Abstract: This reference design provides design ideas for a cost-effective, low-power liquid-level measurement dataacquisition system (DAS) using a compensated silicon pressure sensor and a high-precision delta-sigma ADC. Thisdocument discusses how to select the compensated silicon pressure sensor, suggest system algorithms, and providenoise analyses. It also describes calibration ideas to improve system performance while also reducing complexity andcost.
上传时间： 2013-10-08
上传用户：sjy1991
机电类比法是一种把机械量通过一定的计算等效类比为电量的方法，其在对电子机械系统的分析中应用非常广泛。它能够把一个较复杂的机械系统类比为我们熟知的电路系统来进行分析，从而使问题的分析得到简化。本文通过对振弦式传感器的分析介绍了机电类比法，并对使用电路进行了相关的分析。 Summary：The electromechanical analogy is assort of analysis which is to analogize the mechanical system by using circuit system , it applied widely in the filed of analysis the electronic-mechanical system. The analysis can take a complex mechanical system analogous to a circuitry that we well-known, which can simplify the problems. In the paper, the electro-mechanical analogy method is briefly introduced by analysis the vibrating wire sensor，and have a correlation analysis about the circuit we used.关键词： 机电类比法 振弦式传感器 频率 振荡 反馈Keyword：electro-mechanical analogy method，vibrating wire sensor，frequency, oscillation, feedback 0 引言振弦式传感器是属于频率式传感器的一种。所谓频率式传感器就是能直接将被测量转换为振动频率信号的传感器，这类传感器一般是通过测量振弦、振筒、振梁、振膜等弹性振体或石英晶体谐振器的固有谐振频率来达到测量引起谐振频率变化的被测非电量的目的，其也称为谐振式传感器[1]。在分析该类传感器中，由于其涉及到频率，就容易让人联想到在电子技术中接触到的RLC振荡电路。因此可以尝试着用类比的方法使之对应起来分析,即机电类比法分析。
上传时间： 2013-11-16
上传用户：paladin
The Maxim Integrated 71M6541-DB REV 3.0 Demo Board is a demonstration board for evaluating the 71M6541 device for single-phase electronic energy metering applications in conjunction with the Remote sensor Inter-face. It incorporates a 71M6541 integrated circuit, a 71M6601 Remote Interface IC, peripheral circuitry such as a serial EEPROM, emulator port, and on-board power supply. A serial to USB converter allows communication to a PC through a USB port. The Demo Board allows the evaluation of the 71M6541 energy meter chip for measurement accuracy and overall system use.
上传时间： 2013-11-06
上传用户：雨出惊人love
目录 一、Smart Phone Market Share 1.1、中国智能手机销售量与变化状况 1.2、智能手机操作系统份额走势 1.3、智能手机销售价格走势 二、展讯智能手机方案 三、TI 无线充电方案 四、Freescale G+M二合一 sensor 五、NXP NFC 六、TI 五合一 无线芯片 展讯智能手机方案框图
上传时间： 2014-12-30
上传用户：blacklee
在研究传统家用燃气报警器的基础上，以ZigBee协议为平台，构建mesh网状网络实现网络化的智能语音报警系统。由于传感器本身的温度和实际环境温度的影响，传感器标定后采用软件补偿方法。为了减少系统费用，前端节点采用半功能节点设备，路由器和协调器采用全功能节点设备，构建mesh网络所形成的家庭内部报警系统，通过通用的电话接口连接到外部的公用电话网络，启动语音模块进行报警。实验结果表明，在2.4 GHz频率下传输，有墙等障碍物的情况下，节点的传输距离大约为35 m，能够满足家庭需要，且系统工作稳定，但在功耗方面仍需进一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol，and constructed mesh network to achieve network-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator，constructed alarm system within the family by building mesh network，connected to the external public telephone network through the common telephone interface, started the voice alarm module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上传时间： 2013-10-30
上传用户：swaylong
为满足无线网络技术具有低功耗、节点体积小、网络容量大、网络传输可靠等技术要求，设计了一种以MSP430单片机和CC2420射频收发器组成的无线传感节点。通过分析其节点组成，提出了ZigBee技术中的几种网络拓扑形式，并研究了ZigBee路由算法。针对不同的传输要求形式选用不同的网络拓扑形式可以尽大可能地减少系统成本。同时针对不同网络选用正确的ZigBee路由算法有效地减少了网络能量消耗，提高了系统的可靠性。应用试验表明，采用ZigBee方式通信可以提高传输速率且覆盖范围大，与传统的有线通信方式相比可以节约40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower， small nodes， large capacity and reliable network transmission， wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided network topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different network topologies form can most likely reduce the system cost. And aiming at different network to choose the correct ZigBee routing algorithm can effectively reduced the network energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate， cover more area and reduce 40% cost compared with traditional wired communications mode.
上传时间： 2013-10-09
上传用户：robter
波长信号的解调是实现光纤光栅传感网络的关键，基于现有的光纤光栅传感器解调方法，提出一种基于FPGA的双匹配光纤光栅解调方法，此系统是一种高速率、高精度、低成本的解调系统，并且通过引入双匹配光栅有效地克服了双值问题同时扩大了检测范围。分析了光纤光栅的测温原理并给出了该方案软硬件设计，综合考虑系统的解调精度和FPGA的处理速度给出了基于拉格朗日的曲线拟合算法。 Abstract: sensor is one of the most important application of the fiber grating. Wavelength signal demodulating is the key techniques to carry out fiber grating sensing network， based on several existing methods of fiber grating sensor demodulation inadequate， a two-match fiber grating demodulation method was presented. This system is a high-speed， high precision， low-cost demodulation system. And by introducing a two-match grating effectively overcomes the problem of double value while expands the scope of testing. This paper analyzes the principle of fiber Bragg grating temperature and gives the software and hardware design of the program. Considering the system of demodulation accuracy and processing speed of FPGA，this paper gives the curve fitting algorithm based on Lagrange.
上传时间： 2013-10-10
上传用户：zxc23456789
特点： 精确度0.05%满刻度±1位數 可量测交直流电流/交直流电压/电位计/Pt-100/热电偶/荷重元/电阻等信号 热电偶sensor输入种类J/K/T/E/R/S/B可任意规划 显示范围-19999-99999可任意规划 小数点可任意规划 尺寸小，稳定性高 CE认证
上传时间： 2013-10-31
上传用户：wsq921779565
Abstract: This application note explains how to design an intelligent lighting controller that senses and measures the ambient lightlevel with an ambient light sensor (ALS). Equipped with a real-time clock (RTC), the controller also knows when to turn lighting on oroff at specified times. The system presented in this document can be used to control all luminaires that are mains-supply operated.Controller software is also provided in hex format.
上传时间： 2013-11-18
上传用户：AbuGe
Rotating shafts experience a an elliptical motion called whirl. It is important to decompose this motion into a forward and backward whil orbits. The current function makes use of two sensors to generate a bi-directional spectrogram. The method can be extended to any time-frequency distribution ％ ％ compute the forward/backward Campbell/specgtrogram ％ ％ INPUT: ％ y (n x 2) each column is measured from a different sensor ％ /////// ％ __ ％ |s1| y(:,1) ％ |__| ％ __ ％ / \ ________|/ ％ | | | s2 |/ y(:,2) ％ \____/ --------|/ ％ ％ Fs Sampling frequnecy ％ ％ OUTPUT: ％ B spectrogram/Campbel diagram ％ x x-axis coordinate vector (time or Speed) ％ y y-axis coordinate vector (frequency [Hz])
标签： experience elliptical decompose important
上传时间： 2015-06-23
上传用户：372825274
