PCA9515 是一款采用BiCMOS 工艺的总线中继器，通过它可以扩展I2C 和SMBus 系统。PCA9515 在保持总线操作模式和特性的情况下，通过缓存数据线（SDA）和时钟线（SCL）的数据实现I2C 总线扩展，总线容性负载能力最大为400pF。
上传时间： 2013-11-10
上传用户：asdgfsdfht
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上传时间： 2013-10-10
上传用户：inwins
The PCA9516 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both the data(SDA) and the clock (SCL) lines, thus enabling five buses of 400 pF.The I2C-bus capacitance limit of 400 pF restricts the number ofdevices and bus length. Using the PCA9516 enables the systemdesigner to divide the bus into five segments off of a hub where anysegment to segment transition sees only one repeater delay.
上传时间： 2013-11-21
上传用户：q123321
The PCA9535 and PCA9535C are 24-pin CMOS devices that provide 16 bits of GeneralPurpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and wasdeveloped to enhance the NXP Semiconductors family of I2C-bus I/O expanders. Theimprovements include higher drive capability, 5 V I/O tolerance, lower supply current,individual I/O configuration, and smaller packaging. I/O expanders provide a simplesolution when additional I/O is needed for ACPI power switches, sensors, push buttons,LEDs, fans, etc.
上传时间： 2013-10-21
上传用户：爱死爱死
PCA9516 是一款基于BICMOS 工艺的I2C/SMBus 总线中继器。PCA9516 保持I2C 总线系统所有的模式与特性的同时，允许扩展I2C/时钟总线和连接5 条最大容限为400pF 电容的总线。当I2C 总线上有400pF 的电容时，总线长度和器件的数量都会被限制。系统设计者把总线分成五部分，各部分之间的传输只有一个复用器的延时。
上传时间： 2013-11-13
上传用户：75119158
The PCA9536 is an 8-pin CMOS device that provides 4 bits of General Purpose parallelInput/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed toenhance the NXP Semiconductors family of I2C-bus I/O expanders. I/O expanders providea simple solution when additional I/O is needed for ACPI power switches, sensors,push buttons, LEDs, fans, etc.
上传时间： 2013-10-09
上传用户：731140412
The PCA9517 is a CMOS integrated circuit that provides level shifting between lowvoltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) I2C-bus or SMBus applications.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Usingthe PCA9517 enables the system designer to isolate two halves of a bus for both voltageand capacitance. The SDA and SCL pins are over voltage tolerant and arehigh-impedance when the PCA9517 is unpowered.
标签： translating Level 9517 PCA
上传时间： 2013-12-25
上传用户：wsf950131
The PCA9537 is a 10-pin CMOS device that provides 4 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.
上传时间： 2013-10-14
上传用户：wuchunzhong
PCA9517 是一款基于CMOS 工艺的低电压I2C 中继器，在I2C 总线或SMBus 应用中进行高低电压转换。PCA9517 能够在电平转换期间保持总线所有的操作模式和特性，通过数据线（SDA）和时钟线（SCL）的双向缓存实现I2C 总线扩展，总线最大容性负载为400pF。PCA9517 能够隔离器件总线两端的电压和容性负载。SDA 和SCL 引脚具有过压保护功能，在掉电的情况下为高阻状态。
上传时间： 2013-10-08
上传用户：zgz317
The PCA9538 is a 16-pin CMOS device that provides 8 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.
上传时间： 2014-01-24
上传用户：youmo81
