One of the fi rst lessons in a basic electronics coursecovers the symbols for resistors, capacitors, inductors,voltage sources and current sources. Althougheach symbol represents a functional component of areal-world circuit, only some of the symbols have directphysical counterparts. For instance, the three discretepassive devices—resistors, capacitors, inductors—canbe picked off a shelf and placed on a real board muchas their symbolic analogs appear in a basic schematic.Likewise, while voltage sources have no direct 2-terminalanalog, a voltage source can be easily built with an offthe-shelf linear regulator.
上传时间： 2013-11-24
上传用户：simonpeng
An essential component of a noise-free audio device isa clean power supply, but few switching regulators canoperate at high efficiency while keeping the switchingfrequency out of the audio band. The LTC®3620 fills thisvoid. It is a high efficiency 15mA buck regulator with aprogrammable minimum switching frequency, making itpossible to virtually eliminate audible switching noise. Theinternal synchronous switches and low quiescent currentof this buck regulator provide the ability to maintain highefficiency, while its small footprint makes it ideal for tiny,low power audio applications.
上传时间： 2013-10-21
上传用户：非衣2016
数字电压表是大学物理教学和实验中的重要仪表，其数字化是指将连续的模拟电压量转换成不连续、离散的数字量并加以显示。传统的实验用模拟电压表功能单一、精度低、体积大，且存在读数时的视差，长时间连续使用易引起视觉疲劳，使用中存在诸多不便。而目前数字万用表的内部核心多是模/数转换器，其精度很大程度上限制了整个表的准确度，可靠性较差。
上传时间： 2013-10-16
上传用户：牛津鞋
Photomultipliers (PMT), avalanche photodiodes (APD),ultrasonic transducers, capacitance microphones, radiationdetectors and similar devices require high voltage,low current bias. Additionally, the high voltage must bepristinely free of noise; well under a millivolt is a commonrequirement with a few hundred microvolts sometimesnecessary. Normally, switching regulator confi gurationscannot achieve this performance level without employingspecial techniques. One aid to achieving low noise is thatload currents rarely exceed 5mA. This freedom permitsoutput fi ltering methods that are usually impractical
上传时间： 2013-10-28
上传用户：lhw888
The design of battery-powered equipment can often bequite challenging. Since few ICs can operate directly fromthe end-of-life voltage from a 2-cell battery (about 1.8V),most systems require a DC/DCconverter. The systemdesigner often has a limited area in which to place the DC/DC converter; associated inductors and capacitors must be
上传时间： 2013-11-23
上传用户：wys0120
电源待机能耗规范术语解释： 静态待机模式是指产品被关闭不执行任何常规功能但仍然与电源连接的空载状态,此时仅为低功耗微控制器和唤醒电路供电。比如有唤醒功能的电脑等电子产品，该微功耗电源在静态待机状态下功耗小于6mW，比能源之星静态待机功耗2.0和EuP标(300mW)还要低50倍，这么低的静态待机功耗世界无与伦比。 动态待机模式是指产品在开启并处于执行常规功能时的状态,此时为主IC控制器、接收器和开关机驱动电路供电。比如有遥控功能的电视机等电子产品，该微功耗电源在动态待机状态下功耗小于50mW，比能源之星静态待机功耗2.0和EuP标(300mW)还要低6倍，这么低的动态待机功耗世界无与伦比。
上传时间： 2013-11-25
上传用户：asasasas
说明：单排直插（SIP）封装或双排直插DIP（封装）,任意值电压输入转换出任意值电压输出，精度为±2%或±3%.简说：DC/DC定电压隔离双隔离（输入/输出隔离、两路输出之间也隔离,双输出,两路正压或两路负压及或一正一负）转换器,输出共同一地线,瞬变响应快,极低纹波噪声输出，无需任何外围元件即可工作，脚位采用7PIN单列,14PIN双列直插，小型封装。应用：便携仪表,医学仪表,自控装置,防盗报警器,手持仪表,通讯设备等数字电路。
上传时间： 2013-10-31
上传用户：qq527891923
LY6206系列是一款高精度,低功耗,3引脚LDO高电压调整器芯片,并采用CMOS工艺和激光微调技术. 在输出电流较大的情况下,输入输出压差也能很小。 LY6206系列芯片内部包括一个电流限制电路,一个驱动三极管,一个高精度参考电压源和一个误差校正电路,可使用低ESR陶瓷电容.电流限制器的foldback电路可为电流限制器和输出引脚提供短路保护。通过激光微调技术,可设定芯片的输出电压,其范围是1.2V至5.0V,间隔100mV,输出电压1.2V-3.6V封装SOT23-3/SOT23-5/SOT89-3
上传时间： 2013-11-15
上传用户：thuyenvinh
这个模块可以被看作是一个USB2.0协议的转换器，将电脑的USB2.0接口转换为一个透明的并行总线，就象单片机总线一样。从而几天之内就可以完成USB2.0产品的设计。
上传时间： 2013-11-01
上传用户：shaoyun666
基于STC89C51与AD转换器ADC0809芯片，可以测量8路 0--5V的电压值，并在四位LED数码管上轮流显示或单路选择显示。 原理图+源程序。
上传时间： 2013-11-07
上传用户：peterli123456
