通用异步收发器UART(Universal Asynchronous Receiver/Transmitter)是广泛使用的串行传输协议。串行外设用到异步串行接口一般采用专用集成电路实现。但是这类芯片一般包含许多辅助模块，而时常不需要使用完整的UART的功能和辅助功能，或者当在FPGA上设计时，需要将UART功能集成到FPGA内部而不能使用芯片。蓝牙主机控制器接口则是实现主机设备与蓝牙模块之间互操作的控制部件。当在使用蓝牙设备的时候尤其是在监控场所，接口控制器在控制数据与计算机的传输上就起了至关重要的作用。 论文针对信息技术的发展和开发过程中的实际需要，设计了一个蓝牙HCI-UART(Host Controller Interface-Universal Asynchronous Receiver/Transmitter)控制接口的模块。使用VHDL将其核心功能集成，既可以单独使用，也可集成到系统芯片中，并且整个设计紧凑、稳定且可靠，其用途广泛，具有一定的使用价值。 本设计采用TOP-DOWN设计方法，整体上分为UART接口和蓝牙主机控制器接口两部分。首先根据UART和蓝牙主机控制器接口的实现原理和设计指标要求进行系统设计，对系统划分模块以及各个模块的信号连接；然后进行模块设计，设计出每个模块的功能，并用VHDL语言编写代码来实现模块功能；再使用ISE8.2I自带的仿真器对各模块进行功能仿真和时序仿真；最后进行硬件验证，在Virtex-II开发板上对系统进行功能验证。实现了发送、接收和波特率发生等功能，验证了结果，表明设计正确，功能良好，符合设计要求。
上传时间： 2013-04-24
上传用户：tianyi223
·详细说明：完整的MP3播放器源码。包括列表窗口，音频特性调整功能，仿照winamp。支持换肤。- Complete MP3 player source code. Including tabulates the window, the audio frequency characteristic adjustment function, imitates winamp. The support t
上传时间： 2013-06-17
上传用户：郭静0516
·详细说明：双音多频（DTMF）信号发生器的使用源程序，vc 编写，与《双音多频（DTMF）接收器的使用源程序》联合用- The double sound multi- frequencies (DTMF) the signal generating device use source program, the vc compilation, (DTMF) Receiver Use Source p
上传时间： 2013-07-23
上传用户：tianjinfan
Abstract: The MAX3108 is a complete high-performance universal asynchronous receiver-transmitter (UART) in a tiny 2.1mm ×
标签： Programming Rates Baud 3108
上传时间： 2014-12-23
上传用户：清风冷雨
The LT®6552 is a specialized dual-differencing 75MHzoperational amplifier ideal for rejecting common modenoise as a video line receiver. The input pairs are designedto operate with equal but opposite large-signal differencesand provide exceptional high frequency commonmode rejection (CMRR of 65dB at 10MHz), therebyforming an extremely versatile gain block structure thatminimizes component count in most situations. The dualinput pairs are free to take on independent common modelevels, while the two voltage differentials are summedinternally to form a net input signal.
上传时间： 2014-12-23
上传用户：13691535575
Designers of signal receiver systems often need to performcascaded chain analysis of system performancefrom the antenna all the way to the ADC. Noise is a criticalparameter in the chain analysis because it limits theoverall sensitivity of the receiver. An application’s noiserequirement has a signifi cant infl uence on the systemtopology, since the choice of topology strives to optimizethe overall signal-to-noise ratio, dynamic range andseveral other parameters. One problem in noise calculationsis translating between the various units used by thecomponents in the chain: namely the RF, IF/baseband,and digital (ADC) sections of the circuit.
上传时间： 2014-12-05
上传用户：cylnpy
分析了调幅信号和载波信号之间的相位差与调制信号的极性的对应关系,得出了相敏检波电路输出电压的极性与调制信号的极性有对应关系的结论。为了验证相敏检波电路的这一特性,给出3 个电路方案,分别选用理想元件和实际元件,采用Multisim 对其进行仿真实验,直观形象地演示了相敏检波电路的鉴相特性,是传统的实际操作实验所不可比拟的。关键词:相敏检波;鉴相特性;Multisim;电路仿真 Abstract : The corresponding relation between modulation signal polarity and difference phases of amplitudemodulated signal and the carrier signal ,the polarity of phase2sensitive detecting circuit output voltage and the polarity of modulation signal are correspondent . In order to verify this characteristic ,three elect ric circuit s plans are produced ,idea element s and actual element s are selected respectively. Using Multisim to carry on a simulation experiment ,and then demonst rating the phase detecting characteristic of the phase sensitive circuit vividly and directly. Which is t raditional practical experience cannot be com pared.Keywords :phase sensitive detection ;phase2detecting characteristic ;Multisim;circuit simulation
上传时间： 2013-11-23
上传用户：guanhuihong
Avalanche photo diode (APD) receiver modules arewidely used in fi ber optic communication systems. AnAPD module contains the APD and a signal conditioningamplifi er, but is not completely self contained. It stillrequires signifi cant support circuitry including a highvoltage, low noise power supply and a precision currentmonitor to indicate the signal strength. The challenge issqueezing this support circuitry into applications withlimited board space. The LT®3482 addresses this challengeby integrating a monolithic DC/DC step-up converter andan accurate current monitor. The LT3482 can supportup to a 90V APD bias voltage, and the current monitorprovides better than 10% accuracy over four decades ofdynamic range (250nA to 2.5mA).
上传时间： 2014-01-18
上传用户：wenyuoo
介绍一种基于C8051F060单片机和NAND Flash的数据采集存储系统，该系统可实现3路信号采样，每路采样率为5KS/s,通过异步串行通信接口实现数据传输。并详细说明系统的软件设计。 Abstract: An acquisition and storage system based on C8051F060and NAND Flash is designed in this paper.The system is used to sample three-channel of signal,5KSPS each channel,and can upload data to test bench through UART（Universal Asynchronous Receiver/Transmitter）.The software design is discussed in detail.
上传时间： 2013-10-12
上传用户：Jesse_嘉伟
在嵌入式系统中，嵌入式CPU往往要通过各种串行数据总线与“外界”进行通信。在应用中，异步的串行数据通信用得较多，而通用异步收发器UART（Universal Asynchronous Receiver Transmitter）在其中扮演着重要角色：完成数据的串并转换，即把并行数据按照通信波特率转化为通信协议中规定的串行数据流，也可从串行数据流中取出有用数据转变为并行数据。而UART与CPU接口简单，CPU只需通过执行读写操作即可完成收发数据，从而完成与外界的通信。有许多现成的芯片可以实现UART的功能，如常用的Intel8250/8251接口芯片就可以作为RS232、RS422串口的UART控制芯片。
上传时间： 2013-11-25
上传用户：www240697738
