89S51 与数码管显示器以及键盘SW 对应引脚的联机为： P0.0-------------------------数码管显示器的a脚 P0.1-------------------------数码管显示器的b脚 P0.2-------------------------数码管显示器的c脚 P0.3-------------------------数码管显示器的d脚 P0.4-------------------------数码管显示器的e脚 P0.5-------------------------数码管显示器的f脚 P0.6-------------------------数码管显示器的g脚 P0.7-------------------------数码管显示器的dp脚 ； P2.2-------------------------数码管显示器1的驱动脚 P2.3-------------------------数码管显示器2的驱动脚 P2.4-------------------------数码管显示器3的驱动脚 P2.5-------------------------数码管显示器4的驱动脚 P2.6-------------------------数码管显示器5的驱动脚 P2.7-------------------------数码管显示器6的驱动脚 ； P2.2-------------------------键盘SW1 P2.3-------------------------键盘SW2 P2.4-------------------------键盘SW3 P2.5-------------------------键盘SW4 P2.6-------------------------键盘SW5 P2.7-------------------------键盘SW6
上传时间： 2013-12-29
上传用户：1583060504
The decoding algorithm used in RBDS.c is based on error trapping. The program emulates the operation of the encoder and decoder of a binary cyclic codes, using bitwise shifts and xor for modulo g(x) operations.
标签： The algorithm operation decoding
上传时间： 2015-07-05
上传用户：youmo81
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
标签： the 20060125 project WinAVR
上传时间： 2014-10-10
上传用户：yan2267246
crc任意位生成多项式 任意位运算 自适应算法 循环冗余校验码(CRC，Cyclic Redundancy Code)是采用多项式的 编码方式，这种方法把要发送的数据看成是一个多项式的系数 ，数据为bn-1bn-2…b1b0 (其中为0或1)，则其对应的多项式为： bn-1Xn-1+bn-2Xn-2+…+b１X+b０ 例如：数据“10010101”可以写为多项式 X７+X４+X２+1。 循环冗余校验CRC 循环冗余校验方法的原理如下： (1) 设要发送的数据对应的多项式为P(x)。 (2) 发送方和接收方约定一个生成多项式G(x)，设该生成多项式 的最高次幂为r。 (3) 在数据块的末尾添加r个0，则其相对应的多项式为M(x)=XrP(x) 。(左移r位) (4) 用M(x)除以G(x)，获得商Q(x)和余式R(x)，则 M(x)=Q(x) ×G(x)+R(x)。 (5) 令T(x)=M(x)+R(x)，采用模2运算，T(x)所对应的数据是在原数 据块的末尾加上余式所对应的数据得到的。 (6) 发送T(x)所对应的数据。 (7) 设接收端接收到的数据对应的多项式为T’(x)，将T’(x)除以G(x) ，若余式为0，则认为没有错误，否则认为有错。
上传时间： 2014-11-28
上传用户：宋桃子
All 3G and GSM specifications have a 3GPP specification number consisting of 4 or 5 digits. (e.g. 09.02 or 29.002). The first two digits define the series as listed in the table below. They are followed by 2 further digits for the 01 to 13 series or 3 further digits for the 21 to 55 series. The term "3G" means a 3GPP system using a UTRAN radio access network the term "GSM" means a 3GPP system using a GERAN radio access network. (Thus "GSM" includes GPRS and EDGE features.)
标签： e.g. specifications specification consisting
上传时间： 2015-08-11
上传用户：yoleeson
The book "The Finite Difference Time Domain for Electromagnetics" by Karl Kunz and Raymond Luebbers, CRC Press, 1993, contains an FDTD code and output files in Appendix B. The same code and output files are contained in this directory.
标签： Electromagnetics Difference The Luebbers
上传时间： 2013-12-29
上传用户：chongcongying
/* * EULER S ALGORITHM 5.1 * * TO APPROXIMATE THE SOLUTION OF THE INITIAL VALUE PROBLEM: * Y = F(T,Y), A<=T<=B, Y(A) = ALPHA, * AT N+1 EQUALLY SPACED POINTS IN THE INTERVAL [A,B]. * * INPUT: ENDPOINTS A,B INITIAL CONDITION ALPHA INTEGER N. * * OUTPUT: APPROXIMATION W TO Y AT THE (N+1) VALUES OF T. */
标签： APPROXIMATE ALGORITHM THE SOLUTION
上传时间： 2015-08-20
上传用户：zhangliming420
/*** *** *** *** *** *** *** *** *** *** *** *** **/ //**此映射表用来映射LED模块不译码时，显示的字符和必须输入的数据的关系 //**每段和对应比特位的关系见示意图 // g // --- --- // b | a |f | | <---显示0时点亮的段为gfedcb // --- // c | |e | | 那么写入数据为0x7e // --- --- // d // bit: 7 6 5 4 3 2 1 0 // 段位： g f e d c b a
上传时间： 2013-11-25
上传用户：
Digital Thermostat with High Accuracy -6,00 to 46,00 °C Digital Thermostat We build a digital thermostat for home applications, which controls the room temperature. I used the AT90S2313 microprocessor of ATMEL. The digital thermostat opens the main heating valve of the apartment and the hot water flows in the radiators. Digital Thermostat Board
标签： Thermostat Digital Accuracy digital
上传时间： 2014-01-18
上传用户：D&L37
This book presents an insightful view of XML that places this emerging technology in the context of the ongoing Web revolution. Written for business and technical professionals, this book revals the true value of XML for distributed information systems. It explains how XML is transforming the way organizations manage data and build software systems details the opportunities the language offers for organizatoins that understand tis significance and potential impact and explains how XML and Web services reflect a fundamental shift in software construction-from monolithic applications to software based on the composition of simple parts.
标签： insightful technology presents emerging
上传时间： 2015-09-24
上传用户：思琦琦
