描述了NTC使用B值计算出实际温度与输出的电压之间的关系。
标签： ntc计算
上传时间： 2022-06-15
上传用户：
BC20-TE-B NB-Iot 评估板评估板原厂原理图V1.2。完整对应实物装置。
上传时间： 2022-06-17
上传用户：
ASR M08-B设置软件 V3.2 arduino 2560+ASRM08-B测试程序 arduino UNO+ASRM08-B测试程序语音控制台灯电路图及C51源码(不带校验码) 继电器模块设置。 ASR M08-B是一款语音识别模块。首先对模块添加一些关键字，对着该模块说出关键字，串口会返回三位的数，如果是返回特定的三位数字，还会引起ASR M08-B的相关引脚电平的变化。【测试】①打开“ASR M08-B设置软件 V3.2.exe”。②选择“串口号”、“打开串口”、点选“十六进制显示”。③将USB转串口模块连接到语音识别模块上。接线方法如下：语音模块TXD --> USB模块RXD语音模块RXD --> USB模块TXD语音模块GND --> USB模块GND语音模块3V3 --> USB模块3V3（此端为3.3V电源供电端。）④将模块的开关拨到“A”端，最好再按一次上面的大按钮（按一次即可，为了确保模块工作在正确的模式）。⑤对着模块说“开灯”、“关灯”模块会返回“0B”、“0A”，表示正常(注意：0B对应返回值010，0B对应返回值010，返回是16进制显示的嘛，设置的时候是10进制设置的)。
标签： ASR M08-B
上传时间： 2022-07-06
上传用户：aben
All inputs of the C16x family have Schmitt-Trigger input characteristics. These Schmitt-Triggers are intended to always provide proper internal low and high levels, even if anundefined voltage level (between TTL-VIL and TTL-VIH) is externally applied to the pin.The hysteresis of these inputs, however, is very small, and can not be properly used in anapplication to suppress signal noise, and to shape slow rising/falling input transitions.Thus, it must be taken care that rising/falling input signals pass the undefined area of theTTL-specification between VIL and VIH with a sufficient rise/fall time, as generally usualand specified for TTL components (e.g. 74LS series: gates 1V/us, clock inputs 20V/us).The effect of the implemented Schmitt-Trigger is that even if the input signal remains inthe undefined area, well defined low/high levels are generated internally. Note that allinput signals are evaluated at specific sample points (depending on the input and theperipheral function connected to it), at that signal transitions are detected if twoconsecutive samples show different levels. Thus, only the current level of an input signalat these sample points is relevant, that means, the necessary rise/fall times of the inputsignal is only dependant on the sample rate, that is the distance in time between twoconsecutive evaluation time points. If an input signal, for instance, is sampled throughsoftware every 10us, it is irrelevant, which input level would be seen between thesamples. Thus, it would be allowable for the signal to take 10us to pass through theundefined area. Due to the sample rate of 10us, it is assured that only one sample canoccur while the signal is within the undefined area, and no incorrect transition will bedetected. For inputs which are connected to a peripheral function, e.g. capture inputs, thesample rate is determined by the clock cycle of the peripheral unit. In the case of theCAPCOM unit this means a sample rate of 400ns @ 20MHz CPU clock. This requiresinput signals to pass through the undefined area within these 400ns in order to avoidmultiple capture events.For input signals, which do not provide the required rise/fall times, external circuitry mustbe used to shape the signal transitions.In the attached diagram, the effect of the sample rate is shown. The numbers 1 to 5 in thediagram represent possible sample points. Waveform a) shows the result if the inputsignal transition time through the undefined TTL-level area is less than the time distancebetween the sample points (sampling at 1, 2, 3, and 4). Waveform b) can be the result ifthe sampling is performed more than once within the undefined area (sampling at 1, 2, 5,3, and 4).Sample points:1. Evaluation of the signal clearly results in a low level2. Either a low or a high level can be sampled here. If low is sampled, no transition willbe detected. If the sample results in a high level, a transition is detected, and anappropriate action (e.g. capture) might take place.3. Evaluation here clearly results in a high level. If the previous sample 2) had alreadydetected a high, there is no change. If the previous sample 2) showed a low, atransition from low to high is detected now.
上传时间： 2013-10-23
上传用户：copu
加密算法 Test Driver for Crypto++, a C++ Class Library of Cryptographic Primitives: - To generate an RSA key cryptest g - To encrypt and decrypt a string using RSA cryptest r - To calculate MD5, SHS, and RIPEMD-160 message digests: cryptest m file - To encrypt and decrypt a string using DES-EDE in CBC mode: cryptest t - To encrypt or decrypt a file cryptest e|d input output - To share a file into shadows: cryptest s <pieces> <pieces-needed> file (make sure file has no extension, if you re running this under DOS) - To reconstruct a file from shadows: cryptest j output file1 file2 [....] - To gzip a file: cryptest z <compression-level> input output - To gunzip a file: cryptest u input output - To run validation tests: cryptest v - To run benchmarks: cryptest b [time for each benchmark in seconds]
标签： Cryptographic Primitives generate Library
上传时间： 2015-07-16
上传用户：wqxstar
DirectX not only provides fast access to the hardware and therefore incredibly speedy performance, but it also makes it much easier for hardware developers to produce new devices that work well in the Windows environment. The DirectX APIs take away the necessity of writing your own low-level, device-specific code to access hardware such as the display adapter and network card, making it much easier for you to write programs that take full advantage of the computer s multimedia capabilities.
标签： performance incredibly therefore hardware
上传时间： 2016-02-16
上传用户：秦莞尔w
輕易學好C++編程技巧 - 進楷 (香港科技大學筆記 19課) 內容包括 1) base C++ review, 2) Pointers and Dynamic Objects, 3) Recursion,Linked Lists, 4) Stacks and Queues, 5) Algorithm Analysis, 6) Insertion Sort and Mergesort, 7) Quicksort, 8) Heaps and Heapsort, 9) Lower Bound of Sorting and Radix Sort, 10) Binary Trees and Binary Search Trees 11) AVL Trees, 12) B+ Trees 13) Graphs and Breadth-First Search 14) Depth-First Search 15) Connected Components, Directed Graphs, 16) Topological Sort 17) Hashing 18) Pattern Matching 19) Additional Review
标签： Pointers Dynamic Objects review
上传时间： 2014-10-10
上传用户：chfanjiang
The "GEE! It s Simple" package illustrates Gaussian elimination with partial pivoting, which produces a factorization of P*A into the product L*U where P is a permutation matrix, and L and U are lower and upper triangular, respectively. The functions in this package are accurate, but they are far slower than their MATLAB equivalents (x=A\b, [L,U,p]=lu(A), and so on). They are presented here merely to illustrate and educate. "Real" production code should use backslash and lu, not this package.
标签： illustrates elimination Gaussian pivoting
上传时间： 2016-11-09
上传用户：wang5829
The "GEE! It s Simple" package illustrates Gaussian elimination with partial pivoting, which produces a factorization of P*A into the product L*U where P is a permutation matrix, and L and U are lower and upper triangular, respectively. The functions in this package are accurate, but they are far slower than their MATLAB equivalents (x=A\b, [L,U,p]=lu(A), and so on). They are presented here merely to illustrate and educate. "Real" production code should use backslash and lu, not this package.
标签： illustrates elimination Gaussian pivoting
上传时间： 2014-01-21
上传用户：lxm
This material is not only up-to-date, it defines up-to-date. It is truly cutting-edge. As the only book on the subject, Rootkits will be of interest to any Windows security researcher or security programmer. It s detailed, well researched and the technical information is excellent. The level of technical detail, research, and time invested in developing relevant examples is impressive.
标签： up-to-date only cutting-edge material
上传时间： 2017-07-09
上传用户：comua
