虫虫首页|资源下载|资源专辑|精品软件
登录|注册

excitation

  • Separation of harmonic excitation responses from contaminated measurements based on ICA

    Separation of harmonic excitation responses from contaminated measurements based on ICA

    标签: contaminated measurements Separation excitation

    上传时间: 2014-01-24

    上传用户:zhuimenghuadie

  • 用matlab去實現mixed excitation linear prediction

    用matlab去實現mixed excitation linear prediction

    标签: excitation prediction matlab linear

    上传时间: 2013-12-09

    上传用户:妄想演绎师

  • 基于DSP的新型柴油发电机励磁控制系统研究

    在综合分析谐波励磁无刷同步发电机励磁控制系统的基础上,对其励磁控制策略进行了研究,开发了一套基于DSP( TMS320F2812) 控制的新型柴油发电机励磁控制系统,该系统采用参数自适应模糊PID 控制励磁,选用交流采样方式实时检测各信号的瞬时特性,系统仿真结果以及在1 台25 kW 工频柴油发电机上的试验结果证明了该控制器具有较好的电压调节特性,系统稳态和暂态性能完全满足发电机对励磁系统的要求。关键词:励磁调节;模糊PID 控制;数字信号处理器;交流采样 Abstract :According to the general analysis of the excitation cont rol system of the harmonious wave excitation brushless synchronous generator and it s characteristics ,a new type of diesel generator excitation cont rol system based on DSP( TMS320F2812) was designed. An adaptive fuzzy PID cont rol of excitation is used in this system. To detect the t ransient characteristics of the signals in a timely manner ,AC sampling was applied.The system simulation result s and the testing result s f rom a 25 kW diesel generator (50 Hz) can prove that the voltage regulation characteristics of the excitation cont rol system are very well ,and both the steadyOstate performance and the t ransient performance of the generator are also good.Key words :excitation cont rol ;fuzzy PID cont rol ;digital signal processor (DSP) ;AC sampling

    标签: DSP 柴油发电机 励磁控制 系统研究

    上传时间: 2013-10-29

    上传用户:fxf126@126.com

  • A new cable fault location method based on wavelet reconstruction is proposed. In this method the

    A new cable fault location method based on wavelet reconstruction is proposed. In this method the difference between the currents of faulty phase and sound phase under the high voltage pulse excitation is used as the measured signal and is decomposed in multi-scale by wavelet transform, then reconstructed in single scale. Comparing with traditional fault location method by travelling wave, the presented method will not be interfered by the reflected wave from the branch joint of cables or from other positions where the impedances are not matched and not be influenced by fault types, otherwise, the reflected waves can be recognized even the faulty position is near to the measuring terminal, at the same time, the influence of the wave speed uncertainty can be reduced. The correctness of the proposed method is proved by simulation results.

    标签: method reconstruction location proposed

    上传时间: 2016-02-03

    上传用户:maizezhen

  • ISO11452-4-2011 标准文件

    Road vehicles -- Component test methods for electrical disturbances from narrowband radiated electromagnetic energy -- Part 4: Harness excitation methods

    标签: iso11452 标准

    上传时间: 2022-04-26

    上传用户:qingfengchizhu