This example describes how to use the ADC and DMA to transfer continuously converted data from ADC to a data buffer. The ADC is configured to converts continuously ADC channel14. Each time an end of conversion occurs the DMA transfers, in circular mode, the converted data from ADC1 DR register to the ADC_ConvertedValue variable. The ADC1 clock is set to 14 MHz.
标签： continuously ADC describes converted
上传时间： 2014-01-03
上传用户：徐孺
This example provides a description of how to use a DMA channel to transfer a word data buffer from memory (Flash) to memory (RAM). The dedicated DMA channel is configured to transfer once a time a 32 word data buffer stored as constant in the Flash memory to another buffer in the RAM memory. The received data are stored in the DST_Buffer. The DMA channel transfer complete interrupt is enabled to generate an interrupt at the end of the buffer transfer. As soon as the transfer is completed an interrupt is generated and in the DMA channel interrupt routine the transfer complete interrupt pending bit is cleared. The data counter is stored before and after the transfer to show that all data has been transfered. TransferStatus gives the data transfer status where it is PASSED if transmitted and received data are the same otherwise it is FAILED
标签： description provides transfer example
上传时间： 2016-04-24
上传用户：ecooo
M-file uses random data which BPSK modulates a carrier to configure a BPSK UWB transmitter. The receiver demodulates the BPSK UWB carrier and the data is recovered
标签： BPSK transmitter configure modulates
上传时间： 2016-04-24
上传用户：haoxiyizhong
The data for AVR DSP MCU reference
上传时间： 2016-04-25
上传用户：sammi
usb bulk 传输例程。 * The bulkusb driver is a generic function driver, based on the Windows Driver Model (WDM). * Supports Plug and Play(PnP), Power Management(PM), Windows Management Instrumentation (WMI) and the Selective Suspend (SS) features. * This sample is based off the selSusp DDK sample. Please refer the selSusp sample and the DDK docs to understand the handling of PnP, PM, WMI and SS features and implementations. * The USB device used for this sample is a generic Intel I82930 USB evaluation board programmed with a simple loopback test using a 64 KB circular buffer. None of the code in the sample is specific to this controller chip.
标签： driver function Windows bulkusb
上传时间： 2016-04-25
上传用户：270189020
OFDM systems based on MATLAB simulation program
标签： simulation systems program MATLAB
上传时间： 2016-04-26
上传用户：kristycreasy
Different methods for generating pyramid data structure have been analysed, these effects in image matching are compared, also a fast
标签： generating Different structure analysed
上传时间： 2016-04-26
上传用户：LIKE
Different methods for generating pyramid data structure have been analysed, thesea fast algorithm of pyramid data struct is provided.
标签： generating Different algorithm structure
上传时间： 2013-12-17
上传用户：SimonQQ
基于串口的手机短信程序--- --SMS based on the serial port procedures
标签： procedures serial based port
上传时间： 2016-04-26
上传用户：lmeeworm
NRF905驱动代码 // The content of this struct is nRF905 s initialize data. // CH_NO=1 433MHZ Normal Opration,No Retrans RX,TX Address is 4 Bytes // RX TX Payload Width is 32 Bytes Disable Extern Clock Fosc=16MHZ // 8 Bits CRC And enable
标签： initialize 905 content Normal
上传时间： 2013-12-16
上传用户：lanjisu111
