The JW® 7805 is a low noise low-dropout (LDO) voltage regulator with enable function that operates from 1.8V to 5.5V. It provides up to 300mA of output current and offers low-power operation in miniaturized packaging. JW7805 supports fixed output voltage 0.9V, 1.0V, 1.05V, 1.1V,1.2V, 1.3V, 1.35V, 1.5V, 1.8V, 1.85V, 2.1V, 2.2V, 2.3V, 2.5V, 2.6V, 2.7V, 2.8V, 2.85V, 2.9V, 3.0V,3.1V, 3.3V, 3.6V, 4.2V, 4.4V and 5.0V. The features of low quiescent current as low as 6uA and almost zero disable current are ideal for powering the battery equipment. JW7805’s low output noise and high PSRR are also friendly to RF systems.
标签： JW7805
上传时间： 2022-05-06
上传用户：slq1234567890
Abstract: A sliding mode observer and fractional-order phase-locked loop (FO-PLL) method is proposed for the sensorless speed control of a permanent magnet synchronous motor (PMSM).The saturation function is adopted in order to reduce the chattering phenomenon caused by the sliding mode observer. In this proposed FO-PLL, method, a regulable fractional order r is involved, which means that the FO-PLL provides an extra degree of freedom. In fact, the conventional phase-locked loop (PLL) applied in sensorless PMSM control can be seen as a special case of the proposed FO-PLL. By selecting a proper fractional order r a better performance may be achieved. The computer simulation results demonstrate the effectiveness of the proposed method.Key words: fractional calculus; fractional order phase-locked loop; sensorless control; sliding mode observer; permanent magnet synchronous motor; speed controll
上传时间： 2022-06-18
上传用户：
说明：Microchip Technology Inc.采用存储容量为1 Kb至1Mb的低电压串行电可擦除PROM（Electrically Erasable PROM，EEPROM），支持兼容串行外设接口（Serial Peripheral Interface，SPI）的串行总线架构，该系列器件支持字节级和页级功能，存储容量为512 Kb和1Mb的器件还通常与基于闪存的产品结合使用，具有扇区和芯片擦除功能。所需的总线信号为时钟输入（SCK）线、独立的数据输入（S1）线和数据输出（SO）线。通过片选（CS）输入信号控制对器件的访问。可通过保持引脚（HOLD）暂停与器件的通信。器件被暂停后，除片选信号外的所有输入信号的变化都将被忽略，允许主机响应优先级更高的中断。整个SPI兼容系列器件都具有标准的8引脚PDIP和SOIC封装，以及更高级的封装，如8引脚TSSOP，MSOP.2x3DFN，5x6 DFN和6引脚SOT-23封装形式。所有封装均为符合RoHS标准的无铅（雾锡）封装。引脚图（未按比例绘制）
上传时间： 2022-06-20
上传用户：fliang
INTRODUCTION In the past, adding speech recording and playback capability to a product meant using a digital signal processor or a specialized audio chip. Now, using a simplified Adaptive Differential Pulse Code Modulation(ADPCM) algorithm, these audio capabilities can be added to any PICmicro device. This application note will cover the ADPCM compression and decompression algorithms, performance comparison of all PICmicro devices, and an application using a PIC16C72 micro-controller.DEFINITION OF TERMS step size -value of the step used for quantization of ana-log signals and inverse quantization of a number of steps.quantization -the digital form of an analog input signal is represented by a finite number of steps.adaptive quantization -the step size of a quantizer is dramatically changed with time in order to adapt to a changing input signal.inverse quantizer -a finite number of steps is converted into a digital representation of an analog signal.
上传时间： 2022-06-20
上传用户：
本文以感应加热电源为研究对象，阐述了感应加热电源的基本原理及其发展趋势。对感应加热电源常用的两种拓扑结构-电流型逆变器和电压型逆变器做了比较分析，并分析了感应加热电源的各种调功方式。在对比几种功率调节方式的基础上，得出在整流侧调功有利于高频感应加热电源频率和功率的提高的结论，选择了不控整流加软斩波器调功的感应加热电源作为研究对象，针对传统硬斩波调功式感应加热电源功率损耗大的缺点，采用软斩波调功方式，设计了一种零电流开关准诺振变换器ZCS-QRCs（Zero-current-switching-Quasi-resonant）倍频式串联 振高频感应加热电源。介绍了该软斩波调功器的组成结构及其工作原理，通过仿真和实验的方法研究了该软斩波器的性能，从而得出该软斩波器非常适合大功率高频感应加热电源应用场合的结论。同时设计了功率闭环控制系统和PI功率调节器，将感应加热电源的功率控制问题转化为Buck斩波器的电压控制问题。针对目前IGBT器件频率较低的实际情况，本文提出了一种新的逆变拓扑-通过IGBT的并联来实现倍频，从而在保证感应加热电源大功率的前提下提高了其工作频率，并在分析其工作原理的基础上进行了仿真，验证了理论分析的正确性，达到了预期的效果。另外，本文还设计了数字锁相环（DPLL），使逆变器始终保持在功率因数近似为1的状态下工作，实现电源的高效运行。最后，分析并设计了1GBT的缓冲吸收电路。本文第五章设计了一台150kHz，10KW的倍频式感应加热电源实验样机，其中斩波器频率为20kHz，逆变器工作频率为150kHz（每个IGBT工作频率为75kHz），控制孩心采用TI公司的TMS320F2812 DSP控制芯片，简化了系统结构。实验结果表明，该倍频式感应加热电源实现了斩波器和逆变器功率器件的软开关，有效的减小了开关损耗，并实现了数字化，提高了整机效率。文章给出了整机的结构设计，直流斩波部分控制框图，逆变控制框图，驱动电路的设计和保护电路的设计。同时，给出了关键电路的仿真和实验波形。
上传时间： 2022-06-22
上传用户：
摘要：介绍了以FreeModbus协议找在嵌入式抢占实时操作系统μC/OS-l的STM32平台上，成功实现了Modbus协议的移植。通过详细分析FreeModbus协议花并编写STM32F103VET6微处理器的底层驱动，成功实现了工业Modbus协议RTU和ASCll两种模式的通信功能。测试结果表明，在实际工业生产控制和仪表开发中，应用Freemodbus协议，完全符合工业数据采集、实时控制和数据处理等厂级重复性和精确度要求，在一定程度上降低了工业仪表开发的周期及成本。关键词：实时操作系统，uC/OS-ll，FreeModbus，Modbus协议，STM32Abstract:This paper introduces FreeModbus stack transplanted to the STM32 platform which has been embedded in the preemptive real-time operating system uC/OS-ll，in order that the transplantation of the Modbus protocol is successfuly im-plemented.The FreeModbus stack is analyzed in detail and STM32F103VET6 microprocessor underlying driver is writed，so that the two Modbus industrial communication function RTU and ASCll are successfully realized.Keywords:time operating system，uC/OS-ll，.FreeModbus，Modbus协议，STM32
标签： freemodbus 通信协议
上传时间： 2022-06-25
上传用户：
The GD32F103xx device is a 32-bit general-purpose microcontroller based on the ARM?Cortex?-M3 RISC core with best ratio in terms of processing power, reduced power consumption and peripheral set. The Cortex?-M3 is a next generation processor core whichis tightly coupled with a Nested Vectored Interrupt Controller (NVIC), SysTick timer and advanced debug support.The GD32F103xx device incorporates the ARM ' Cortex?-M3 32-bit processor core operating at 108 MHz frequency with Flash accesses zero wait states to obtain maximumefficiency. It provides up to 3 MB on-chip Flash memory and up to 96 KB SRAM memory. An extensive range of enhanced I/Os and peripherals connected to two APB buses. The devices offer up to three 12-bit ADCs, up to two 12-bit DACs, up to ten general-purpose
标签： gd32f103
上传时间： 2022-07-23
上传用户：aben
