DMA 控制器 串行

    上传时间: 2013-11-04

    上传用户:gaome

  • 袖珍型电子日历及8路长时间定时控制器程序

    袖珍型电子日历及8路长时间定时控制器程序

    标签: 电子日历 8路 定时控制器 程序

    上传时间: 2013-10-29

    上传用户:agent

  • 四路抢答器的设计和制作

    四路抢答器的设计和制作,抢答用的

    标签: 四路抢答器

    上传时间: 2013-11-02

    上传用户:ouyangmark

  • 通用1553B总线的信息监控系统

    在航电系统维护过程中,为解决定位故障的效率和降低维修成本等问题,提出了基于ICD(Interface Control Document,接口控制文件)的1553B总线的信息监控系统模型。该系统运用数据采集卡对总线中传输的信号有无失真、偏差等电气特性进行检测,并使用1553B通讯卡通过测控软件LabWindows/CVI编程与ICD数据库的动态链接,实现总线信息的解析和故障的判断。与传统的维护过程相比,这种模型能够从信号的电气特性以及信息的解析等全方位的去检测判断故障的来源,并且能够广泛在其他1553B总线系统内扩展应用。验证表明该监控系统可以对总线信息进行快速有效地监测分析,能满足应用需求。 Abstract:  In the process of avionics system maintenance, to solve the problems such as improving the efficiency of fast orientation to troubles and reducing maintenance cost, system of 1553B bus information monitor model based on ICD was proposed. The system observed whether the data which transmitted on the bus appear distortion and deviation by using data acquisition card. And using 1553B communication card programming of the measure software LabWindows/CVI and the dynamic linking of ICD database, message analysis and fault estimation could be realized. Compared with traditional maintenance, this model can all-dimensionally detect and analyze the source of faults from both electrical characteristics of the signal and message analysis, and it can be widely applied in the other 1553B system. Experiment shown that this monitor system can effectively detect and analyze the bus message and can meet the application requirements.  

    标签: 1553B 总线 信息监控

    上传时间: 2013-11-23

    上传用户:18752787361

  • 基于C8051F060的数据采集存储系统的设计

    介绍一种基于C8051F060单片机和NAND Flash的数据采集存储系统,该系统可实现3路信号采样,每路采样率为5KS/s,通过异步串行通信接口实现数据传输。并详细说明系统的软件设计。 Abstract:  An acquisition and storage system based on C8051F060and NAND Flash is designed in this paper.The system is used to sample three-channel of signal,5KSPS each channel,and can upload data to test bench through UART(Universal Asynchronous Receiver/Transmitter).The software design is discussed in detail.

    标签: C8051F060 数据采集 存储系统

    上传时间: 2013-10-12

    上传用户:Jesse_嘉伟

  • 基于C8051F020单片机的多路压力测量仪

    介绍了一种基于C8051F020单片机的多路压力测量仪。该测量仪选用电阻应变式压力传感器采集压力信号,并经放大电路处理后送入C8051F020单片机,再由C8051F020单片机内部的A/D转换器将采集到的压力信号进行模数转化,然后分别对数据进行存储和显示。该测量仪能测量6路压力信号,并且各测量点都能单独检测和设置。由于采用了C8051F020单片机,简化了硬件电路,增强了抗干扰能力,使得测量仪具有测量精度高,冲击小等特点。 Abstract:  A measurement apparatus for multi-channel pressure based on single chip microcomputer is introduced.It can measure 6 channels signal of the pressure,and the pressure measure points can be detection and located individually.The pressure signal sampling is obtained by resistor stress-type pressure sensors,the digital signals of 6 channels are collected through amplifying and adjustment circuit of pressure signals and internal integrated A/D converter of MCU.Finally,and it realizes the function to store and display data separately.C8051F020 was used to made hardware circuit simple,and it also enhanced the anti-interference ability.It features high precision and little impact.

    标签: C8051F020 单片机 多路 压力

    上传时间: 2013-11-16

    上传用户:yare

  • 基于MC33993的多路开关检测接口电路设计

    主要介绍了以PIC18F2480单片机为处理器,基于可编程多路开关检测接口器件MC33993实现的车用多路开关检测接口电路的设计。该设计克服了以往基于分立元件的检测接口电路的弊端,简化了接口电路设计,保证了车用开关工作的可靠性和安全性。 Abstract:  The design of automotive multiple switch detection interface circuit based on MC33993 is introduced mainly which adopts PIC18F2480 single chip microprocessor.This circuit overcomes shortage of traditional design which contains many schism elements, and the application of MC33993 also predigests the whole design of interface circuit and guarantees the dependability and security of the switch.

    标签: 33993 MC 多路开关 检测

    上传时间: 2013-11-19

    上传用户:star_in_rain

  • 多路温度采集及监控系统的设计

    介绍一种基于单片机的多路温度采集及监控系统,能够测量6路温度信号,具有计算机联网功能,各测量点可以单独监控和设置,可根据用户的需求自动控制。测量温度范围为-10 ℃~200 ℃,控制方式采用模拟量调压模式。该系统具有控制精度高、冲击小等特点。 Abstract:  A temperature collecting and surveillance-controlling system based on sing-chip microcomputer is introduced. It can measure 6 channel signal of the temperature,and it has a function of network connection.The temperature measure points can be monitored and located, it can be controlled automatic according to user’s demand.The temperature range is -10℃ to 200℃.The model of control is adjustable voltage with simulation. It features high precision and little impact.

    标签: 多路 温度采集 监控系统

    上传时间: 2013-10-23

    上传用户:bjgaofei