设计了水声信号发生系统中的功率放大电路，可将前级电路产生的方波信号转换为正弦信号，同时进行滤波、功率放大，使其满足换能器对输入信号的要求。该电路以单片机AT89C52，集成6阶巴特沃思低通滤波芯片MF6以及大功率运算放大器LM12为核心，通过标准RS232接口与PC进行通信，实现信号增益的程控调节，对干扰信号具有良好的抑制作用。经调试该电路工作稳定正常，输出波形无失真，在输出功率以及放大增益、波纹系数等方面均满足设计要求。 This paper presented a design and implementation of underwater Acoustic power amplifer. This circuit converted the rectangle signal generated by frontend circuit into the sine signal， then filtered and power amplification， it meets the requirements of the transducer.Included AT89C52， 6th order Butterworth filter MF6， hipower amplififier LM12.Communication with PC through the RS232 port. The signal gain is adjustable and could be remote controlled. It has a good inhibitory effect on the interference signal. After debugged， this circuit works stable， the output waveform has no distortion， it meets the design requirement in outprt power， amplifier gain and ripple factor.
上传时间： 2013-11-20
上传用户：qwe1234
利用EZ-USB接口芯片AN2131Q实现了基于TMS320C5409的水声信号采集及混沌特性研究系统中的高速数据通信，提出了一种采用FIFO缓存芯片实现AN2131Q与TMS320C5409的连接方法，深入研究了EZ-USB序列接口芯片的固件、设备驱动和用户程序开发过程。关键词：AN2131Q; TMS320C5409; IDT72V02；数据通信ABSTRACT: Using AN2131Q as the control chip, the communication between DSP and PC in the underwater Acoustic signal acquisition and chaotic characteristics study system is realized. The method is proposed that using FIFO to realize the connectivity between AN2131Q and TMS320C5409. The development of programming Firmware、device driver and user application are thoroughly researched.Key words: AN2131Q; TMS320C5409; IDT72V02; data communication
上传时间： 2014-04-03
上传用户：hahayou
This project aim was to build wireless software modem for data communication between two computers using an Acoustic interface in the voice frequency range (20Hz– 20,000Hz). The transmitting antenna is a speaker (frequency response of: 90Hz – 20,000Hz) and the receiving antenna is a microphone (frequency response of: 100Hz – 16,000Hz). The test files used as information files were text files. This goal was attained both in an incoherent scheme and in a coherent scheme. Build under Matlab code, our modem uses OFDM (orthogonal frequency division multiplexing) modulation, synchronization by LMS sequence, channel estimation (no equalizer) via pilot tones. The symbols are either PSK or ASK for a constellation size of 2 or 4. To optimize the probability of error, these symbols were mapped using Gray mapping. Report
标签： communication computers software wireless
上传时间： 2014-05-29
上传用户：wangdean1101
* Acousticfeatures.m: Matlab script to generate training and testing files from event timeseries. * afm_mlpatterngen.m: Matlab script to extract feature information from Acoustic event timeseries. * extractevents.m: Matlab script to extract event timeseries using the complete run timeseries and the ground truth/label information. * extractfeatures.m: Matlab script to extract feature information from all Acoustic and seismic event timeseries for a given run and set of nodes. * sfm_mlpatterngen.m: Matlab script to extract feature information from esmic event timeseries. * ml_train1.m: Matlab script implementation of the Maximum Likelihood Training Module. ?ml_test1.m: Matlab script implementation of the Maximum Likelihood Testing Module. ?knn.m: Matlab script implementation of the k-Nearest Neighbor Classifier Module.
标签： Acousticfeatures timeseries generate training
上传时间： 2013-12-25
上传用户：牛布牛
Commercially available active noise control headphones rely on fixed analog controllers to drive "anti-noise" loudspeakers. Our design uses an adaptive controller to optimally cancel unwanted Acoustic noise. This headphone would be particularly useful for workers who operate or work near heavy machinery and engines because the noise is selectively eliminated. Desired sounds, such as speech and warning signals, are left to be heard clearly. The adaptive control algorithm is implemented on a Texas Instruments (TI™ ) 1 TMS320C30GEL digital signal processor (DSP), which drives a Sony CD550 headphone/microphone system. Our experiments indicate that adaptive noise control results in a dramatic improvement in performance over fixed noise control. This improvement is due to the availability of high-performance programmable DSPs and the self-optimizing and tracking capabilities of the adaptive controller in response to the surrounding noise.
标签： Commercially controllers headphones available
上传时间： 2013-12-04
上传用户：dyctj
We consider the problem of target localization by a network of passive sensors. When an unknown target emits an Acoustic or a radio signal, its position can be localized with multiple sensors using the time difference of arrival (TDOA) information. In this paper, we consider the maximum likelihood formulation of this target localization problem and provide efficient convex relaxations for this nonconvex optimization problem.We also propose a formulation for robust target localization in the presence of sensor location errors. Two Cramer-Rao bounds are derived corresponding to situations with and without sensor node location errors. Simulation results confirm the efficiency and superior performance of the convex relaxation approach as compared to the existing least squares based approach when large sensor node location errors are present.
标签： 传感器网络
上传时间： 2016-11-27
上传用户：xxmluo
One of the prerequisites for the development of telecommunication services is the understanding of the propagation of the waves, either Acoustic, electromagnetic, radio or light waves, which are used for the transmission of information. In this work, we shall limit ourselves to the study of radio waves: this term apply to the electromagnetic waves used in radio communications. Their frequency spectrum is very broad, and is divided into the following frequency bands : ELF waves (f < 3 kHz), VLF (3-30 kHz), LF waves (30-300 kHz), MF waves (300-3000 kHz), HF (3-30 MHz), VHF waves (30-300 MHz), UHF waves (300-3000 MHz), SHF waves (3-30 GHz), EHF waves (30-300 GHz) and sub- EHF waves (300-3000 GHz).
标签： Propagation Radio Wave
上传时间： 2020-05-31
上传用户：shancjb
Over many years, RF-MEMS have been a hot topic in research at the technology and device level. In particular, various kinds of mechanical Si-MEMS resonators and piezoelectric BAW (bulk Acoustic wave) resonators have been developed. The BAW technology has made its way to commercial products for passive RF filters, in particular for duplexers in RF transceiver front ends for cellular communica- tions. Beyond their use in filters, micromachined resonators can also be used in conjunction with active devices in innovative circuits and architectures.
标签： MEMS-based Circuits Systems and
上传时间： 2020-06-06
上传用户：shancjb
