09.06.01_example_9-7.sv

system verilog design book examples

/**********************************************************************
 * Selecting which modport to use at the module port definition
 *
 * NOTE: The modules in this example do not contain functionality.
 * The purpose of the example is to illustrate connections between
 * module instances.
 *
 * Author: Stuart Sutherland
 *
 * (c) Copyright 2003, Sutherland HDL, Inc. *** ALL RIGHTS RESERVED ***
 * www.sutherland-hdl.com
 *
 * Used with permission in the book, "SystemVerilog for Design"
 *  By Stuart Sutherland, Simon Davidmann, and Peter Flake.
 *  Book copyright: 2003, Kluwer Academic Publishers, Norwell, MA, USA
 *  www.wkap.il, ISBN: 0-4020-7530-8
 *
 * Revision History:
 *   1.00 15 Dec 2003 -- original code, as included in book
 *   1.01 10 Jul 2004 -- cleaned up comments, added expected results
 *                       to output messages
 *
 * Caveat: Expected results displayed for this code example are based
 * on an interpretation of the SystemVerilog 3.1 standard by the code
 * author or authors.  At the time of writing, official SystemVerilog
 * validation suites were not available to validate the example.
 *
 * RIGHT TO USE: This code example, or any portion thereof, may be
 * used and distributed without restriction, provided that this entire
 * comment block is included with the example.
 *
 * DISCLAIMER: THIS CODE EXAMPLE IS PROVIDED "AS IS" WITHOUT WARRANTY
 * OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED
 * TO WARRANTIES OF MERCHANTABILITY, FITNESS OR CORRECTNESS. IN NO
 * EVENT SHALL THE AUTHOR OR AUTHORS BE LIABLE FOR ANY DAMAGES,
 * INCLUDING INCIDENTAL OR CONSEQUENTIAL DAMAGES, ARISING OUT OF THE
 * USE OF THIS CODE.
 *********************************************************************/

interface chip_bus (input wire clock, resetN);
  logic interrupt_request, grant, ready;
  logic [31:0] address;
  wire  [63:0] data;

  modport master (input  interrupt_request,
                  input  address,
                  output grant, ready,
                  inout  data,
                  input  clock, resetN);

  modport slave  (output interrupt_request,
                  output address,
                  input  grant, ready,
                  inout  data,
                  input  clock, resetN);
endinterface

module primary   (chip_bus.master pins);  // use master modport
  //...
endmodule

module secondary (chip_bus.slave pins);  // use slave modport
  //...
endmodule

module chip (input wire clock, resetN);

  initial begin
    $display("\nNo simulation results--just checking that example compiles and elaborates\n");
    $finish;
  end

  chip_bus  bus (clock, resetN);  // instance of an interface

  primary   i1 (bus);  // will use the master modport view

  secondary i2 (bus);  // will use the slave modport view

endmodule