为提升虚拟仪器传输速率与实时性能，扩展监测范围，在VC的软件平台上设计了一种全功能虚拟示波器。与传统虚拟示波器相比，该系统采用嵌入式系统完成信号采集，采用工业以太网为传输介质，通过线性插值算法和多线程编程思想，实现波形显示、参数计算、频谱分析以及波形存储及回放功能。实验结果表明，该虚拟示波器可以实现20 kHz采样频率下的波形精确显示，达到预期的各项指标。 Abstract: o enhance the transfer rate and real-time of virtual instrument performance， expand scope of monitoring， this paper uses the VCs software platform to design a fully functional virtual oscilloscope. Compared with traditional virtual oscilloscope， this system adopts the embedded system to complete the data acquisition， industrial Ethernet as the transmission medium used by the linear interpolation algorithm and multi-threaded programming ideas， namely to achieve waveform display， parameter calculation， spectrum analysis and waveform storage and playback. Experimental results show that the virtual oscilloscope can accurately display the waveform with 20kHz sampling frequency， and achieve the desired targets.
上传时间： 2013-11-25
上传用户：wbwyl
主要针对货车动态称重系统中大量实时载重数据存取的需求而做的设计。该设计基于ARM9和μC/OS-II相结合的软硬件平台，实现了一种SD卡文件系统。SD卡的接口电路采用SD总线模式连接，软件设计基于嵌入式操作系μC/OS-II ，文件系统的实现参照FAT32规范。实际应用表明，该设计能够满足大量数据的存取效率以及文件管理的技术指标。
上传时间： 2013-11-04
上传用户：rlgl123
针对在51单片机上移植实时操作系统μC/OS-II的目的，以μC/OS-II工作原理为基础，结合51单片机堆栈空间少的情况，采用改变堆栈指针到不同任务寄存器组的方法，通过改变堆栈指针的实验，得出在堆栈空间较少的情况下，也能够实现μC/OS-II在51单片机上的运行的结论。
上传时间： 2013-11-13
上传用户：hz07104032
The use of the Wind River VxWorks Real-Time Operating System (RTOS) on Virtex™-4embedded PowerPC™ processors continues to be a popular choice for high performanceFPGA designs. The introduction of the Wind River Workbench design environment has enableda new and easier way for designers to control the configuration of the VxWorks kernel. Thisguide shows the steps required to build and configure a ML403 Embedded DevelopmentPlatform to boot and run the VxWorks RTOS. A VxWorks bootloader is created, programmedinto Flash, and used to boot the design. The concepts presented here can be scaled to anyPowerPC enabled development platform.
上传时间： 2013-10-26
上传用户：agent
基于Nios-II设计和实现了支持PSTN网络、Internet网络的双网传真机系统，利用FPGA实现了传真机系统的多个电路模块，包括A/D采样控制逻辑、二值化图像处理模块、MH编码模块、MH译码模块和CIS扫描、TPH打印、电机控制模块。基于μC/OS-II、Niche TCP/IP实现了T30协议通信、非实时网络传真通信、Tiff文件创建、Tiff文件解析模块。使用Altera Cyclone EP1C20开发板实现和验证了整机系统，经过软硬件联调，达到了系统设计指标和功能。
上传时间： 2013-11-13
上传用户：xwd2010
Keil C51 V8 专业开发工具（PK51） PK51是为8051系列单片机所设计的开发工具，支持所有8051系列衍生产品，，支持带扩展存储器和扩展指令集（例如Dallas390/5240/400,Philips 51MX,Analog Devices MicroConverters）的新设备,以及支持很多公司的一流的设备和IP内核,比如Analog Devices, Atmel, Cypress Semiconductor, Dallas Semiconductor, Goal, Hynix, Infineon, Intel, NXP(founded by Philips), OKI, Silicon Labs,SMSC, STMicroeleectronics,Synopsis, TDK, Temic, Texas Instruments,Winbond等。 通过PK51专业级开发工具，可以轻松地了解8051的On-chip peripherals与及其它关键特性。 The PK51专业级开发工具包括… l μVision Ø 集成开发环境 Ø 调试器 Ø 软件模拟器 l Keil 8051扩展编译工具 Ø AX51宏汇编程序 Ø ANSI C编译工具 Ø LX51 连接器 Ø OHX51 Object-HEX 转换器 l Keil 8051编译工具 Ø A51宏汇编程序 Ø C51 ANSI C编译工具 Ø BL51 代码库连接器 Ø OHX51 Object-HEX 转换器 Ø OC51 集合目标转换器 l 目标调试器 Ø FlashMON51 目标监控器 Ø MON51目标监控器 Ø MON390 (Dallas 390)目标监控器 Ø MONADI (Analog Devices 812)目标监控器 Ø ISD51 在系统调试 l RTX51微实时内核 你应该考虑PK51开发工具包,如果你… l 需要用8051系列单片机来开发 l 需要开发 Dallas 390 或者 Philips 51MX代码 l 需要用C编写代码 l 需要一个软件模拟器或是没有硬件仿真器 l 需要在单芯片上基于小实时内核创建复杂的应用
上传时间： 2013-10-30
上传用户：yy_cn
The NXP LPC315x combine an 180 MHz ARM926EJ-S CPU core, High-speed USB 2.0OTG, 192 KB SRAM, NAND flash controller, flexible external bus interface, an integratedaudio codec, Li-ion charger, Real-Time Clock (RTC), and a myriad of serial and parallelinterfaces in a single chip targeted at consumer, industrial, medical, and communicationmarkets. To optimize system power consumption, the LPC315x have multiple powerdomains and a very flexible Clock Generation Unit (CGU) that provides dynamic clockgating and scaling.The LPC315x is implemented as multi-chip module with two side-by-side dies, one fordigital fuctions and one for analog functions, which include a Power Supply Unit (PSU),audio codec, RTC, and Li-ion battery charger.
上传时间： 2014-01-17
上传用户：Altman
Abstract: This application note explains how to design an intelligent lighting controller that senses and measures the ambient lightlevel with an ambient light sensor (ALS). Equipped with a real-time clock (RTC), the controller also knows when to turn lighting on oroff at specified times. The system presented in this document can be used to control all luminaires that are mains-supply operated.Controller software is also provided in hex format.
上传时间： 2013-11-18
上传用户：AbuGe
数字运算，判断一个数是否接近素数 A Niven number is a number such that the sum of its digits divides itself. For example, 111 is a Niven number because the sum of its digits is 3, which divides 111. We can also specify a number in another base b, and a number in base b is a Niven number if the sum of its digits divides its value. Given b (2 <= b <= 10) and a number in base b, determine whether it is a Niven number or not. Input Each line of input contains the base b, followed by a string of digits representing a positive integer in that base. There are no leading zeroes. The input is terminated by a line consisting of 0 alone. Output For each case, print "yes" on a line if the given number is a Niven number, and "no" otherwise. Sample Input 10 111 2 110 10 123 6 1000 8 2314 0 Sample Output yes yes no yes no
上传时间： 2015-05-21
上传用户：daguda
Ever wanted to just type tail -f error_log on Windows?Envious of your Unix friends who can track changes to a file, in real time, as they happen? Well, now with the Objektiv Tail for Win32, you ll be happily monitoring your log files like you ve never done before. What s even better, you can track several files all at the same time with the patented "Multiple Document Interface"TM technology, with each file having its own, fabulous window.
标签： error_log Envious Windows friends
上传时间： 2015-05-31
上传用户：rocwangdp
