NEC 8位MCU参考手册
上传时间： 2013-11-17
上传用户：swz13842860183
PCA9634是一款通过I2C总线控制的8位LED驱动器，该驱动器特别为红/绿/蓝/琥珀（RGBA）色的混合应用进行了优化。每个LED输出都有自己的8位分辨率（256级）固定频率的独立PWM控制器，该控制器运行在97KHz的频率下，占空比可由0%到99.6%可调，用以将LED设置到一个特定的亮度值。除此之外，该驱动器还有一个8位分辨率（256级）的组PWM控制器，该控制器的工作频率可以为固定的190Hz，也可以在24Hz和每10.73秒一次（约0.093Hz）之间调整，其占空比为0%到99.6%可调，用于使所有LED以同样的值模糊（dim）或者闪烁。
上传时间： 2013-12-20
上传用户：liaofamous
PCA9624是一款带I2C总线的8位LED的电压开关优化的LED驱动器，它主要应用于电流为100mA 的红/绿/蓝/琥珀（RGBA）的LED的亮度和闪烁的控制。每个LED输出均有独立的8位分辨率（256个梯度）且输出频率固定为97KHz的PWM控制器它可以在0%到99.6%的范围内对LED的亮度进行调整，使发光二极管被设置为一个特定的亮度值。额外的8位分辨率（256个梯度）PWM控制器组既有固定的190Hz的频率又可以在24Hz和每10.73秒的固定周期内对LED灯亮度从0％至99.6％的范围内调整，使它们保持同样的亮度或闪烁速度。
上传时间： 2013-11-24
上传用户：38553903210
PCA9624是一款带I2C总线的8位LED的电压开关优化的LED驱动器，它主要应用于电流为100mA 的红/绿/蓝/琥珀（RGBA）的LED的亮度和闪烁的控制。每个LED输出均有独立的8位分辨率（256个梯度）且输出频率固定为97KHz的PWM控制器它可以在0%到99.6%的范围内对LED的亮度进行调整，使发光二极管被设置为一个特定的亮度值。额外的8位分辨率（256个梯度）PWM控制器组既有固定的190Hz的频率又可以在24Hz和每10.73秒的固定周期内对LED灯亮度从0％至99.6％的范围内调整，使它们保持同样的亮度或闪烁速度。
上传时间： 2014-12-27
上传用户：zhangliming420
<Almost since the introduction of microcontrollers as electronic components there always has been an oscillatorcircuit on the device to make it work. From application point of view only some external components wererequired to make it work. However, to make sure that it will always work required more effort. This report is basedon feedback from the market from customers applying 8-bit mircrocontrollers.>
标签： oscillators X-tal bit mic
上传时间： 2013-11-12
上传用户：穿着衣服的大卫
The PCA9670 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9670 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-15
上传用户：stella2015
The PCA9672 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9672 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-23
上传用户：jasonheung
The PCA9674/74A is a drop-in upgrade for the PCF8574/74A providing higher Fast-modePlus I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上传时间： 2013-10-22
上传用户：wwwwwen5
The PCA9557 is a silicon CMOS circuit which provides parallel input/output expansion for SMBus and I2C-bus applications. The PCA9557 consists of an 8-bit input port register, 8-bit output port register, and an I2C-bus/SMBus interface. It has low current consumption and a high-impedance open-drain output pin, IO0. The system master can enable the PCA9557’s I/O as either input or output by writing to the configuration register. The system master can also invert the PCA9557 inputs by writing to the active HIGH polarity inversion register. Finally, the system master can reset the PCA9557 in the event of a time-out by asserting a LOW in the reset input. The power-on reset puts the registers in their default state and initializes the I2C-bus/SMBus state machine. The RESET pin causes the same reset/initialization to occur without de-powering the part.
上传时间： 2014-01-18
上传用户：bs2005
RSM-4055 是带隔离的数字量输入输出模块。模块有8 路隔离数字量输入，8 路隔离数字量输出。数字量输入可支持开关触点信号或电平信号，数字量输出采用开漏输出，最大负载可达50V，50mA，同时模块的DI 通道还具有计数功能，能对小于2kHz 的数字脉冲信号进行计数，DI 输入检测和计数都具有数字滤波功能能有效滤掉干扰信号，数字输入检测和计数可同时使用。模块适用于采集工业现场的数字量信号以及控制功率继电器等。
上传时间： 2013-11-10
上传用户：zl520l
