lb_ctl.v

32位单精度浮点加法器

//-----------------------------------------------------------------------------
//  
//  Copyright (c) 2009 Xilinx Inc.
//
//  Project  : Programmable Wave Generator
//  Module   : lb_ctl.v
//  Parent   : wave_gen
//  Children : debouncer.v
//
//  Description: 
//     Loopback controller.
//     Implements a debouncer on a slide switch, which is used to select
//     the output on the txd pin. When "off" (connected to gnd, so low), the 
//     normal transmit path is selected. When "on" (high), the rxd pin is
//     looped back to the txd pin with no intervening logic (a pure
//     combinational path)
//
//  Parameters:
//     CLOCK_RATE:     Clock rate (in Hz)
//     DEBOUNCE_TIME:  In SECONDS (real)
//
//  Local Parameters:
//
//  Notes       : 
//
//  Multicycle and False Paths
//     None

`timescale 1ns/1ps


module lb_ctl (
  input            clk_tx,          // Clock input
  input            rst_clk_tx,      // Active HIGH reset - synchronous to clk_tx
  
  input            lb_sel_i,        // Undebounced slide switch input
  
  input            txd_tx,          // Normal transmit data
  input            rxd_i,           // Raw receive data

  output           txd_o            // Transmit data to pin
);


//***************************************************************************
// Parameter definitions
//***************************************************************************

//  parameter 
//    CLOCK_RATE = 50_000_000,
//    DEBOUNCE_TIME = 0.004;    // The switch bounces for 2ms. Use 4ms for safety

//  localparam
//    CLOCK_PERIOD = 1.0/CLOCK_RATE,
//    FILTER       = (DEBOUNCE_TIME + CLOCK_PERIOD/2) / CLOCK_PERIOD;

  parameter FILTER = 200_000; // 0.004s at 50MHz
    

//***************************************************************************
// Reg declarations
//***************************************************************************


//***************************************************************************
// Wire declarations
//***************************************************************************

  wire         lb_sel_filt;          // Filtered value of the lb_sel switch
  
//***************************************************************************
// Code
//***************************************************************************

  // Instantiate the debouncer.

  debouncer #(
    .FILTER     (FILTER)
  ) debouncer_i0 (
    .clk        (clk_tx),
    .rst        (rst_clk_tx),
    .signal_in  (lb_sel_i),
    .signal_out (lb_sel_filt)
  );

  // Implement the loopback MUX
  assign txd_o = lb_sel_filt ? rxd_i : txd_tx;

endmodule