Thinking in C++(Second Edition) 国外经典C++原版书库《C++编程思想(英文版.第2版)》/(美)埃克尔(Eckel,B)著 十分经典、难得！
标签： Thinking Edition Second Eckel
上传时间： 2016-08-17
上传用户：520
Data Structures and Algorithms with Object-Oriented Design Patterns in Java Bruno R. Preiss B.A.Sc., M.A.Sc., Ph.D., P.Eng. Associate Professor Department of Electrical and Computer Engineering University of Waterloo, Waterloo, Canada
标签： B.A.S R. Object-Oriented Algorithms
上传时间： 2017-03-07
上传用户：z754970244
同时由B.W.Kernighan和D.M.Ritchit合著了著名的“THE C PROGRAMMING LANGUAGE”一书。通常简称为《K&R》，也有人称之为《K&R》标准
标签： PROGRAMMING Kernighan LANGUAGE Ritchit
上传时间： 2017-05-29
上传用户：ddddddos
dsp hư ớ ng dẫ n giao tiế p LCD code viế t bằ ng C
上传时间： 2017-06-17
上传用户：xuanjie
dsp từ cơ bả n đ ế n nâ ng cao 1
上传时间： 2014-12-05
上传用户：watch100
一﹑指标要求：. A: f5 b G A( d8 n （１）设计一个4位十进制的频率计其测量范围1Hz~9.999KHz；6 N3 G8 k( U- @ n* A （２）记数过程结束后，保存并显示结果；
上传时间： 2014-01-07
上传用户：妄想演绎师
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS，提出一种PS2键盘的设计方法。基于W78E052D单片机，采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路，电位器位置信息以键盘扫描码序列形式发送，正交编码器信号通过XC9536XL转换为单片机可接收的中断信号，软件接收到中断信息后等效处理成按键。结果表明，在满足开机可设置BIOS同时，又可实现超声特有功能，不需要专门设计驱动程序，接口简单，成本低。 Abstract: Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot， this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller，designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter， potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU， software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot， ultrasound specific functionality can be achieved at the same time， it does not require specially designed driver，the interface is simple and low cost.
上传时间： 2013-10-10
上传用户：asdfasdfd
二: 普通计算器的设计说明: 1 普通计算器的主要功能(普通计算与逆波兰计算): 1.1主要功能: 包括 a普通加减乘除运算及带括号的运算 b各类三角与反三角运算（可实现角度与弧度的切换） c逻辑运算， d阶乘与分解质因数等 e各种复杂物理常数的记忆功能 f对运算过程的中间变量及上一次运算结果的储存. G 定积分计算器（只要输入表达式以及上下限就能将积分结果输出） H 可编程计算器（只要输入带变量的表达式后，再输入相应的变量的值就能得到相应的结果） I 二进制及八进制的计算器 j十六进制转化为十进制的功能。 *k (附带各种进制间的转化器)。 L帮助与阶乘等附属功能
上传时间： 2013-11-26
上传用户：yzy6007
光学设计软件zemax源码： This DLL models an nular aspheric surface as described in: "Annular surfaces in annular field systems" By Jose M. Sasian Opt. eng. 36 (12) P 3401-3401 December 1997 This surface is essentially an odd aspheric surface with an offset in the aspheric terms. The sag is given by: Z = (c*r*r) / (1+(1-((1+k)*c*c*r*r))^ 1/2 ) + a*(r-q)^2 + b*(r-q)^3 + c*(r-q)^4 + ... Note the terms a, b, c, ... have units of length to the -1, -2, -3, ... power.
标签： described aspheric surfaces Annular
上传时间： 2014-01-08
上传用户：yyyyyyyyyy
