给定三个n阶线性方程组Ax=b，采用列主元素法解线性方程组的直接法。
上传时间： 2014-01-19
上传用户：璇珠官人
一﹑指标要求：. A: f5 b G A( d8 n （１）设计一个4位十进制的频率计其测量范围1Hz~9.999KHz；6 N3 G8 k( U- @ n* A （２）记数过程结束后，保存并显示结果；
上传时间： 2014-01-07
上传用户：妄想演绎师
To use this function just define a variable say var, var = pnseq(a, b, c) for a, b and c refer to the zip file
标签： var function variable define
上传时间： 2014-01-06
上传用户：zhuoying119
针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS，提出一种PS2键盘的设计方法。基于W78E052D单片机，采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路，电位器位置信息以键盘扫描码序列形式发送，正交编码器信号通过XC9536XL转换为单片机可接收的中断信号，软件接收到中断信息后等效处理成按键。结果表明，在满足开机可设置BIOS同时，又可实现超声特有功能，不需要专门设计驱动程序，接口简单，成本低。 Abstract: Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot， this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller，designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter， potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU， software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot， ultrasound specific functionality can be achieved at the same time， it does not require specially designed driver，the interface is simple and low cost.
上传时间： 2013-10-10
上传用户：asdfasdfd
See Appendix B for a description of the programs included on this companion disk. RESOURCE.WRI identifies other books and resources for Internet programming. WEBHELP.HLP contains an introduction to the World Wide Web. TCPMAN.HLP provides detailed instructions to help you use the Trumpet Winsock included on this disk. Use the Program Manager s File menu Run option to execute the SETUP.EXE program found on this disk. SETUP.EXE will install the programs on your hard drive and create an Internet Programming group window. Internet编程技术 [配套程序] [涉及平台] VC [作者] void [文件大小] 1032K
标签： description companion Appendix RESOURCE
上传时间： 2013-12-04
上传用户：asasasas
Rotating shafts experience a an elliptical motion called whirl. It is important to decompose this motion into a forward and backward whil orbits. The current function makes use of two sensors to generate a bi-directional spectrogram. The method can be extended to any time-frequency distribution ％ ％ compute the forward/backward Campbell/specgtrogram ％ ％ INPUT: ％ y (n x 2) each column is measured from a different sensor ％ /////// ％ __ ％ |s1| y(:,1) ％ |__| ％ __ ％ / \ ________|/ ％ | | | s2 |/ y(:,2) ％ \____/ --------|/ ％ ％ Fs Sampling frequnecy ％ ％ OUTPUT: ％ B spectrogram/Campbel diagram ％ x x-axis coordinate vector (time or Speed) ％ y y-axis coordinate vector (frequency [Hz])
标签： experience elliptical decompose important
上传时间： 2015-06-23
上传用户：372825274
剖析Intel IA32 架构下C 语言及CPU 浮点数机制 Version 0.01 哈尔滨工业大学 谢煜波 （email: xieyubo@126.com 网址:http://purec.binghua.com） （QQ:13916830 哈工大紫丁香BBSID:iamxiaohan） 前言 这两天翻看一本C 语言书的时候，发现上面有一段这样写到 例：将同一实型数分别赋值给单精度实型和双精度实型，然后打印输出。 #include <stdio.h> main() { float a double b a = 123456.789e4 b = 123456.789e4 printf(“％f\n％f\n”,a,b) } 运行结果如下：
标签： Version xieyubo Intel email
上传时间： 2013-12-25
上传用户：徐孺
/* * EULER S ALGORITHM 5.1 * * TO APPROXIMATE THE SOLUTION OF THE INITIAL VALUE PROBLEM: * Y = F(T,Y), A<=T<=B, Y(A) = ALPHA, * AT N+1 EQUALLY SPACED POINTS IN THE INTERVAL [A,B]. * * INPUT: ENDPOINTS A,B INITIAL CONDITION ALPHA INTEGER N. * * OUTPUT: APPROXIMATION W TO Y AT THE (N+1) VALUES OF T. */
标签： APPROXIMATE ALGORITHM THE SOLUTION
上传时间： 2015-08-20
上传用户：zhangliming420
* "Copyright (c) 2006 Robert B. Reese ("AUTHOR")" * All rights reserved. * (R. Reese, reese@ece.msstate.edu, Mississippi State University) * IN NO EVENT SHALL THE "AUTHOR" BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE "AUTHOR" * HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
上传时间： 2015-09-24
上传用户：mpquest
基于事件驱动的串口通讯控件 消息帧数据格式: 1 0 A B X X 其中 10 为消息标识, AB表示文本长度,L=A*100+B XX为配位字符,任意 控制帧数据格式 0 1 A B M N 其中 01为控制标识, AB为请求标识 MN为附加标识 11表示请求对方接收文件,M表示描述字串中文件名子串的长度 N表示描述字串中文件大小子串的长度 10通知对方放弃传输 00通知文件传输完毕 01请求对方发送数据, MN为10请求发送下一个 MN为00请求重发 数据帧数据格式 0 0 A B M N 其中 00 为数据标识, AB表示数据长度,L=A*100+B MN为校验,M*100+N=A+B
上传时间： 2015-10-06
上传用户：拔丝土豆
