为满足无线网络技术具有低功耗、节点体积小、网络容量大、网络传输可靠等技术要求，设计了一种以MSP430单片机和CC2420射频收发器组成的无线传感节点。通过分析其节点组成，提出了ZigBee技术中的几种网络拓扑形式，并研究了ZigBee路由算法。针对不同的传输要求形式选用不同的网络拓扑形式可以尽大可能地减少系统成本。同时针对不同网络选用正确的ZigBee路由算法有效地减少了网络能量消耗，提高了系统的可靠性。应用试验表明，采用ZigBee方式通信可以提高传输速率且覆盖范围大，与传统的有线通信方式相比可以节约40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower， small nodes， large capacity and reliable network transmission， wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided network topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different network topologies form can most likely reduce the system cost. And aiming at different network to choose the correct ZigBee routing algorithm can effectively reduced the network energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate， cover more area and reduce 40% cost compared with traditional wired communications mode.
上传时间： 2013-10-09
上传用户：robter
本软件是关于MAX338, MAX339的英文数据手册：MAX338, MAX339 8通道/双4通道、低泄漏、CMOS模拟多路复用器 The MAX338/MAX339 are monolithic, CMOS analog multiplexers (muxes). The 8-channel MAX338 is designed to connect one of eight inputs to a common output by control of a 3-bit binary address. The dual, 4-channel MAX339 is designed to connect one of four inputs to a common output by control of a 2-bit binary address. Both devices can be used as either a mux or a demux. On-resistance is 400Ω max, and the devices conduct current equally well in both directions. These muxes feature extremely low off leakages (less than 20pA at +25°C), and extremely low on-channel leakages (less than 50pA at +25°C). The new design offers guaranteed low charge injection (1.5pC typ) and electrostatic discharge (ESD) protection greater than 2000V, per method 3015.7. These improved muxes are pin-compatible upgrades for the industry-standard DG508A and DG509A. For similar Maxim devices with lower leakage and charge injection but higher on-resistance, see the MAX328 and MAX329.
上传时间： 2013-11-12
上传用户：18711024007
This document was developed under the Standard Hardware and Reliability Program (SHARP) TechnologyIndependent Representation of Electronic Products (TIREP) project. It is intended for use by VHSIC HardwareDescription Language (VHDL) design engineers and is offered as guidance for the development of VHDL modelswhich are compliant with the VHDL Data Item Description (DID DI-EGDS-80811) and which can be providedto manufacturing engineering personnel for the development of production data and the subsequent productionof hardware. Most VHDL modeling performed to date has been concentrated at either the component level orat the conceptual system level. The assembly and sub-assembly levels have been largely disregarded. Under theSHARP TIREP project, an attempt has been made to help close this gap. The TIREP models are based upon lowcomplexity Standard Electronic Modules (SEM) of the format A configuration. Although these modules are quitesimple, it is felt that the lessons learned offer guidance which can readily be applied to a wide range of assemblytypes and complexities.
上传时间： 2013-11-20
上传用户：pzw421125
8051上的CRC8校验 A CCITT-8 CRC calculator. The source contains both the calculated (smaller but slower) version, and the table driven (faster but larger) version.
标签： calculator calculated contains smaller
上传时间： 2013-12-13
上传用户：CSUSheep
Tug of War(A tug of war is to be arranged at the local office picnic. For the tug of war, the picnickers must be divided into two teams. Each person must be on one team or the other the number of people on the two teams must not differ by more than 1 the total weight of the people on each team should be as nearly equal as possible. The first line of input contains n the number of people at the picnic. n lines follow. The first line gives the weight of person 1 the second the weight of person 2 and so on. Each weight is an integer between 1 and 450. There are at most 100 people at the picnic. Your output will be a single line containing 2 numbers: the total weight of the people on one team, and the total weight of the people on the other team. If these numbers differ, give the lesser first. )
上传时间： 2014-01-07
上传用户：离殇
pdnMesh is an automatic mesh generator and solver for Finite Element problems. It will also do post-processing to generate contour plots and Postscript printouts. GUI support using GTK or MFC (Win32) is available. The problem definition can be done in any form and given to pdnMesh as an input data file. Drawing Exchange Format (DXF) files can be directly imported to pdnmesh. The quality and the coarseness of the mesh can be controlled by giving input parameters.
标签： automatic generator problems pdnMesh
上传时间： 2013-12-19
上传用户：cuibaigao
硬件设计vhdl_cpu1,1. You may copy and distribute verbatim copies of this core, as long -- as this file, and the other associated files, remain intact and -- unmodified. Modifications are outlined below.
标签： this distribute vhdl_cpu verbatim
上传时间： 2015-03-20
上传用户：aa17807091
Overview In this chapter I introduce Borland C++Builder (BCB) and explain what it is about. I also devote considerable time to explaining the purpose of this book and the philosophy behind my approach to technical writing. Technical subjects covered in this chapter include Creating a simple Multimedia RAD program that plays movies, WAV files, and MIDI files. Shutting down the BCB RAD programming tools and writing raw Windows API code instead. Creating components dynamically on the heap at runtime. Setting up event handlers (closures) dynamically at runtime. A brief introduction to using exceptions. This topic is covered in more depth in Chapter 5, "Exceptions." A brief introduction to ANSI strings. This subject is covered in more depth in Chapter 3, "C++Builder and the VCL." Using the online help. Greping through the include and source files that come with the product and with this book.
标签： introduce Overview Borland Builder
上传时间： 2014-01-04
上传用户：小鹏
In each step the LZSS algorithm sends either a character or a <position, length> pair. Among these, perhaps character "e" appears more frequently than "x", and a <position, length> pair of length 3 might be commoner than one of length 18, say. Thus, if we encode the more frequent in fewer bits and the less frequent in more bits, the total length of the encoded text will be diminished. This consideration suggests that we use Huffman or arithmetic coding, preferably of adaptive kind, along with LZSS.
标签： algorithm character position either
上传时间： 2014-01-27
上传用户：wang0123456789
This model simulates a CDMA2000 1xRTT Forward link (between Base Station and Mobile Station). In particular, it simulates the Radio Configuration 3 of a Forward Fundamental channel. The block CDMA2k: Initial settings allows you to set different parameters such as data rate, Power Control SubChannel insertion rate, spreading code index, QOSF index and the channel model.
标签： Station simulates Forward between
上传时间： 2015-03-28
上传用户：13215175592
