S64是atmel公司的一块ARM7处理器，价格低廉，16k RAM 64K flash，带USB接口，是ARM入门的好选择，这个是它的电路图，protel的
上传时间： 2013-12-26
上传用户：gtzj
介绍了viterbi译码器的编解码器的设计，包括decoder.v,encoder.v.control.v,ram.v等，压缩 包里面有pdf说明
上传时间： 2013-12-20
上传用户：zhichenglu
Ideal for large low power (nanoWatt) and connectivity applications that benefit from the availability of four serial ports: double synchronous serial ports (I² C™ and SPI™ ) and double asynchronous (LIN capable) serial ports. Large amounts of RAM memory for buffering and FLASH program memory make it ideal for instrumentation panels, TCP/IP enabled embedded applications as well as metering and industrial control and monitoring applications. While operating up to 40 MHz, it is also backward software and hardware compatible with the PIC18F8720.
标签： connectivity applications availabilit nanoWatt
上传时间： 2016-02-04
上传用户：CHINA526
在使用单片机作为控制cpu时，请稍作简化，具体的PID参数必须由具体对象通过实验确定。由于单片机的处理速度和ram资源的限制，一般不采用浮点数运算，而将所有参数全部用整数，运算到最后再除以一个2的N次方数据（相当于移位），作类似定点数运算，可大大提高运算速度，根据控制精度的不同要求，当精度要求很高时，注意保留移位引起的“余数”，做好余数补偿。这个程序只是一般常用pid算法的基本架构，没有包含输入输出处理部分。
上传时间： 2016-02-05
上传用户：1109003457
FIFO电路(first in，first out)，内部藏有１６ｂｉｔ×１６ｗｏｒｄ的Dual port RAM，依次读出已经写入的数据。因为不存在Address输入，所以请自行设计内藏的读写指针。由FIFO电路输出的EF信号(表示RAM内部的数据为空)和FF信号(表示RAM内部的数据为满)来表示RAM内部的状态，并且控制FIFO的输入信号WEN(写使能)和REN(读使能)。以及为了更好得控制FIFO电路，AEF(表示RAM内部的数据即将空)信号也同时输出。
上传时间： 2016-02-06
上传用户：zhoujunzhen
μC/OS-II Goals Probably the most important goal of μC/OS-II was to make it backward compatible with μC/OS (at least from an application’s standpoint). A μC/OS port might need to be modified to work with μC/OS-II but at least, the application code should require only minor changes (if any). Also, because μC/OS-II is based on the same core as μC/OS, it is just as reliable. I added conditional compilation to allow you to further reduce the amount of RAM (i.e. data space) needed by μC/OS-II. This is especially useful when you have resource limited products. I also added the feature described in the previous section and cleaned up the code. Where the book is concerned, I wanted to clarify some of the concepts described in the first edition and provide additional explanations about how μC/OS-II works. I had numerous requests about doing a chapter on how to port μC/OS and thus, such a chapter has been included in this book for μC/OS-II.
标签： OS-II compatible important Probably
上传时间： 2013-12-02
上传用户：jkhjkh1982
DSP2812的直流斩波调速程序，已经做出了实物，能成功的烧写到了FLASH了用CCS2000调试用不同的CMD文件在RAM中运行或在FLASH中运行
上传时间： 2016-02-26
上传用户：gououo
S3C2410的ADS工程，有内存映射，可在RAM中调试中断
上传时间： 2014-01-02
上传用户：佳期如梦
电赛一等奖作品：音频信号分析仪的FPGA源码，VHDL编写，Quartus7.1综合，ModelSim6.2g se仿真，应用了opencores.org上的开源FFT IP核，加入了8051总线接口和ram
上传时间： 2013-12-29
上传用户：yoleeson
NAME Control_AT24Cxx This collection of routines allows an AT89C2051 microcontroller to read and write the AT24Cxx family of serial CMOS EEPROMS. This version of the code is compatible only with the AT89C2051 due to the location of the data buffer and stack in RAM. The code may be modified to work with the AT89C1051 by relocating or resizing the buffer and stack to fit into the smaller amount of RAM available in the AT89C1051. Note that the minimum size of the buffer is determined by the page size of the AT24Cxx.
标签： microcontroller Control_AT collection routines
上传时间： 2013-12-13
上传用户：asddsd
