flexible construction of girth-six QC-LDPC Codes
标签： construction girth-six flexible QC-LDPC
上传时间： 2017-09-27
上传用户：gaojiao1999
信息化社会的到来以及IP技术的兴起，正深刻的改变着电信网络的面貌以及未来技术发展的走向。无线通信技术的发展为实现数字化社区提供了有力的保证。而视频通信则成为多媒体业务的核心。如何在环境恶劣的无线环境中，实时传输高质量的视频面临着巨大的挑战，因此这也成为人们的研究热点。 对于无线移动信道来说，网络的可用带宽是有限的。由于多径、衰落、时延扩展、噪声影响和信道干扰等原因，无线移动通信不仅具有带宽波动的特点，而且信道误码率高，经常会出现连续的、突发性的传输错误。无线信道可用带宽与传输速率的时变特性，使得传输的可靠性大为降低。 视频播放具有严格的实时性要求，这就要求网络为视频的传输提供足够的带宽.有保障的延时和误码率。为了获得可接受的重建视频质量，视频传输至少需要28Kbps左右的带宽。而且视频传输对时延非常敏感。然而无线移动网络却无法提供可靠的服务质量。 基于无线视频通信面临的挑战，本文在对新一代视频编码国际标准H.264/AVC研究的基础上，主要在提高其编码效率和H.264的无线传输抗误码性能，以及如何在嵌入式环境下实现H.264解码器进行了研究。 结合低码率和帧内刷新，提出一种针对感兴趣区的可变帧内刷新方法。实验表明该方法可以使用较少的码率对感兴趣区域进行更好的错误控制，以提高区域图像质量，同时能根据感兴趣区及信道的状况自动调整宏块刷新数量，充分利用有限的码率。 为了有效的平衡编码效率和抗误码能力的之间的矛盾，笔者提出了一种自适应FMO(flexible Macroblock Order)编码方法，可根据图像的复杂度自适应地选择编码所需的FMO模式。仿真结果表明这种FMO编码方式完全可行，且在运动复杂度频繁变化时效果更加明显，完全可应用在环境恶劣的无线信道中。 在对嵌入式PXA270硬件结构和X264研究的基础上，基本实现了基于H.264的嵌入式解码，在PXA270基础上进行环境的配置，定制WirtCE操作系统，并编译、产生开发所用的SDK和下载内核到目标机。利用开发工具EVC实现在PC机上的实时开发和在线仿真调试，最终实现了对无差错H.264码流实时解码。
上传时间： 2013-06-18
上传用户：也一样请求
The LTC®1966 is a true RMS-to-DC converter that uses aDS computational technique to make it dramatically simplerto use, significantly more accurate, lower in powerconsumption and more flexible than conventional logantilogRMS-to-DC converters. The LTC1966 RMS-to-DCconverter has an input signal range from 5mVRMS to1.5VRMS (a 50dB dynamic range with a single 5V supplyrail) and a 3dB bandwidth of 800kHz with signal crestfactors up to four.
上传时间： 2013-10-12
上传用户：qilin
提出一种基于凌阳单片机的步进电机加减速的控制方法。采用凌阳科技推出的16位结构工控单片机SPMC75F2413A为控制器，由Allegro公司生产的两相步进电机专用驱动器件SLA7042M构成步进电机的驱动电路，在传统的3段直线加减速控制算法基础上增加至7段S形曲线加减速过程，控制步进电机的启动和停止。实验结果表明，该控制方法克服了直线加减速中不连续、易造成系统冲击的问题，整个系统实现柔性控制，电机启动、停止连续性能提高30%。 Abstract: The method of controlled stepping motor is referred based on SPMC75F2413A MCU， which adopts the 16 knots SPMC75F2413A MCU as the controller. The special-purpose actuation chip SLA7042M of two stepping motor produced by Allegro Corporation constituted to actuation electric circuit. The purpose of increasing to seven section of S shape curve based on the traditional three sections of straight line is to control the start and stop process of stepping motor. The experimental results show that the control method solves easy to pull-out and overshot problems. The overall system realizes flexible control， and the performance of motor start or stop continuity is increased 30%
上传时间： 2013-12-08
上传用户：jiangfire
出了一种利用ATmega8单片机对ISD2500系列语音芯片进行控制的智能语音系统，此系统使用灵活，易于功能升级，具有良好的应用前景。提供了硬件连接电路和关键源程序。 Abstract: An intelligent voice system using ISD2500 series voice chips based on ATmega8 MCU is described.This system is flexible and easy to upgrade for users,and it has pretty good using foreground. The circuit diagram and the key program are also provided.
上传时间： 2014-01-22
上传用户：Artemis
Virtex-5, Spartan-DSP FPGAs Application Note This application note demonstrates how efficient implementations of Digital Up Converters(DUC) and Digital Down Converters (DDC) can be done by leveraging the Xilinx DSP IPportfolio for increased productivity and reduced time to development. Step-by-step instruction is given on how to perform system-level trade off analysis and develop the most efficient FPGA implementation, thus allowing engineers a flexible, low-cost and low-power alternative to ASSP technologies.
标签： Spartan-DSP Virtex FPGAs Ap
上传时间： 2013-10-23
上传用户：raron1989
1.The C Programming Language is a powerful, flexible andpotentially portable high-level programming language. 2.The C language may be used successfully to create a programfor an 8-bit MCU, but to produce the most efficient machinecode, the programmer must carefully construct the C Languageprogram.3.The programmer must not only create an efficient high leveldesign, but also pay attention to the detailed implementation.
上传时间： 2013-12-27
上传用户：huanglang
Luminary Micro Stellaris™ microcontrollers that are equipped with an analog-to-digital converter(ADC), use an innovative sequence-based sampling architecture designed to be extremely flexible,yet easy to use. This application note describes the sampling architecture of the ADC. Sinceprogrammers can configure Stellaris microcontrollers either through the powerful StellarisFamilyDriver Library or through direct writes to the device's control registers, this application note describesboth methods. The information presented in this document is intended to complement the ADCchapter of the device datasheet, and assumes the reader has a basic understanding of howADCsfunction.
标签： Microcontr Stellaris Using the
上传时间： 2013-10-14
上传用户：blans
winCE msdn讲座 XP Embedded Now and the future Windows XP Embedded Developmentand Deployment Model OverviewWindows XP Embedded Component ModelWindows XP Embedded Studio Tools Microsoft WindowsXP Embedded Product Highlights Componentized version of Windows XP Professional~ 12,000 components and updates as of Service Pack 2flexible localizationSame binaries and API as Windows XP ProfessionalHotfixes and service packsEmbedded Enabling FeaturesRuns on standard PC hardwareSupports boot on hard drives, compact flash, DiskOnChipand read-only mediaSupport for remote install and remote bootHeadless device and remote management supportIntegration with Microsoft management tools
上传时间： 2013-10-31
上传用户：jrsoft
The AT89C52 is a low-power, high-performance CMOS 8-bit microcomputer with 8Kbytes of Flash programmable and erasable read only memory (PEROM). The deviceis manufactured using Atmel’s high-density nonvolatile memory technology and iscompatible with the industry-standard 80C51 and 80C52 instruction set and pinout.The on-chip Flash allows the program memory to be reprogrammed in-system or by aconventional nonvolatile memory programmer. By combining a versatile 8-bit CPUwith Flash on a monolithic chip, the Atmel AT89C52 is a powerful microcomputerwhich provides a highly-flexible and cost-effective solution to many embedded controlapplications.
上传时间： 2013-11-10
上传用户：1427796291
