ddr2_32mx32_s3_dqs_iob.v

Xilinx DDR2存储器接口调试代码

///////////////////////////////////////////////////////////////////////////////
// Copyright (c) 2005-2007 Xilinx, Inc.
// This design is confidential and proprietary of Xilinx, All Rights Reserved.
///////////////////////////////////////////////////////////////////////////////
//   ____  ____
//  /   /\/   /
// /___/  \  /   Vendor			: Xilinx
// \   \   \/    Version		: $Name: i+IP+131489 $
//  \   \        Application		: MIG
//  /   /        Filename		: ddr2_32Mx32_s3_dqs_iob.v
// /___/   /\    Date Last Modified	: $Date: 2007/09/21 15:23:18 $
// \   \  /  \   Date Created		: Mon May 2 2005
//  \___\/\___\
// Device	: Spartan-3/3A/3A-DSP
// Design Name	: DDR2 SDRAM
// Purpose	: This module instantiates DDR IOB output flip-flops, an
//               output buffer with registered tri-state, and an input buffer
//               for a single strobe/dqs bit. The DDR IOB output flip-flops
//               are used to forward strobe to memory during a write. During
//               a read, the output of the IBUF is routed to the internal
//               delay module, dqs_delay.
///////////////////////////////////////////////////////////////////////////////

`timescale 1ns/100ps
module ddr2_32Mx32_s3_dqs_iob
  (
   input            clk,
   input            ddr_dqs_reset,
   input            ddr_dqs_enable,
   inout            ddr_dqs,
   inout  ddr_dqs_n,
   output           dqs
   );

   localparam VCC = 1'b1;
   localparam GND = 1'b0;

   wire dqs_q;
   wire ddr_dqs_enable1;
   wire ddr_dqs_enable_b;
   wire data1;

   assign ddr_dqs_enable_b = ~ddr_dqs_enable;
   assign data1 = (ddr_dqs_reset == 1'b1) ? 1'b0 : 1'b1;


  (* IOB = "TRUE" *) FD  U1
      (
       .D(ddr_dqs_enable_b),
       .Q(ddr_dqs_enable1),
       .C(clk)
       )/* synthesis syn_useioff = 1 */;

   FDDRRSE U2 (  
             .Q(dqs_q),
             .C0(clk),
             .C1(~clk),
             .CE(VCC),
             .D0(data1),
             .D1(GND),
             .R(GND),
             .S(GND)
             );



//***********************************************************************
//IO buffer for dqs signal. Allows for distribution of dqsto the data(DQ) loads.
//***********************************************************************


  OBUFTDS  U3  (
            .I(dqs_q),
            .T(ddr_dqs_enable1),
            .O(ddr_dqs),
            .OB(ddr_dqs_n)
            );

   IBUFDS  U4 (
                   .I(ddr_dqs),
                   .IB(ddr_dqs_n),
                   .O(dqs)
                   );

     endmodule