虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

ac-dc-AC

  • 基于PIC16C71的数字水温配制阀的设计

      设计了一种基于PIC16C71单片机的数字水温配制阀。该配制阀采用NTC热敏电阻作温度传感器,与固定电阻组成简单分压电路作为水温测量电路,利用PIC16C71单片机内置的8位A/D转换器把热敏电阻上的模拟电压转换为数字量,PIC16C71单片机控制直流电机驱动混水阀调节冷热水的混合比例实现水温调节。给出了控制电路图,对水温测量电路的参数选择和测温精度作了详细讨论。实验和分析表明,选用阻值较大的NTC热敏电阻和分压电阻可较好地解决热敏电阻因功耗较大造成的热击穿问题。   Abstract:   A digital valve for controlling water temperature based on PIC16C71 was presented in this paper.A bleeder circuit which consisted of a NTC thermistor as temperature sensor and a fixed resistance was designed as water temperature measuring circuit.The analog voltage on the thermistor was converted into digital signal by a 8-bit A/D converter embedded in PIC16C71. Based on the digital signal, the MCU PIC16C71 drived the valve by a DC motor to adjust the water temperature through adjusting the proportion of hot water and cold water.The circuit diagram of controller was given,the principle,the component parameters and the accuracy of measuring temperatures were also dissertated in detail. It was found by experiment and analysis that thermal breakdown of thermistor caused by high power could be solved by selecting thermistor and fixed resistance with high impedance value.

    标签: PIC 16C C71 16

    上传时间: 2013-11-08

    上传用户:Yue Zhong

  • 基于ATmega16的标记机控制系统

    介绍了当前普通标记机控制系统现状及其存在缺点,给出气动标记机及相频修正PWM模式的工作原理。采用ATmega16单片机和USB转换RS232接口器件CH341T实现驱动控制系统与PC的实时通讯,标记控制系统可升级到USB接口。采用基于ATmega16的相频修正PWM替换555振荡电路产生的PWM,可直接通过软件调整PWM信号。使用达林顿三极管TIP122替代直流继电器驱动高频电磁阀,使得电磁阀驱动电路简单,成本低廉。该控制系统已成功应用于气动标记机。 Abstract:  In this paper,the actuality and demerit of the common gas marking machine control systems are described.The operation principle of the gas marking machine and the phase and frequency correct PWM of ATmega16is introduced.The real-time communication between the driving control system and PC by CH341T which its function is translated USB to RS232is realized,the control systems is updated grade to USB interface.The PWM signal can be adjustable by software for the555surge circuit was substituted by the phase and frequency.The high frequency electromagnetic value’s driving circuit by DC relay is replaced by TIP122,therefore,the circuit is become simple and the cost cheap.The control systems has been widely used in gas marking machine.

    标签: ATmega 16 标记 控制系统

    上传时间: 2013-10-18

    上传用户:1427796291

  • 2.4GHz PTR4000无线嵌入式模块高速率1Mbps、

    产品特性2.4Ghz全球开放ISM频段,免许可证使用最高工作速率1Mbps,高效GMSK调制,抗干扰能力强,特别适合工业控制场合125频道,满足多点通信和跳频通信需要内置硬件CRC检错和点对多点通信地址控制低功耗1.9~3.6V工作Power Down模式下状态仅为1uA内置2.4Ghz天线,体积小巧约24x24mm不包括天线模块可软件设地址,只有收到本机地址时才会输出数据(提供中断指示,可直接接各种单片机使用,软件编程非常方便内置专门稳压电路,使用各种电源包括DC/DC开关电源均有很好的通信效果标准DIP间距接口便于嵌入式应用PTR4000-Quick-DEV快速开发系统,含开发板、源代码、原理图等详细资料,即开即用,上手快,缩短您的开发时间

    标签: 1Mbps 4000 2.4 GHz

    上传时间: 2013-10-12

    上传用户:sz_hjbf

  • 基于ATmega48的3相无刷电机的控制方法

    介绍了采用ATmega48单片机实现三相无刷直流电机控制器的方法。利用Atmega48获得带死区的脉宽调制(PWM)、霍尔传感器的换相处理、正弦驱动信号的产生和电机转速的控制等功能。采用该方法的优点是所需的外围器件少,成本低。 Abstract:  The method of 3-phase brushless DC motor control based on ATmega48 is presented in this paper.The system uses ATmega48 to generate PWM signals with dead-time, hall sensors signals commutation,sine driving signal and rotational speed of motor.Using this method,the needed external devices are few, the cost is low.

    标签: ATmega 48 无刷电机 控制方法

    上传时间: 2013-12-09

    上传用户:330402686

  • LPC900系列单片机电源电路的设计

    LPC900 系列芯片在低电压环境下工作,适合低功耗应用。通过 Sipex 公司的 DC/DC buck 稳压器,DC/DC boost 稳压器,LDO 型稳压器,我们可以轻松实现各种低电压供给电路,满足您的各种应用。ZLG 公司为客户提供全系列微控制器电源电路解决方案。

    标签: LPC 900 单片机 电源电路

    上传时间: 2014-12-27

    上传用户:yunfan1978

  • TinyM0_Routine

    TinyM0配套教程】    * 【TinyM0配套教程】接口技术与可靠性设计(I2C器件应用方案)    * 【TinyM0配套教程】LPC1100系列Cortex-M0最小系统设计      * 【TinyM0配套教程】功能部件(SSP)     * 【TinyM0配套教程】接口技术与可靠性设计(UART器件应用方案)    * 【TinyM0配套教程】接口技术与可靠性设计(串行NOR Flash存储方案)    * 【TinyM0配套教程】硬件体系结构(存储器寻址)      * 【TinyM0配套教程】硬件体系结构(功率控制)     * 【TinyM0配套教程】硬件体系结构(时钟系统)     * 【TinyM0配套教程】功能部件(LPC1100系列器件简介、引脚连接模块、GPIO)    * 【TinyM0配套教程】功能部件(定时器计数器)     * 【TinyM0配套教程】接口技术与可靠性设计(DC/DC应用指南)    * 【TinyM0配套教程】硬件体系结构(系统节拍定时器)     * 【TinyM0配套教程】硬件体系结构(系统控制模块)      * 【TinyM0配套教程】接口技术与可靠性设计(ESD器件应用指南)    * 【TinyM0配套教程】功能部件(I2C)      * 【TinyM0配套教程】功能部件(WDT)      * 【TinyM0配套教程】功能部件(ADC)     * 【TinyM0配套教程】功能部件(UART)       * 【TinyM0配套教程】接口技术与可靠性设计(LDO应用指南)    * 【TinyM0配套教程】接口技术与可靠性设计(复位设计)

    标签: Routine TinyM

    上传时间: 2013-11-01

    上传用户:litianchu

  • KS-0825用户接口电路模块

    KS-0825 系列用户接口电路模块(RINGSLIC MODULE)采用模块化结构,在单个模块上集成了DC/DC 变换器、正反极开关、恒流馈电电路、二/四线变换电路、450Hz 正旋波发生器等用户接口系统需要的所有功能,使小用户话音系统的设计变得极为简单,用户只需要提供+5V 直流电源,即可实现小用户话音系统所必需的恒流馈电、振铃、二/四线变换、等功能;同时可以大幅度降低系统体积,降低成本。

    标签: 0825 KS 用户接口 电路模块

    上传时间: 2013-11-12

    上传用户:894448095

  • 嵌入式CAN转UART模块 CSM100系列产品手册

    嵌入式CAN转UART模块 CSM100系列产品手册 CSM100系列UART转CAN 模块是集成微处理器、CAN-bus控制器、CAN-bus收发器、DC-DC转换、高速光电隔离于一体的嵌入式CAN转UART模块。

    标签: UART CAN 100 CSM

    上传时间: 2014-01-03

    上传用户:caixiaoxu26

  • SCY99090应用指南

    本文着重介绍高效低纹波DC-DC降压稳压器SCY99090的特性、典型应用电路、电路中元器件的选型以及PCB的布局。

    标签: 99090 SCY 应用指南

    上传时间: 2014-12-27

    上传用户:swaylong

  • XL6003 300KHz 36V Boost 3W LED

    The XL6003 regulator is fixed frequency PWM Boost (step-up) DC/DC converter, capable ofdriving 1050mA load current with excellent line and load regulation. The regulator is simple to use because it includes internal frequency compensation and a fixed-frequency oscillator so that it requires a minimum number of external components to work. The XL6003 could directly drive 5~10 3W LED units at VIN=12V.

    标签: Boost 6003 300 36V

    上传时间: 2013-11-07

    上传用户:xy@1314