虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

altium <b>design</b>er

  • b Rew book for brew phone design

    b Rew book for brew phone design

    标签: design phone book brew

    上传时间: 2016-05-07

    上传用户:liuchee

  • The Design and Evolution of C++ 国外经典C++原版书库《C++语言的设计和演化》/(美)斯特郎斯特鲁普(Stroustrup,B)著;裘宗燕等译 十分经典、难得!

    The Design and Evolution of C++ 国外经典C++原版书库《C++语言的设计和演化》/(美)斯特郎斯特鲁普(Stroustrup,B)著;裘宗燕等译 十分经典、难得!

    标签: Stroustrup Evolution Design The

    上传时间: 2016-08-17

    上传用户:chenlong

  • Data Structures and Algorithms with Object-Oriented Design Patterns in Java Bruno R. Preiss B.A.S

    Data Structures and Algorithms with Object-Oriented Design Patterns in Java Bruno R. Preiss B.A.Sc., M.A.Sc., Ph.D., P.Eng. Associate Professor Department of Electrical and Computer Engineering University of Waterloo, Waterloo, Canada

    标签: B.A.S R. Object-Oriented Algorithms

    上传时间: 2017-03-07

    上传用户:z754970244

  • CDMA mobile radio design Jon B. Groe Lawrence E. Larson

    CDMA mobile radio design Jon B. Groe Lawrence E. Larson

    标签: B. E. Lawrence mobile

    上传时间: 2017-03-31

    上传用户:lz4v4

  • USB扁口接口TP4055锂离子电池充电接口板ALTIUM设计硬件原理图+PCB文件 2层B板手设计

    5V USB扁口接口TP4055锂离子电池充电接口板ALTIUM设计硬件原理图+PCB文件,2层B板手设计,大小为33*18mm,,可以做为你的学习设计参考。TP4055 是一款完整的单节锂离子电池充电器,带电池正负极反接保护,采用恒定 电流/恒定电压线性控制。其 SOT 封装与较少的外部元件数目使得 TP4055 成为便携式应 用的理想选择。TP4055 可以适合 USB 电源和适配器电源工作。 由于采用了内部 PMOSFET 架构,加上防倒充电路,所以不需要外部检测电阻器和 隔离二极管。热反馈可对充电电流进行自动调节,以便在大功率操作或高环境温度条件 下对芯片温度加以限制。充满电压固定于 4.2V,而充电电流可通过一个电阻器进行外部 设置。当电池达到 4.2V 之后,充电电流降至设定值 1/10,TP4055 将自动终止充电。 当输入电压(交流适配器或 USB 电源)被拿掉时,TP4055 自动进入一个低电流状 态,电池漏电流在 2uA 以下。TP4055 的其他特点包括充电电流监控器、欠压闭锁、自 动再充电和一个用于指示充电结束和输入电压接入的状态引脚。

    标签: usb 接口 tp4055

    上传时间: 2021-11-22

    上传用户:trh505

  • 基于单片机的数字化B超键盘设计

    针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS,提出一种PS2键盘的设计方法。基于W78E052D单片机,采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路,电位器位置信息以键盘扫描码序列形式发送,正交编码器信号通过XC9536XL转换为单片机可接收的中断信号,软件接收到中断信息后等效处理成按键。结果表明,在满足开机可设置BIOS同时,又可实现超声特有功能,不需要专门设计驱动程序,接口简单,成本低。 Abstract:  Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot, this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller,designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter, potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU, software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot, ultrasound specific functionality can be achieved at the same time, it does not require specially designed driver,the interface is simple and low cost.    

    标签: 单片机 B超 数字化 键盘设计

    上传时间: 2013-10-10

    上传用户:asdfasdfd

  • mpeg test inter b. Dequantizer Algorithm hardware realization method and comparison c. Dequantize

    mpeg test inter b. Dequantizer Algorithm hardware realization method and comparison c. Dequantizer Hardware Architecture Design

    标签: b. c. Dequantizer realization

    上传时间: 2016-01-29

    上传用户:450976175

  • 21世纪大学新型参考教材系列 集成电路B 荒井

    21世纪大学新型参考教材系列 集成电路B 荒井

    标签: 大学 教材 集成电路

    上传时间: 2013-04-15

    上传用户:eeworm

  • 家电维修(最基础的教程B)1-20.Torrent

    家电维修(最基础的教程B)1-20.Torrent

    标签: Torrent 20 家电维修 教程

    上传时间: 2013-06-10

    上传用户:eeworm

  • jk-b交通信号控制机原理图

    jk-b交通信号控制机原理图

    标签: jk-b 交通信号 控制机 原理图

    上传时间: 2013-07-13

    上传用户:eeworm