Data Structures and Algorithms with Object-Oriented Design Patterns in Java Bruno R. Preiss B.A.Sc., M.A.Sc., Ph.D., P.Eng. Associate Professor Department of Electrical and Computer Engineering University of Waterloo, Waterloo, Canada
标签： B.A.S R. Object-Oriented Algorithms
上传时间： 2017-03-07
上传用户：z754970244
dsp hư ớ ng dẫ n giao tiế p LCD code viế t bằ ng C
上传时间： 2017-06-17
上传用户：xuanjie
dsp từ cơ bả n đ ế n nâ ng cao 1
上传时间： 2014-12-05
上传用户：watch100
Ｃ语言是在70年代初问世的。一九七八年由美国电话电报公司(AT&T)贝尔实验室正式发表了Ｃ语言。同时由B.W.Kernighan和D.M.Ritchit合著了著名的“THE C PROGRAMMING LANGUAGE”一书。通常简称为《K&R》，也有人称之为《K&R》标准。但是，在《K&R》中并没有定义一个完整的标准C语言，后来由美国国家标准学会在此基础上制定了一个C 语言标准，于一九八三年发表。通常称之为ANSI C。
标签： PROGRAMMING Kernighan Ritchit THE
上传时间： 2014-11-12
上传用户：思琦琦
国际会议上的关于人耳图像识别的论文：Multi-view Ear Recognition Based on B-Spline Pose Manifold Construction
标签： Construction Recognition Multi-view B-Spline
上传时间： 2013-12-17
上传用户：磊子226
基于 Ma t l a b语言的遗传算法工具箱支持二进制和浮点数编码方式， 并且提供了多种选择、 交叉、 变异的方法。 通过具体实例对 Ma t l a b的遗传 算法工具箱的用法进行 了说 明介绍.
上传时间： 2017-09-05
上传用户：671145514
m a t l a b 编 程 实 例！
标签：
上传时间： 2013-12-21
上传用户：skfreeman
有关于T函数与B函数的一些总结，可以作为课件使用。
上传时间： 2015-11-10
上传用户：wangtianhe
随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS，提出一种PS2键盘的设计方法。基于W78E052D单片机，采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路，电位器位置信息以键盘扫描码序列形式发送，正交编码器信号通过XC9536XL转换为单片机可接收的中断信号，软件接收到中断信息后等效处理成按键。结果表明，在满足开机可设置BIOS同时，又可实现超声特有功能，不需要专门设计驱动程序，接口简单，成本低。 Abstract: Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot， this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller，designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter， potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU， software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot， ultrasound specific functionality can be achieved at the same time， it does not require specially designed driver，the interface is simple and low cost.
上传时间： 2013-10-10
上传用户：asdfasdfd
