目前电动汽车主要以锂电池作为动力来源,为了提高锂电池的使用时间和安全性,为锂电池提供安全良好的运行环境,电池管理系统应运而生。BMS主控单元基于S32K144汽车级单片机,通过主从式网络控制结构能够对锂电池的各个参数进行采集与分析。采用扩展卡尔曼滤波对电池的荷电状态(SOC)进行估算,克服普通估算方法无法避免电池内阻误差的缺点,通过Matlab/Simulink软件仿真验证可使估算误差达到2%以内。At present,electric vehicles mainly use lithium batteries as the power source.In order to improve the running time and safety of lithium batteries,a safe and good operating environment for power batteries is provided,and a battery management system(BMS) has emerged.The BMS main control unit is based on the S32K144 automotive-grade control chip.Through the master-slave network control structure,it can collect and analyze the various parameters of the lithium battery.The Extended Kalman Filter(EKF) is used to estimate the state of charge(SOC) of the battery,which overcomes the shortcomings of the internal estimation method that cannot overcome the internal resistance error of the battery.It can be verified by Matlab/Simulink software simulation.The estimation error is within 2%.
上传时间： 2022-03-26
上传用户：XuVshu
数字示波器功能强大,使用方便,但是价格相对昂贵。本文以Ti的MSP430F5529为主控器,以Altera公司的EP2C5T144C8 FPGA器件为逻辑控制部件设计数字示波器。模拟信号经程控放大、整形电路后形成方波信号送至FPGA测频,根据频率值选择采用片上及片外高速AD分段采样。FPGA控制片外AD采样并将数据输入到FIFO模块中缓存,由单片机进行频谱分析。测试表明:简易示波器可以实现自动选档、多采样率采样、高精度测频及频谱分析等功能。Digital oscilloscope is powerful and easy to use, but also expensive. The research group designed a low-cost digital oscilloscope, the chip of MSP430F5529 of TI is chosen as the main controller and the device of EP2C5T144C8 of Altera company is used as the logic control unit. Analog signal enter the programmable amplifier circuit, shaping circuit and other pre-processing circuit. The shaped rectangular wave signal is sent to FPGA for measure the frequency. According to the frequency value to select AD on-chip or off-chip high-speed AD for sampling. FPGA controls the off-chip AD sampling and buffers AD data by FIFO module. The single chip microcomputer receives the data, and do FFT for spectrum analysis. The test shows that the simple oscilloscope can realize automatic gain selection, sampling at different sampling rates, high precision frequency measurement and spectrum analysis.
上传时间： 2022-03-27
上传用户：
本文设计了一种磁致伸缩位移传感器,介绍了该磁致伸缩位移传感器的测量原理,通过结构优化设计提高了仪器的性能,详述了硬件电路设计及实现方法,完成了软件设计,实现了高压充电、问询脉冲加载、时间测量及滤波等功能,并通过实验对其性能进行了验证。所研制的磁致伸缩位移传感器具有测量精度高、长期稳定性好等特点,满足了大量程、高精度、恶劣环境等测量的要求。A kind of sensor based on magnetostrictive principle is designed.The measuring principle of the magnetostrictive displacement sensor is introduced,the performance of the instrument is improved by the structural optimization design,and introduced the hardware circuit design and the realization method,completed the software design,realized the functions of the high voltage charging,inquiries pulse loading,time measurement and filtering,and its performance is verified through the experiment.The magnetostrictive displacement sensor has the characteristics of high measuring precision.The sensor meets the requirements of large range,high precision,poor environment and so on.
标签： 位移传感器
上传时间： 2022-04-06
上传用户：
为适应双向DC/DC功率变换的电流采样需求,一种高精度高边电流采样电路被提出。其基本思想是在功率电路的高边串入采样电阻,借助电流镜原理并引入偏置电流电路,将双向电流均转换为正向电压输出。通过理论分析与仿真结合的方法对电流镜采样原理及4种不同的偏置电流电路方案进行对比,最后通过实验数据验证了高精度高边电流采样电路的有效性。实验数据表明,该采样电路可在-25~75℃的温度工作范围内,针对-10~＋10 A范围内的电流采样实现优于5%的采样精度。Current sensing plays an important role in controlling,monitoring or protection functions of power systems.To meet the current sensing requirement of bidirectional DC/DC converters,a high-accuracy bidirectional current sensing circuit is proposed.The proposed current sensing circuit inserts a resistor in the path of the current to be sensed,while the current mirror and biased current circuit are introduced.Therefore,the bidirectional current can be expressed by positive voltage.By theoretical analysis and simulation,the sampling theory is analyzed and four biased current circuits are compared.At last,experimental results verified the proposed method.It is demonstrated that the proposed current sensing circuit can achi...
上传时间： 2022-04-22
上传用户：
数字频率计是电工电子中常用的测量仪器,数字频率计通过用输入待测信号对一特定长度的信号进行计数,从而得出频率并通过数码管直观的显示出来。本文提出了一种与输入同步的数字频率计的设计,提高了频率计的精度,设计采用Multisim软件进行设计和仿真的过程,介绍了其工作原理,硬件电路设计和仿真的过程。设计采用了Multisim软件进行设计和仿真,设计结果得到的验证。Digital frequency counter is used to measure the frequency of a signal.It is common to use a multivibrator to generate a standard 1 second time base signal and count input signal gated by this signal.However,the asynchronous of this time base signal with input signal will bring errors.In this paper,a high precision frequency counter which use synchronized time base signal generator is proposed.This frequency counter is designed and simulated by Multisim tools and result is verified.
标签： multisim
上传时间： 2022-05-08
上传用户：
说明： STM8单片机连接CAN芯片 MCP2515 的源码，已经通过工程验证。(MCP2515 CAN chip STM8 MCU connections of the source has been verified by engineering.)
上传时间： 2022-05-17
上传用户：
Introduction The Sil9135/Sil9135A HDMI Receiver with Enhanced Audio and Deep Color Outputs is a second-generation dual-input High Definition Multimedia Interface(HDMI)receiver. It is software-compatible with the Sil9133receiver, but adds audio support for DTS-HD and Dolby TrueHD. Digital televisions that can display 10-or 12-bit color depth can now provide the highest quality protected digital audio and video over a single cable. The Sil9135and Sil9135A devices, which are functionally identical, can receive Deep Color video up to 12-bit,1080p @60Hz. Backward compatibility with the DVI 1.0specification allows HDMI systems to connect to existing DVI 1.0 hosts, such as HD set-top boxes and PCs. Silicon Image HDMI receivers use the latest generation Transition Minimized Differential Signaling(TMDS) core technology that runs at 25-225 MHz.The chip comes pre-programmed with High-bandwidth?
上传时间： 2022-06-25
上传用户：
开关升压型锂电池充电管理芯片FLD5302/3概述 为开关型两节或三节锂离子/锂 聚合物电池充电管理芯片，非常适合于便携 式设备的充电管理应用。 集电压和电 流调节器、预充、充电状态指示和充电截止 适配器自适应等功能于一体，采用 SOP-8 封装。 对电池充电分为三个阶段：预 充（ Pre-charge ）、恒流（CC/Constant Current）、恒压（CV/Constant Voltage）过程。 集成过压及过流保护，确保电芯的 安全。
上传时间： 2022-06-25
上传用户：
eMMC (Embedded Multi Media Card）是MMC协会订立、主要针对手机或平板电脑等产品的内嵌式存储器标准规格。eMMC在封装中集成了一个控制器，提供标准接口并管理闪存，使得手机厂商就能专注于产品开发的其它部分，并缩短向市场推出产品的时间。MMC的应用是对存储容量有较高要求的消费电子产品。2011年已大量生产的一些热门产品，如Palm Pre、Amazon Kindle II和Flip MinoHD，都采用了eMMC。为了确认这些产品究竟使用了何种存储器，iSuppli利用拆机分析业务对它们进行了拆解，发现eMMC身在其中。附件为介绍EMMC5.1标准的数据手册.
上传时间： 2022-06-27
上传用户：
FU6831 是一款集成 8051 内核和电机控制引擎(ME)的电机驱动专用芯片，8051 内核处理常规事务，ME 处理电机实时事务，双核协同工作实现各种高性能电机控制。其中 8051 内核大部分指令周期为 1T 或 2T，芯片内部集成有高速运算放大器、比较器、Pre-driver、高速 ADC、高速乘/除法器、CRC、SPI、I2C、UART、多种 TIMER、PWM 等功能，内置高压 LDO，适用于 BLDC/PMSM 电机的方波、SVPWM/SPWM、FOC 驱动控制。预驱动为 3P3N Predriver 输出。
标签： fu6831
上传时间： 2022-07-09
上传用户：
