Without this, the debugger spontaneously fails! 1 - Install mdk315b 2 - Replace the files: \Keil\ARM\BIN\ARM.DLL with one from mdk305a\Keil\ARM\BIN\ARM.DLL \Keil\ARM\BIN31\ARM.DLL with one from mdk305a\Keil\ARM\BIN30\ARM.DLL \Keil\UV3\UV3.DLL with one from mdk305a\Keil\UV3\UV3.DLL (*) 3 - Use KeyGen (Ver3p4 works) Select ARM, With computer ID code , External CID code and RealView MDK (or RealView RL) Note: Must replace DLLs before entry of serial (*) - May not be necessary (???)
标签： spontaneously the debugger Without
上传时间： 2016-04-13
上传用户：小宝爱考拉
Boost LED drivers are often used to drive LEDs in series. If an LED fails while open,overvoltage protection (OVP) is necessary to avoid the damage to a boost integrated circuit (IC) or output capacitor. This application report presents the solutions to increase the TPS61043 LED driver OVP threshold.
标签： Overvoltage Protection Solutions Driver
上传时间： 2013-10-14
上传用户：jiangfire
The PCA9541 is a 2-to-1 I2C-bus master selector designed for high reliability dual masterI2C-bus applications where system operation is required, even when one master fails orthe controller card is removed for maintenance. The two masters (for example, primaryand back-up) are located on separate I2C-buses that connect to the same downstreamI2C-bus slave devices. I2C-bus commands are sent by either I2C-bus master and are usedto select one master at a time. Either master at any time can gain control of the slavedevices if the other master is disabled or removed from the system. The failed master isisolated from the system and will not affect communication between the on-line masterand the slave devices on the downstream I2C-bus.
上传时间： 2013-10-09
上传用户：3294322651
The STWD100 watchdog timer circuits are self-contained devices which prevent systemfailures that are caused by certain types of hardware errors (non-responding peripherals,bus contention, etc.) or software errors (bad code jump, code stuck in loop, etc.).The STWD100 watchdog timer has an input, WDI, and an output, WDO (see Figure 2). Theinput is used to clear the internal watchdog timer periodically within the specified timeoutperiod, twd (see Section 3: Watchdog timing). While the system is operating correctly, itperiodically toggles the watchdog input, WDI. If the system fails, the watchdog timer is notreset, a system alert is generated and the watchdog output, WDO, is asserted (seeSection 3: Watchdog timing).The STWD100 circuit also has an enable pin, EN (see Figure 2), which can enable ordisable the watchdog functionality. The EN pin is connected to the internal pull-downresistor. The device is enabled if the EN pin is left floating.
上传时间： 2013-10-22
上传用户：taiyang250072
This directory contains the memtest 8051 firmware for the Anchor Chips EZ-USB chip. The purpose of this software is to test the different memory segments in the Ez-Usb chip. This example will output the string "good" on the 7 segment LED if the mem test passes, or it will output the first address where the memtest fails.
标签： directory the contains firmware
上传时间： 2015-05-04
上传用户：zxc23456789
These libraries are designed for use with Microsoft Visual C++ version 6.0. Install them by running setup.exe. This will copy the files to various places where MSVC will expect to find them. If setup fails, alternate instructions are below.
标签： Microsoft libraries designed Install
上传时间： 2015-06-23
上传用户：s363994250
We address the problem of blind carrier frequency-offset (CFO) estimation in quadrature amplitude modulation, phase-shift keying, and pulse amplitude modulation communications systems.We study the performance of a standard CFO estimate, which consists of first raising the received signal to the Mth power, where M is an integer depending on the type and size of the symbol constellation, and then applying the nonlinear least squares (NLLS) estimation approach. At low signal-to noise ratio (SNR), the NLLS method fails to provide an accurate CFO estimate because of the presence of outliers. In this letter, we derive an approximate closed-form expression for the outlier probability. This enables us to predict the mean-square error (MSE) on CFO estimation for all SNR values. For a given SNR, the new results also give insight into the minimum number of samples required in the CFO estimation procedure, in order to ensure that the MSE on estimation is not significantly affected by the outliers.
标签： frequency-offset estimation quadrature amplitude
上传时间： 2014-01-22
上传用户：牛布牛
This directory contains the memtest 8051 firmware for the Anchor Chips EZ-USB chip. The purpose of this software is to test the different memory segments in the Ez-Usb chip. This example will output the string "good" on the 7 segment LED if the mem test passes, or it will output the first address where the memtest fails.
标签： directory the contains firmware
上传时间： 2013-12-16
上传用户：gdgzhym
