虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Model-<b>VIEW</b>-Control

  • PCA9549 Octal bus switch with

    The PCA9549 provides eight bits of high speed TTL-compatible bus switching controlledby the I2C-bus. The low ON-state resistance of the switch allows connections to be madewith minimal propagation delay. Any individual A to B channel or combination of channelscan be selected via the I2C-bus, determined by the contents of the programmable Controlregister. When the I2C-bus bit is HIGH (logic 1), the switch is on and data can flow fromPort A to Port B, or vice versa. When the I2C-bus bit is LOW (logic 0), the switch is open,creating a high-impedance state between the two ports, which stops the data flow.An active LOW reset input (RESET) allows the PCA9549 to recover from a situationwhere the I2C-bus is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-busstate machine and causes all the bits to be open, as does the internal power-on resetfunction.

    标签: switch Octal 9549 with

    上传时间: 2014-11-22

    上传用户:xcy122677

  • 8051单片机系统扩展与接口技术

    8051单片机系统扩展与接口技术:第一节   8051 单片机系统扩展概述第二节  单片机外部存储器扩展第三节  单片机输入输出(I/O)口扩展及应用第四节   LED显示器接口电路及显示程序第五节  单片机键盘接口技术第六节 单片机与数模(D/A)及模数(A/D)转换1、地址总线(Address Bus,简写为AB)地址总线可传送单片机送出的地址信号,用于访问外部存储器单元或I/O端口。A   地址总线是单向的,地址信号只是由单片机向外发出。B   地址总线的数目决定了可直接访问的存储器单元的数目。例如N位地址,可以产生2N个连续地址编码,因此可访问2N个存储单元,即通常所说的寻址范围为 2N个地址单元。MCS—51单片机有十六位地址线,因此存储器展范围可达216 = 64KB地址单元。C   挂在总线上的器件,只有地址被选中的单元才能与CPU交换数据,其余的都暂时不能操作,否则会引起数据冲突。2、数据总线(Data Bus,简写为DB)数据总线用于在单片机与存储器之间或单片机与I/O端口之间传送数据。A   单片机系统数据总线的位数与单片机处理数据的字长一致。例如MCS—51单片机是8位字长,所以数据总线的位数也是8位。B   数据总线是双向的,即可以进行两个方向的数据传送。3、控制总线(Control Bus,简写为CB)控制总线实际上就是一组控制信号线,包括单片机发出的,以及从其它部件送给单片机的各种控制或联络信号。对于一条控制信号线来说,其传送方向是单向的,但是由不同方向的控制信号线组合的控制总线则表示为双向的。总线结构形式大大减少了单片机系统中连接线的数目,提高了系统的可靠性,增加了系统的灵活性。此外,总线结构也使扩展易于实现,各功能部件只要符合总线规范,就可以很方便地接入系统,实现单片机扩展。

    标签: 8051 单片机 系统扩展 接口技术

    上传时间: 2013-10-18

    上传用户:assef

  • keil使用笔记

    keil 使用笔记:在Memory窗口上输入address_type:address才能看到正确地址的变量debug~perfermance analyzer加入要察看的模块名称,然后view~perfermance analyzer window 可以察看各个模块运行时间①Display address_type:address B:Bit address C:Code Memory Bx:Code Bank D D:80H 命令可以查看特殊寄存器 data D I:0 命令可以查看内部RAM数据iData; D X:0 命令可以查看外部RAM数据xData; ②R1 //显示R1 register ~R1 //显示变量R1 R1 = R7 //对寄存器Rx操作R1 = --R7 R1 = 0x20 ③main //显示main()的开始地址d main //显示main()的代码④向RAM.ROM中写数据Enter data_type address_type:address expr,expr.... data_type:int char double float long E char data:0x20 1,2,3,4 //向data区0x20开始的地址写1,2,3,4 变量放在RAM的30H,要把定义放在main前面!另外特别注意,内部RAM通常供C程序存放中间变量等,所以一定要看看编译后的程序中是否存在存储单元冲突的情况,比如如果程序中 使用了别的寄存器组的话,08-1FH单元就不能用了unsigned long data i _at_ 0x30

    标签: keil 使用笔记

    上传时间: 2013-11-05

    上传用户:dongqiangqiang

  • labview中文教程

    第八章 labview的编程技巧     本章介绍局部变量、全局变量、属性节点和其他一些有助于提高编程技巧的问题,恰当地运用这些技巧可以提高程序的质量。   8.1 局部变量 严格的语法尽管可以保证程序语言的严密性,但有时它也会带来一些使用上的不便。在labview这样的数据流式的语言中,将变量严格地分为控制器(Control)和指示器(Indicator),前者只能向外流出数据,后者只能接受流入的数据,反过来不行。在一般的代码式语言中,情况不是这样的。例如我们有变量a、b和c,只要需要我们可以将a的值赋给b,将b的值赋给c等等。前面所介绍的labview内容中,只有移位积存器即可输入又可输出。另外,一个变量在程序中可能要在多处用到,在图形语言中势必带来过多连线,这也是一件烦人的事。还有其他需要,因此labview引入了局部变量。

    标签: labview 教程

    上传时间: 2013-10-27

    上传用户:xieguodong1234

  • 最新的支持向量机工具箱

    最新的支持向量机工具箱,有了它会很方便 1. Find time to write a proper list of things to do! 2. Documentation. 3. Support Vector Regression. 4. Automated model selection. REFERENCES ========== [1] V.N. Vapnik, "The Nature of Statistical Learning Theory", Springer-Verlag, New York, ISBN 0-387-94559-8, 1995. [2] J. C. Platt, "Fast training of support vector machines using sequential minimal optimization", in Advances in Kernel Methods - Support Vector Learning, (Eds) B. Scholkopf, C. Burges, and A. J. Smola, MIT Press, Cambridge, Massachusetts, chapter 12, pp 185-208, 1999. [3] T. Joachims, "Estimating the Generalization Performance of a SVM Efficiently", LS-8 Report 25, Universitat Dortmund, Fachbereich Informatik, 1999.

    标签: 支持向量机 工具箱

    上传时间: 2013-12-16

    上传用户:亚亚娟娟123

  • This model simulates a CDMA2000 1xRTT Forward link (between Base Station and Mobile Station). In par

    This model simulates a CDMA2000 1xRTT Forward link (between Base Station and Mobile Station). In particular, it simulates the Radio Configuration 3 of a Forward Fundamental channel. The block CDMA2k: Initial settings allows you to set different parameters such as data rate, Power Control SubChannel insertion rate, spreading code index, QOSF index and the channel model.

    标签: Station simulates Forward between

    上传时间: 2015-03-28

    上传用户:13215175592

  • Description: FASBIR(Filtered Attribute Subspace based Bagging with Injected Randomness) is a variant

    Description: FASBIR(Filtered Attribute Subspace based Bagging with Injected Randomness) is a variant of Bagging algorithm, whose purpose is to improve accuracy of local learners, such as kNN, through multi-model perturbing ensemble. Reference: Z.-H. Zhou and Y. Yu. Ensembling local learners through multimodal perturbation. IEEE Transactions on Systems, Man, and Cybernetics - Part B: Cybernetics, 2005, vol.35, no.4, pp.725-735.

    标签: Description Randomness Attribute Filtered

    上传时间: 2015-04-10

    上传用户:ynzfm

  • 一个用MVC模式写出来的贪食蛇小游戏

    一个用MVC模式写出来的贪食蛇小游戏,将Model.View.Control分开,可作为学习MVC的入门。

    标签: MVC 模式 小游戏

    上传时间: 2013-11-30

    上传用户:leixinzhuo

  • by Randal L. Schwartz and Tom Phoenix ISBN 0-596-00132-0 Third Edition, published July 2001. (See

    by Randal L. Schwartz and Tom Phoenix ISBN 0-596-00132-0 Third Edition, published July 2001. (See the catalog page for this book.) the text of Learning Perl, 3rd Edition. Table of Contents Copyright Page Preface Chapter 1: Introduction Chapter 2: Scalar Data Chapter 3: Lists and Arrays Chapter 4: Subroutines Chapter 5: Hashes Chapter 6: I/O Basics Chapter 7: Concepts of Regular Expressions Chapter 8: More About Regular Expressions Chapter 9: Using Regular Expressions Chapter 10: More Control Structures Chapter 11: Filehandles and File Tests Chapter 12: Directory Operations Chapter 13: Manipulating Files and Directories Chapter 14: Process Management Chapter 15: Strings and Sorting Chapter 16: Simple Databases Chapter 17: Some Advanced Perl Techniques Appendix A: Exercise Answers Appendix B: Beyond the Llama Index Colophon

    标签: L. published Schwartz Edition

    上传时间: 2014-11-29

    上传用户:kr770906

  • by Randal L. Schwartz and Tom Phoenix ISBN 0-596-00132-0 Third Edition, published July 2001. (See

    by Randal L. Schwartz and Tom Phoenix ISBN 0-596-00132-0 Third Edition, published July 2001. (See the catalog page for this book.) Learning Perl, 3rd Edition. Table of Contents Copyright Page Preface Chapter 1: Introduction Chapter 2: Scalar Data Chapter 3: Lists and Arrays Chapter 4: Subroutines Chapter 5: Hashes Chapter 6: I/O Basics Chapter 7: Concepts of Regular Expressions Chapter 8: More About Regular Expressions Chapter 9: Using Regular Expressions Chapter 10: More Control Structures Chapter 11: Filehandles and File Tests Chapter 12: Directory Operations Chapter 13: Manipulating Files and Directories Chapter 14: Process Management Chapter 15: Strings and Sorting Chapter 16: Simple Databases Chapter 17: Some Advanced Perl Techniques Appendix A: Exercise Answers Appendix B: Beyond the Llama Index Colophon

    标签: L. published Schwartz Edition

    上传时间: 2015-09-03

    上传用户:lifangyuan12