The LTC®3610 is a high power monolithic synchronousstep-down DC/DC regulator that can deliver up to 12Aof continuous output current from a 4V to 24V (28Vmaximum) input supply. It is a member of a high currentmonolithic regulator family (see Table 1) that featuresintegrated low RDS(ON) N-channel top and bottomMOSFETs. This results in a high effi ciency and highpower density solution with few external components.This regulator family uses a constant on-time valleycurrent mode architecture that is capable of operatingat very low duty cycles at high frequency and with veryfast transient response. All are available in low profi le(0.9mm max) QFN packages.
上传时间： 2013-11-07
上传用户：moerwang
High voltage buck DC/DC controllers such as the LTC3890(dual output) and LTC3891 (single output) are popular inautomotive applications due to their extremely wide 4V to60V input voltage range, eliminating the need for a snubberand voltage suppression circuitry. These controllersare also well suited for 48V telecom applications whereno galvanic isolation is required.
上传时间： 2013-10-31
上传用户：wwwe
A recent trend in the design of portable devices has beento use ceramic capacitors to filter DC/DC converter inputs.Ceramic capacitors are often chosen because of theirsmall size, low equivalent series resistance (ESR) and highRMS current capability. Also, recently, designers havebeen looking to ceramic capacitors due to shortages oftantalum capacitors.
上传时间： 2013-11-05
上传用户：comer1123
The design of battery-powered equipment can often bequite challenging. Since few ICs can operate directly fromthe end-of-life voltage from a 2-cell battery (about 1.8V),most systems require a DC/DCconverter. The systemdesigner often has a limited area in which to place the DC/DC converter; associated inductors and capacitors must be
上传时间： 2013-11-23
上传用户：wys0120
本文着重介绍高效低纹波DC-DC降压稳压器SCY99090的特性、典型应用电路、电路中元器件的选型以及PCB的布局。
上传时间： 2014-12-27
上传用户：swaylong
The XL6003 regulator is fixed frequency PWM Boost (step-up) DC/DC converter, capable ofdriving 1050mA load current with excellent line and load regulation. The regulator is simple to use because it includes internal frequency compensation and a fixed-frequency oscillator so that it requires a minimum number of external components to work. The XL6003 could directly drive 5~10 3W LED units at VIN=12V.
上传时间： 2013-11-07
上传用户：xy@1314
文中设计了以DSP28335为控制核心的风光互补智能发电控制系统。分析了前级DC/DC斩波电路的工作原理并运用了基于改进扰动法的最大功率跟踪策略来实现风光互补系统最大功率的跟踪，采用DSP28335芯片作为控制核心，通过对直流斩波电路的检测与控制来实现对系统最大功率的跟踪和总体控制，并通过系统仿真与实验验证了设计的合理性。
上传时间： 2013-11-16
上传用户：顶得柱
Xilinx FPGAs require at least two power supplies: VCCINTfor core circuitry and VCCO for I/O interface. For the latestXilinx FPGAs, including Virtex-II Pro, Virtex-II and Spartan-3, a third auxiliary supply, VCCAUX may be needed. Inmost cases, VCCAUX can share a power supply with VCCO.The core voltages, VCCINT, for most Xilinx FPGAs, rangefrom 1.2V to 2.5V. Some mature products have 3V, 3.3Vor 5V core voltages. Table 1 shows the core voltagerequirement for most of the FPGA device families. TypicalI/O voltages (VCCO) vary from 1.2V to 3.3V. The auxiliaryvoltage VCCAUX is 2.5V for Virtex-II Pro and Spartan-3, andis 3.3V for Virtex-II.
上传时间： 2013-10-22
上传用户：liu999666
ACPCI系列的产品就是专为工控机和台式机及其他电脑工程项目和测试调试设计的。和计算机的连接接口是通用的PCI接口，ACPCI是南京来可电子根据多年的CAN总线工程应用经验总结而成的，力求在CAN总线的兼容性、稳定性和标准性上做到最好，ACPCI的单通道发送速度最高大于5000帧/秒，单通道接收速度最高大于7000帧/秒。总线2500V DC-DC隔离，总线接口防雷击浪涌保护，配套有免费的测试软件Adawin CANTest，方便对卡和客户的CAN应用系统进行测试。
上传时间： 2013-11-08
上传用户：born2007
特点： • CAN波特率5Kbps～1Mbps，可任意设定； • 发送最高大于3000帧/秒，接收最高大于6000帧/秒； • 隔离电压3000V DC-DC； • UDP方式下每个CAN口支持2个目标IP段，多个用户可同时管理一个CAN设备； • 灵活的CAN报文分帧设置，满足用户各种分包需求。
上传时间： 2013-10-08
上传用户：qilin
