虫虫首页|资源下载|资源专辑|精品软件
登录|注册

fault-tolerant

  • c pgm to find redundant paths in a graph.Many fault-tolerant network algorithms rely on an underlyin

    c pgm to find redundant paths in a graph.Many fault-tolerant network algorithms rely on an underlying assumption that there are possibly distinct network paths between a source-destination pair. Given a directed graph as input, write a program that uses depth-first search to determine all such paths. Note that, these paths are not vertex-disjoint i.e., the vertices may repeat but they are all edge-disjoint i.e., no two paths have the same edges. The input is the adjacency matrix of a directed acyclic graph and a pair(s) of source and destination vertices and the output should be the number of such disjoint paths and the paths themselves on separate lines. In case of multiple paths the output should be in order of paths with minimum vertices first. In case of tie the vertex number should be taken in consideration for ordering.

    标签: fault-tolerant algorithms redundant underlyin

    上传时间: 2013-12-17

    上传用户:jkhjkh1982

  • lpc2292/lpc2294 pdf datasheet

    The LPC2292/2294 microcontrollers are based on a 16/32-bit ARM7TDMI-S CPU with real-time emulation and embedded trace support, together with 256 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at the maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 pct with minimal performance penalty. With their 144-pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, 2/4 (LPC2294) advanced CAN channels, PWM channels and up to nine external interrupt pins these microcontrollers are particularly suitable for automotive and industrial control applications as well as medical systems and fault-tolerant maintenance buses. The number of available fast GPIOs ranges from 76 (with external memory) through 112 (single-chip). With a wide range of additional serial communications interfaces, they are also suited for communication gateways and protocol converters as well as many other general-purpose applications. Remark: Throughout the data sheet, the term LPC2292/2294 will apply to devices with and without the /00 or /01 suffix. The suffixes /00 and /01 will be used to differentiate from other devices only when necessary.

    标签: lpc datasheet 2292 2294

    上传时间: 2014-12-30

    上传用户:aysyzxzm

  • RFC 3119 中文版 A More Loss-Tolerant RTP Payload Format for MP3 Audio

    RFC 3119 中文版 A More Loss-Tolerant RTP Payload Format for MP3 Audio

    标签: Loss-Tolerant Payload Format Audio

    上传时间: 2015-12-07

    上传用户:330402686

  • 小波神经网络好文章!A method for fault detection is proposed using a trained neural network as the nominal mo

    小波神经网络好文章!A method for fault detection is proposed using a trained neural network as the nominal model of the system to be monitored. Partial physical knowledge, if available, can be combined with the nominal model to perform fault isolation.

    标签: detection proposed network nominal

    上传时间: 2014-12-08

    上传用户:gmh1314

  • 神經網路學習分類..Neural Fault Classifier for Transmission Line Protection A Modular Approach

    神經網路學習分類..Neural Fault Classifier for Transmission Line Protection A Modular Approach

    标签: Transmission Classifier Protection Approach

    上传时间: 2016-01-16

    上传用户:shizhanincc

  • A new cable fault location method based on wavelet reconstruction is proposed. In this method the

    A new cable fault location method based on wavelet reconstruction is proposed. In this method the difference between the currents of faulty phase and sound phase under the high voltage pulse excitation is used as the measured signal and is decomposed in multi-scale by wavelet transform, then reconstructed in single scale. Comparing with traditional fault location method by travelling wave, the presented method will not be interfered by the reflected wave from the branch joint of cables or from other positions where the impedances are not matched and not be influenced by fault types, otherwise, the reflected waves can be recognized even the faulty position is near to the measuring terminal, at the same time, the influence of the wave speed uncertainty can be reduced. The correctness of the proposed method is proved by simulation results.

    标签: method reconstruction location proposed

    上传时间: 2016-02-03

    上传用户:maizezhen

  • DTNSim2 is a simulator for Delay-Tolerant Networks (DTNs) written in Java. It is based on Sushant Ja

    DTNSim2 is a simulator for Delay-Tolerant Networks (DTNs) written in Java. It is based on Sushant Jain s DTNSim, which was used for the Routing in a delay tolerant network paper. It has been exensively modified.

    标签: Delay-Tolerant simulator Networks DTNSim2

    上传时间: 2016-11-06

    上传用户:tianyi223

  • Make a Driver is difficult, it need some experients. When you write it, you will be fault to other

    Make a Driver is difficult, it need some experients. When you write it, you will be fault to other fault. i think that, this book is good to make driver use WDM(window driver model)

    标签: experients difficult you Driver

    上传时间: 2013-12-12

    上传用户:wxhwjf

  • neural network based fault finding relay

    neural network based fault finding relay

    标签: network finding neural based

    上传时间: 2013-11-27

    上传用户:tianjinfan

  • neural network fault finding relay

    neural network fault finding relay

    标签: network finding neural fault

    上传时间: 2014-01-17

    上传用户:himbly