虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

温度数据采集系统

  • DS18B20的单线多点温度数据采集与传输系统设计

    多点测温

    标签: 18B B20 DS 18

    上传时间: 2013-10-26

    上传用户:wushengwu

  • 基于单片机控制的高精度多点温度检测显示系统

    基于单片机控制的高精度多点温度检测显示系统

    标签: 单片机控制 高精度 多点 温度检测

    上传时间: 2013-10-30

    上传用户:dick_sh

  • STC12系列单片机与PC机在数据采集系

    STC12系列单片机与PC机在数据采集系

    标签: STC 12 PC机 单片机

    上传时间: 2013-11-03

    上传用户:shirleyYim

  • 基于STC12C5A60S2与AD620的小信号采集系统

        在测控领域中,经常遇到监测对象输出信号较小,难以直接采集,一般都需要将其放大后再做处理。介绍了一种小信号采集系统的实现方法,利用具有A/D转换功能的单片机STC25A60S2和具有精确放大功能的易用放大器AD620实现了最小系统,并论述了系统设计与实现,详细介绍了采集小信号的过程,并给出了实际应用的例子,以及小信号采集在相关领域的应用。

    标签: STC 12C A60 60S

    上传时间: 2014-01-03

    上传用户:xuanjie

  • 基于FPGA和面阵CCD摄像头的动态光谱数据采集与预处理

    于FPGA和面阵CCD摄像头的动态光谱数据采集与预处理

    标签: FPGA CCD 面阵 摄像头

    上传时间: 2013-10-16

    上传用户:dongqiangqiang

  • 基于单片机的多路数据采集系统设计毕业论文

    基于单片机的多路数据采集系统

    标签: 单片机 多路数据采集 系统设计 毕业论文

    上传时间: 2014-12-26

    上传用户:龙飞艇

  • 基于C8051F020和Zigbee的汽车测试系统设计

    以C8051F020为核心处理器,设计无线传感器网络数据采集系统。系统采用SZ05-ADV型无线通讯模块组建Zigbee无线网络,结合嵌入式系统的软硬件技术,完成终端节点的8路传感器信号的数据采集。现场8路信号通过前端处理后,分别送入C8051F020的12位A/D转换器进行转换。经过精确处理、存储后的现场数据,通过Zigbee无线网络传送到上位机,系统可达到汽车试验中无线测试的目的。 Abstract:  This paper designs a wireless sensor network system for data acquisition with C8051F020 as core processors.The system used SZ05-ADV wireless communication module,set up a Zigbee wireless network, combined with hardware and software technologies of embedded systems,completed the end-node 8-locale sensor signal data acquisition.Eight locale signals were sent separately into the 12-bit ADC of C8051F020 for conversion through front treatment.After accurate processing and storage,the locale data was transmitted to the host computer through Zigbee wireless.The system achieves the purpose of wireless testing in vehicle trial.

    标签: C8051F020 Zigbee 汽车测试 系统设计

    上传时间: 2013-11-23

    上传用户:dsgkjgkjg

  • MCS-51单片机系统扩展

    数据存储器的扩展 MCS-51单片机内部有128或256个字节的数据存储器,这些存储器通常被用作工作寄存器、堆栈、临时变量等等,一般已经够用,但是如果系统要存储大量的数据,比如数据采集系统,那么片内的数据存储器就不够用了,需要进行扩展。

    标签: MCS 51 单片机 系统扩展

    上传时间: 2013-11-19

    上传用户:jhksyghr

  • 基于MS5534B的微功耗气压数据采集

    气压是气象监测中的一个重要参数,提出了一种气压数据采集模块设计方案,该模块采用数字气压传感器MS5534B、MSP430单片机MSP430F2272和带实时时钟(RTC)64 KB铁电存储器。通过低功耗软件设计方法以微安级整体平均功耗实现了气压数据的采集和存储,适合电池供电的连续高精度气压采集应用。给出了模块的软硬件设计以及MS5534B的性能指标和使用经验。 Abstract:  Air pressure is an important parameter in weather monitor.This paper futs forward a new design scheme of low power-air pressure data acquisition module.The module uses a digital output barometer sensor MS5534B,MSP430 microcontroller MSP430F2272 and integrated RTC 64KB FRAM,precision air pressure measurement and storage chip.Another point of this module is low power consumption, so it is well suited for battery powered air pressure data acquisition applications. At the same time,the software and hardware deign of module is presented,And the speciaties and use notices of MS5534B are given.

    标签: 5534B 5534 MS 微功耗

    上传时间: 2014-12-27

    上传用户:drink!

  • 基于单片机AT89C52的血流信号采集系统的设计

    摘要:根据红光和红外光透过手指后光吸收量变化的特点.本文研究了基于单片机AT89C52的血流信号采集系统。该文设计了血流信号检测电路,研究了四点累加平均滤波和五点滑动平均滤波算法,有效的滤除了信号的高频噪声.克服了因个人生理差异引起的信号基线漂移、易饱和等问题。通过VB编程,实现了单片机和PC机之间的串行通信。关键词:单片机;血流信号;信号采集;串行通信

    标签: 89C C52 AT 89

    上传时间: 2013-11-04

    上传用户:xmsmh