The PCA9541 is a 2-to-1 I2C-bus master selector designed for high reliability dual masterI2C-bus applications where system operation is required, even when one master fails orthe controller card is removed for maintenance. The two masters (for example, primaryand back-up) are located on separate I2C-buses that connect to the same downstreamI2C-bus slave devices. I2C-bus commands are sent by either I2C-bus master and are usedto select one master at a time. Either master at any time can gain control of the slavedevices if the other master is disabled or removed from the system. The failed master isisolated from the system and will not affect communication between the on-line masterand the slave devices on the downstream I2C-bus.
上传时间： 2013-10-09
上传用户：3294322651
The TJA1042 is a high-speed CAN transceiver that provides an interface between aController Area Network (CAN) protocol controller and the physical two-wire CAN bus.The transceiver is designed for high-speed (up to 1 Mbit/s) CAN applications in theautomotive industry, providing the differential transmit and receive capability to (amicrocontroller with) a CAN protocol controller.
标签： High-speed transce 1042 TJA
上传时间： 2014-12-28
上传用户：气温达上千万的
The TJA1051 is a high-speed CAN transceiver that provides an interface between aController Area Network (CAN) protocol controller and the physical two-wire CAN bus.The transceiver is designed for high-speed (up to 1 Mbit/s) CAN applications in theautomotive industry, providing differential transmit and receive capability to (amicrocontroller with) a CAN protocol controller.
标签： High-speed transce 1051 TJA
上传时间： 2013-10-17
上传用户：jisujeke
The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
标签： MULTICHANNEL 5.5 TO RS
上传时间： 2013-10-19
上传用户：ddddddd
本文依据集成电路设计方法学，探讨了一种基于标准Intel 8086 微处理器的单芯片计算机平台的架构。研究了其与SDRAM，8255 并行接口等外围IP 的集成，并在对AMBA协议和8086 CPU分析的基础上，采用遵从AMBA传输协议的系统总线代替传统的8086 CPU三总线结构，搭建了基于8086 IP 软核的单芯片计算机系统，并实现了FPGA 功能演示。关键词：微处理器； SoC；单芯片计算机；AMBA 协议 Design of 8086 CPU Based Computer-on-a-chip System（School of Electrical Engineering and Automation, Heifei University of Technology, Hefei, 230009,China）Abstract: According to the IC design methodology, this paper discusses the design of one kind of Computer-on-a-chip system architecture, which is based on the standard Intel8086 microprocessor,investigates how to integrate the 8086 CPU and peripheral IP such as, SDRAM controller, 8255 PPI etc. Based on the analysis of the standard Intel8086 microprocessor and AMBA Specification,the Computer-on-a-chip system based on 8086 CPU which uses AMBA bus instead of traditional three-bus structure of 8086 CPU is constructed, and the FPGA hardware emulation is fulfilled.Key words: Microprocessor; SoC; Computer-on-a-chip; AMBA Specification
上传时间： 2013-12-27
上传用户：kernor
SystemView仿真软件的应用:利用系统设计、分析和仿真的可视化开发环境—SystemView 软件平台进行通信原理课程教学, 对SystemView 仿真软件进行了简要的介绍.并以2DPSK的调制解调原理为例分析了仿真过程，结果表明通过用SystemView 软件仿真,可以很方便地得到所设计电路的输出结果与分析波形。关键词：SystemView；仿真；2DPSK通信原理是电子信息工程、通信工程等专业的一门重要的专业基础理论课，能否正确理解其概念和基本理论对后续专业课程的学习非常关键。由于该课程公式和理论推导较多，学起来相对乏味，单纯依靠课堂讲解, 很难理解，只有借助一定的辅助工具，才能让学生更好的掌握这门课程。为了使学生能从动态上更直观地形象地理解这些理论, 可以采用动态系统仿真软件System View以增强课堂教学效果,从而使学生更好地掌握其基础理论。
标签： SystemView 仿真软件
上传时间： 2013-11-01
上传用户：haohaoxuexi
keil 使用笔记:在Memory窗口上输入address_type:address才能看到正确地址的变量debug～perfermance analyzer加入要察看的模块名称，然后view～perfermance analyzer window 可以察看各个模块运行时间①Display address_type:address B:Bit address C:Code Memory Bx:Code Bank D D：80H 命令可以查看特殊寄存器 data D I：0 命令可以查看内部RAM数据iData； D X：0 命令可以查看外部RAM数据xData； ②R1 //显示R1 register ~R1 //显示变量R1 R1 = R7 //对寄存器Rx操作R1 = --R7 R1 = 0x20 ③main //显示main()的开始地址d main //显示main()的代码④向RAM.ROM中写数据Enter data_type address_type:address expr,expr.... data_type:int char double float long E char data:0x20 1,2,3,4 //向data区0x20开始的地址写1,2,3,4 变量放在RAM的30H，要把定义放在main前面!另外特别注意，内部RAM通常供C程序存放中间变量等，所以一定要看看编译后的程序中是否存在存储单元冲突的情况，比如如果程序中 使用了别的寄存器组的话，08-1FH单元就不能用了unsigned long data i _at_ 0x30
上传时间： 2013-11-05
上传用户：dongqiangqiang
基于单片机的步进电机开环控制系统:通过ATMEL89C51单片机对步进电机进行控制,主要介绍了步进电机控制器、驱动电路和LED显示电路的设计,实现了步进电机的开环控制。在步进电机控制器的设计中,重点阐述了脉冲产生电路以及对速度的控制。该系统具有成本低、控制方便的特点。关键词: 单片机; 步进电机; 开环控制 Abstract: The design using ATMEL89C51 single chip to control the step2motor with its controller, driving circuit and LED disp lay circuit to realize step motor open2loop controlwere introduced. For the controller in this design,the circuit to p roduce pulse and the speed controlwere expatiated emphatically. This system possesses features of lower cost, easier control.Key words: single ch ip; step2motor; open2loop con trol
上传时间： 2013-10-13
上传用户：cicizoe
基于单片机的除尘控制器的设计:介绍通用控制仪的硬件组成和软件设计,阐述了系统的性能指标和功能特点。该产品功能完善,可靠性高,具有很好的应用前景。关键词: 除尘器;通用控制仪;单片机;系统设计 Abstract: The hardware structure and the software design are introduced in this paper, and the performance index and the features of the system are expounded. It has comp rehensive functions, high reliability and good app lication.Key words: dust catcher; universal controller; microcontroller; system design
上传时间： 2013-11-16
上传用户：ming52900
82C59A-2是为简化微处理机系统中断接口而实现的LSI外围芯片。也叫做PIC（Programmable Interrupt Controller）。是高性能高速度芯片。在多级优先级中断系统内82C59A-1402已经把CPU从对任务的轮询中解救出来。PCI可由软件进行控制，使用于各种不同的环境，联级可接受8~64个中断输入。 管脚与NMOS8259A-2兼容单片8级优先级，级联可扩64级多种可编程中断方式各自专用的请求屏蔽能力与Intel系列机兼容全部采用静态设计低功耗5V的电源供电。
上传时间： 2013-10-30
上传用户：zhliu007
