音响(audio)

MC1741组成的功放电路图

编辑:电子小虫 2013-03-11 09:36 1 次浏览 约 692 字 · 预计阅读 2 分钟
MC1741组成的功放电路图

MC1741组成的功放电路图


Some comments:

- The first thing that you must do, is to measure the end transistors (T3 and T4) amplifying coefficient, the hfe or β. If their disagreement is bigger than 30 %, the amplifier would not give a clear sound. I used MJ3001 and MJ2501 transistors, and this disagreement was around 5%.

- Before the first turning on you must short circuit the inputs of the amp, and put a mA-meter on the output, than turn the amplifier on, and tune the R13 pot, to decrease the DC current on the output, to some uA-s, or in a lucky situation to zero. I was able to decrease it to 10 uA.

This is a very simple, low cost, Hi-Fi quality power amplifier. You can build it 5 ways, like its shown in the table (from 20 W to 80 W RMS).

I am very contented with this amplifier. It gives a very good sound quality.

Have fun with it!


low cost Power Amplifier(MC1741组成的功放电路图)






返回音响(audio)列表