this file contains schematic for smart battery charger
标签： schematic contains battery charger
上传时间： 2013-12-25
上传用户：电子世界
evc4 console app that monitors battery status and writes a csv log file and broadcasts every measurement. Use netcat on network to capture the measurements.
标签： broadcasts and monitors console
上传时间： 2017-08-07
上传用户：xiaodu1124
DS2438 one wire (ow) battery monitor code for renesas M16c... (-:cool:-)
标签： battery monitor renesas 2438
上传时间： 2017-08-10
上传用户：Avoid98
DESCRIPTION The Texas Instruments MSP430 family of ultra-low-power microcontrollers consists of several devices featuring different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes, is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1 μs. The MSP430G2x13 and MSP430G2x53 series are ultra-low-power mixed signal microcontrollers with built-in 16- bit timers, up to 24 I/O capacitive-touch enabled pins, a versatile analog comparator, and built-in communication capability using the universal serial communication interface. In addition the MSP430G2x53 family members have a 10-bit analog-to-digital (A/D) converter. For configuration details see Table 1. Typical applications include low-cost sensor systems that capture analog signals, convert them to digital values, and then process the data for display or for transmission to a host system.
上传时间： 2018-12-25
上传用户：ygyh
Battery systems for energy storage are among the most relevant technologies of the 21 st century. They – in particular modern lithium-ion batteries (LIB) – are enablers for the market success of electric vehicles (EV) as well as for stationary energy storage solutions for balancing fluctuations in electricity grids resulting from the integrationofrenewableenergysourceswithvolatilesupply 1 .BothEVandstationary storage solutions are important because they foster the transition from the usage of fossil energy carriers towards cleaner renewable energy sources. Furthermore, EV cause less local air pollution and noise emissions compared to conventional combustion engine vehicles resulting in better air quality especially in urban areas. Unfortunately, to this day, various technological and economic challenges impede a broad application of batteries for EV as well as for large scale energy storage and load leveling in electricity grids.
标签： Multiscale Simulation Approach
上传时间： 2020-06-07
上传用户：shancjb
The PW4055 is a complete constant-current /constant-voltage linear charger for single cell lithiumion batteries.Its ThinSOT package and low external component count make the PW4055 ideallysuited for portable applications.Furthermore, the PW4055 is specifically designed to work within USBpower specifications.The PW4055 No external sense resistor is needed, and no blocking diode is required due to theinternal MOSFET architecture.Thermal feedback regulates the charge current to limit the dietemperature during high power operation or high ambient temperature. The charge voltage is fixedat 4.2V, and the charge current can be programmed externally with a single resistor. The PW4055automatically terminates the charge cycle when the charge current drops to 1/10th the programmedvalue after the final float voltage is reached. When the input supply (wall adapter or USB supply) isremoved, the PW4055 automatically enters a low current state, dropping the battery drain currentto less than 2µA. The PW4055 can be put into shutdown mode, reducing the supply current to 25µA.The BAT pin has a 7KV ESD(HBM) capability. Other features include charge current monitor, undervoltage lockout, automatic recharge and a status pin to indicate charge termination and the presenceof an input voltage
标签： pw4055
上传时间： 2022-02-11
上传用户：jason_vip1
The OCP3601 is a boost topology switching regulator control IC for battery-used applications fiel
标签： Controller Step-Up 3601 DCDC
上传时间： 2013-06-11
上传用户：2780285129
The trend in ADCs and DACs is toward higher speeds and higher resolutions atreduced power levels. Modern data converters generally operate on ±5V (dualsupply) or +5V (single supply). In fact, many new converters operate on a single +3Vsupply. This trend has created a number of design and applications problems whichwere much less important in earlier data converters, where ±15V supplies and ±10Vinput ranges were the standard.
上传时间： 2013-11-16
上传用户：sjw920325
Photodiodes can be broken into two categories: largearea photodiodes with their attendant high capacitance(30pF to 3000pF) and smaller area photodiodes withrelatively low capacitance (10pF or less). For optimalsignal-to-noise performance, a transimpedance amplifi erconsisting of an inverting op amp and a feedback resistoris most commonly used to convert the photodiode currentinto voltage. In low noise amplifi er design, large areaphotodiode amplifi ers require more attention to reducingop amp input voltage noise, while small area photodiodeamplifi ers require more attention to reducing op amp inputcurrent noise and parasitic capacitances.
上传时间： 2013-10-28
上传用户：hanbeidang
This application note features 8-, 10-, and 12-bit dataacquisition components in various circuit configurations.The circuits include battery monitoring, temperature sensing,isolated serial interfaces, and microprocessor andmicrocontroller serial and parallel interfaces. Also includedare voltage reference circuits (Application Note 42contains more voltage reference circuits).
上传时间： 2014-01-15
上传用户：zq70996813
