ADS8329 Verilog fpga 驱动源码，2.7V 至 5.5V 16 位 1MSPS 串行模数转换器 ADC芯片ADS8329数据采集的verilog代码，已经用在工程中，可以做为你的设计参考。( input clock, input timer_clk_r, input reset, output reg sample_over, output reg ad_convn, input ad_eocn, output reg ad_csn, output reg ad_clk, input ad_dout, output reg ad_din, output reg [15:0] ad_data_lock);reg [15:0] ad_data_old;reg [15:0] ad_data_new; reg [19:0] ad_data_temp; reg [15:0] ad_data;reg [4:0] ad_data_cnt;reg [4:0] ad_spi_cnt; reg [5:0] time_dly_cnt; parameter [3:0] state_mac_IDLE = 0, state_mac_0 = 1, state_mac_1 = 2, state_mac_2 = 3, state_mac_3 = 4, state_mac_4 = 5, state_mac_5 = 6, state_mac_6 = 7, state_mac_7 = 8, state_mac_8 = 9, state_mac_9 = 10, state_mac_10 = 11, state_mac_11 = 12, state_mac_12 = 13, state_mac_13 = 14, state_mac_14 = 15; reg [3:0] state_curr;reg [3:0] state_next;
上传时间： 2022-01-30
上传用户：1208020161
FPGA Verilog HDL设计温度传感器ds18b20温度读取并通过lcd1620和8位LED数码管显示的QUARTUS II 12.0工程文件，包括完整的设计文件.V源码，可以做为你的学习及设计参考。module ds18b20lcd1602display ( Clk, Rst, DQ, //18B20数据端口 Txd, //串口发送端口 LCD_Data, //lcd LCD_RS, LCD_RW, LCD_En, SMData, //数码管段码 SMCom //数码管位码 );input Rst,Clk;output Txd,LCD_RS,LCD_En,LCD_RW;inout DQ;output[7:0] LCD_Data;output[7:0] SMData;output[3:0] SMCom;wire DataReady;//测温完成信号wire [15:0] MeasureResult;//DS18B20测温结果reg [15:0] Temperature;//产生LCD的位码和段码LCD1602Display Gen_LCD(.resetin(Rst),.clkin(Clk),.Data16bIn(Temperature),.lcd_data(LCD_Data),.lcd_rs(LCD_RS),.lcd_rw(LCD_RW),.lcd_e(LCD_En)/*,.SMCom(SMCom)*/);//DS18B20测温和发送 DS18B20 TmpMeasureAndTx(.Rst(Rst),.Clk(Clk),.DQ(DQ),.Txd(Txd),.FinishFlag(DataReady),.Data16b(MeasureResult));//产生数码管的位码和段码SMDisplay Gen_SM(.Rst(Rst),.
标签： fpga verilog hdl 温度传感器 ds18b20 lcd1620 数码显示
上传时间： 2022-01-30
上传用户：
Precision, Low Noise, CMOS, Rail-to-Rail, Input/Output Operational Amplifiers Data Sheet AD8605/AD8606/AD8608The AD8605, AD8606, and AD86081 are single, dual, and quad rail-to-rail input and output, single-supply amplifiers. They feature very low offset voltage, low input voltage and current noise, and wide signal bandwidth. They use the Analog Devices, Inc. patented DigiTrim® trimming technique, which achieves
标签： 运算放大器
上传时间： 2022-02-02
上传用户：
spi 通信的master部分使用的verilog语言实现，可以做为你的设计参考。module spi_master(rstb,clk,mlb,start,tdat,cdiv,din, ss,sck,dout,done,rdata); input rstb,clk,mlb,start; input [7:0] tdat; //transmit data input [1:0] cdiv; //clock divider input din; output reg ss; output reg sck; output reg dout; output reg done; output reg [7:0] rdata; //received dataparameter idle=2'b00; parameter send=2'b10; parameter finish=2'b11; reg [1:0] cur,nxt; reg [7:0] treg,rreg; reg [3:0] nbit; reg [4:0] mid,cnt; reg shift,clr;
上传时间： 2022-02-03
上传用户：
verilog实现I2C通信的slave模块源码状态机设位计可做I2C接口的仿真模型//`timescale 1ns/1psmodule I2C_slv (input [6:0] slv_id,input RESET,input scl_i, //I2C clkinput sda_i, //I2C data ininput [7:0] I2C_RDDATA,////////////////////////output reg sda_o, //I2C data outoutput reg reg_w, //reg write enable pulse (1T of scl_i)output reg [7:0] I2C_ADDR,output reg [7:0] I2C_DATA); parameter ST_ADDR = 4'd0; parameter ST_ACK = 4'd1; parameter ST_WDATA1 = 4'd2; parameter ST_WACK1 = 4'd3; parameter ST_WDATA2 = 4'd4; parameter ST_WACK2 = 4'd5; parameter ST_WDATA3 = 4'd6; parameter ST_WACK3 = 4'd7; parameter ST_RDATA1 = 4'd8; parameter ST_RACK1 = 4'd9; parameter ST_IDLE = 4'd15;//---------------------------------------------------------------------------// Signal Declaration//--------------------------------------------------------------------------- reg i2c_start_n, i2c_stop_n; //wire RESET_scl; wire i2c_stp_n, i2c_RESET; reg [3:0] i2c_cs, i2c_ns; reg [3:0] cnt_bit; reg [7:0] d_vec; reg i2c_rd, i2c_ack; reg [7:0] I2C_RDDATA_latch;
上传时间： 2022-02-03
上传用户：
The PW5410B is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 1.8V to 5V input with up to 100mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410B ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：wangshoupeng199
The PW5410A is a low noise, constant frequency (1.2MHz) switched capacitor voltage doubler. Itproduces a regulated output voltage from 2.7V to 5V input with up to 250mA of output current. Lowexternal parts count (one flying capacitor and two small bypass capacitors at VIN and VOUT) makethe PW5410A ideally suited for small, battery-powered applications
标签： pw5410
上传时间： 2022-02-11
上传用户：
The PW2601 is a charger front-end integrated circuit designed to provide protection to Li-ionbatteries from failures of charging circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree
标签： pw2601
上传时间： 2022-02-11
上传用户：
PW2330 develops a high efficiency synchronous step down DC-DC converter capable of delivering3A output current. PW2330 operates over a wide input voltage range from 4.5V to 30V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss. PW2330 adopts the proprietary instant PWM architecture to achieve fast transient responsesfor high step down applications and high efficiency at light loads. In addition, it operates atpseudo-constant frequency of 500kHz under continuous conduction mode to minimize the size ofinductor and capacitor
标签： pw2330
上传时间： 2022-02-11
上传用户：
The PW2312 is a high frequency, synchronous, rectified, step-down, switch-mode converter withinternal power MOSFETs. It offers a very compact solution to achieve a 1.5A peak output currentover a wide input supply range, with excellent load and line regulation.The PW2312 requires a minimal number of readily available, external components and is available ina space saving SOT23-6 package.
标签： pw2312
上传时间： 2022-02-11
上传用户：qingfengchizhu
