虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

A<b>dc</b>

  • 基于 Ma t l a b语言的遗传算法工具箱支持二进制和浮点数编码方式

    基于 Ma t l a b语言的遗传算法工具箱支持二进制和浮点数编码方式, 并且提供了多种选择、 交叉、 变异的方法。 通过具体实例对 Ma t l a b的遗传 算法工具箱的用法进行 了说 明介绍.

    标签: Ma 语言 算法 工具箱

    上传时间: 2017-09-05

    上传用户:671145514

  • To use this function just define a variable say var, var = pnseq(a, b, c) for a, b and c refe

    To use this function just define a variable say var, var = pnseq(a, b, c) for a, b and c refer to the zip file

    标签: var function variable define

    上传时间: 2014-01-06

    上传用户:zhuoying119

  • 该程序是用来计算互联发电系统的可靠性。该系统是由两个发电系统A、B

    该程序是用来计算互联发电系统的可靠性。该系统是由两个发电系统A、B,经两台变压器和两条并联输电线路连结在一起

    标签: 发电系统 程序 互联 可靠性

    上传时间: 2017-09-11

    上传用户:saharawalker

  • m a t l a b 编 程 实 例!

    m a t l a b 编 程 实 例!

    标签:

    上传时间: 2013-12-21

    上传用户:skfreeman

  • 该程序用事件管理器B的定时器4定时时间来触发A/D采样的启动。采样时采用级联模式

    该程序用事件管理器B的定时器4定时时间来触发A/D采样的启动。采样时采用级联模式,一次做16个转换,转换通道分别是0~15。转换完成后,在A/D中断服务子程序中将转换结果读出。该程序做一次A/D采样。

    标签: 采样 程序 定时器 定时

    上传时间: 2017-09-25

    上传用户:标点符号

  • A B AB D类音频功率放大器简介

    该文档为A、B、AB、D类音频功率放大器简介文档,是一份很不错的参考资料,具有较高参考价值,感兴趣的可以下载看看………………

    标签: ab 音频 功率放大器

    上传时间: 2021-11-28

    上传用户:qdxqdxqdxqdx

  • B型剩余电流保护器设计

    随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.

    标签: 电流保护器

    上传时间: 2022-03-27

    上传用户:

  • j1939 附录a附录b

    j1939 附录a附录b

    标签: j1939

    上传时间: 2022-06-09

    上传用户:

  • 基于单片机的数字化B超键盘设计

    针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS,提出一种PS2键盘的设计方法。基于W78E052D单片机,采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路,电位器位置信息以键盘扫描码序列形式发送,正交编码器信号通过XC9536XL转换为单片机可接收的中断信号,软件接收到中断信息后等效处理成按键。结果表明,在满足开机可设置BIOS同时,又可实现超声特有功能,不需要专门设计驱动程序,接口简单,成本低。 Abstract:  Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot, this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller,designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter, potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU, software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot, ultrasound specific functionality can be achieved at the same time, it does not require specially designed driver,the interface is simple and low cost.    

    标签: 单片机 B超 数字化 键盘设计

    上传时间: 2013-10-10

    上传用户:asdfasdfd

  • 提出了一种基于样本的分级检索 MPEG 视频的新方法:首先用I 帧的dct_dc_size 字段快速粗检,然后用断层摄影(tomography)法分析B 帧运动矢 量的时空分布特性以进一步缩小结果

    提出了一种基于样本的分级检索 MPEG 视频的新方法:首先用I 帧的dct_dc_size 字段快速粗检,然后用断层摄影(tomography)法分析B 帧运动矢 量的时空分布特性以进一步缩小结果集,最后用DC 图像的精确匹配方法验证检索结果.试验结果表明,本方法 所需计算量较小,且可保证较高的检索精度.

    标签: dct_dc_size tomography MPEG

    上传时间: 2013-12-30

    上传用户:独孤求源