PCI设计指南The Xilinx LogiCORE PCI interface is a fully verified, pre-implemented PCI Bus interface. This interface is available in 32-bit and 64- bit versions, with support for multiple Xilinx FPGA device families. It is designed to support both Verilog-HDL and VHDL. The design examples in this book are provided in Verilog.
标签： interface PCI pre-implemented LogiCORE
上传时间： 2016-04-03
上传用户：清风冷雨
英飞凌16位单片机xc167选型指南The XC167CI is a new derivative of the popular C166 microcontroller family that is based on the enhanced C166S V2 architecture it outperforms existing 16-bit solutions.
标签： microcontroller derivative 167 popular
上传时间： 2013-12-27
上传用户：坏天使kk
mips命令集详解，the mips32 instruction set and instruction bit encodings
上传时间： 2016-04-23
上传用户：Miyuki
This example provides a description of how to use a DMA channel to transfer a word data buffer from memory (Flash) to memory (RAM). The dedicated DMA channel is configured to transfer once a time a 32 word data buffer stored as constant in the Flash memory to another buffer in the RAM memory. The received data are stored in the DST_Buffer. The DMA channel transfer complete interrupt is enabled to generate an interrupt at the end of the buffer transfer. As soon as the transfer is completed an interrupt is generated and in the DMA channel interrupt routine the transfer complete interrupt pending bit is cleared. The data counter is stored before and after the transfer to show that all data has been transfered. TransferStatus gives the data transfer status where it is PASSED if transmitted and received data are the same otherwise it is FAILED
标签： description provides transfer example
上传时间： 2016-04-24
上传用户：ecooo
12864液晶原程序.#include <reg52.h> #include <intrins.h> typedef unsigned char BYTE typedef bit BOOL sbit rs=P2^0 sbit rw=P2^1 sbit e =P2^2 BYTE code dis[]={"www.zansi.com"} delay(BYTE ms) {
标签： include unsigned intrins typedef
上传时间： 2016-04-25
上传用户：zsjinju
vhdl编写，8b—10b 编解码器设计 Encoder: 8b/10b Encoder (file: 8b10b_enc.vhd) Synchronous clocked inputs (latched on each clock rising edge) 8-bit parallel unencoded data input KI input selects data or control encoding Asynchronous active high reset initializes all logic Encoded data output 10-bit parallel encoded output valid 1 clock later Decoder: 8b/10b Decoder (file: 8b10b_dec.vhd) Synchronous clocked inputs (latched on each clock rising edge) 10-bit parallel encoded data input Asynchronous active high reset initializes all logic Decoded data, disparity and KO outputs 8-bit parallel unencoded output valid 1 clock later
上传时间： 2016-05-05
上传用户：gundamwzc
I ve written some many years ago dynamic Huffman algorithm to compress and decompress data. It is mainly targeted to data with some symbols occuring more often than the rest (e.g. having some data file consisted of 3 different symbols and their total number of occurence in that file s1(1000), s2(200), s3(30) so the total length of file is 1000+200+30=1230 bytes, it will be encoded assigning one bit to s1 and 2 bits to s2, s3 so the encoded length will be 1*1000+2*(200+30)=1460 bits=182 bytes). In the best case the file consisted of just one symbol will be encoded with compression ratio as 1:8. Huffman coding is used in image compression, however in JPEG2000 arithmetic codec is imployed.
标签： decompress algorithm compress Huffman
上传时间： 2016-05-16
上传用户：aysyzxzm
The DiskPerf filter driver monitors disk-accesses, capturing performance data. It supports Plug and Play, Power Management, and WMI . It is not 64-bit compliant
标签： disk-accesses performance capturing DiskPerf
上传时间： 2013-12-23
上传用户：agent
Addfilter is a command-line application which adds and removes filter drivers for a given drive or volume. It is intended to demonstrate how to insert a filter driver into the driver stack of a device. The sample illustrates how to do this by using the SetupDi APIs. The sample works on the x86 platform. It has only been tested in a 32-bit environment. Since Addfilter is not a driver, it does not deal with Plug and Play or Power Management.
标签： command-line application Addfilter drivers
上传时间： 2016-05-17
上传用户：xzt
The CD Audio sample allows some non-SCSI2 CD ROMs to support audio operations by intercepting the relevant audio ioctls and translating them into the command block(s) expected by the non-compliant cdroms. It supports Plug and Play and Power Management, and is 64-bit compliant.
标签： intercepting operations non-SCSI support
上传时间： 2016-05-17
上传用户：ANRAN
