Recover 4 all Pro v2.25 汉化版
上传时间： 2015-02-10
上传用户：362279997
costas_loop can Recover phase
标签： costas_loop Recover phase can
上传时间： 2016-07-26
上传用户：Divine
it is a program on LABVIEW inorder to Recover the channel estimation with error or without error
标签： error estimation LABVIEW inorder
上传时间： 2017-03-24
上传用户：李梦晗
Aircrack-ng is an 802.11 WEP and WPA-PSK keys cracking program that can Recover keys once enough data packets have been captured. It implements the standard FMS attack along with some optimizations like KoreK attacks, as well as the all-new PTW attack, thus making the attack much faster compared to other WEP cracking tools. In fact, Aircrack-ng is a set of tools for auditing wireless networks.
标签： keys Aircrack-ng cracking WPA-PSK
上传时间： 2013-12-25
上传用户：bruce
QPSK modulation system with Recover loops
标签： modulation Recover system loops
上传时间： 2013-12-20
上传用户：李梦晗
Decompilation Dos Program is a technique that allows you to Recover lost source code. It is also needed in some cases for computer security.
标签： Decompilation technique Program Recover
上传时间： 2013-12-26
上传用户：linlin
The PCA9549 provides eight bits of high speed TTL-compatible bus switching controlledby the I2C-bus. The low ON-state resistance of the switch allows connections to be madewith minimal propagation delay. Any individual A to B channel or combination of channelscan be selected via the I2C-bus, determined by the contents of the programmable Controlregister. When the I2C-bus bit is HIGH (logic 1), the switch is on and data can flow fromPort A to Port B, or vice versa. When the I2C-bus bit is LOW (logic 0), the switch is open,creating a high-impedance state between the two ports, which stops the data flow.An active LOW reset input (RESET) allows the PCA9549 to Recover from a situationwhere the I2C-bus is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-busstate machine and causes all the bits to be open, as does the internal power-on resetfunction.
上传时间： 2014-11-22
上传用户：xcy122677
The PCA9548A is an octal bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to eight downstream pairs, or channels. Any individualSCx/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.An active LOW reset input allows the PCA9548A to Recover from a situation where one ofthe downstream I2C-buses is stuck in a LOW state. Pulling the RESET pin LOW resets theI2C-bus state machine and causes all the channels to be deselected as does the internalPower-on reset function.
上传时间： 2013-10-13
上传用户：bakdesec
tServer task executes functions at low priority (254). serverSend funtion is used to send a request to the tServer to execute a function at the tServer s priority. First tServer task executes the i() system call to print the summary of tShell task. Next an address exception is caused in tServer task by trying to execute a funtion at non-aligned word boundry. As a result SIGBUS signal is raised automatically. Signals (setjmp() and longjmp()) are used to allow the tServer task to Recover gracefully from an address error exception. For more information about signals, please refer to sigLib manual pages.
标签： serverSend functions executes priority
上传时间： 2015-09-21
上传用户：tianjinfan
基于TMS320F2812 光伏并网发电模拟装置PROTEL设计原理图+PCB+软件源码+WORD论文文档,硬件采用2层板设计，PROTEL99SE 设计的工程文件，包括完整的原理图和PCB文件，可以做为你的学习设计参考。 摘要：本文实现了一个基于TMS320F2812 DSP芯片的光伏并网发电模拟装置，采用直流稳压源和滑动变阻器来模拟光伏电池。通过TMS320F2812 DSP芯片ADC模块实时采样模拟电网电压的正弦参考信号、光伏电池输出电压、负载电压电流反馈信号等。经过数据处理后，用PWM模块产生实时的SPWM 波，控制MOSFET逆变全桥输出正弦波。本文用PI控制算法实现了输出信号对给定模拟电网电压的正弦参考信号的频率和相位跟踪，用恒定电压法实现了光伏电池最大功率点跟踪（MPPT），从而达到模拟并网的效果。另外本装置还实现了光伏电池输出欠压、负载过流保护功能以及光伏电池输出欠压、过流保护自恢复功能、声光报警功能、孤岛效应的检测、保护与自恢复功能。系统测试结果表明本设计完全满定设计要求。关键词：光伏并网，MPPT，DSP Photovoltaic Grid-connected generation simulator Zhangyuxin，Tantiancheng，Xiewuyang(College of Electrical Engineering, Chongqing University)Abstract: This paper presents a photovoltaic grid-connected generation simulator which is based on TMS320F2812 DSP, with a DC voltage source and a variable resistor to simulate the characteristic of photovoltaic cells. We use the internal AD converter to real-time sampling the referenced grid voltage signal, outputting voltage of photovoltaic, feedback outputting voltage and current signal. The PWM module generates SVPWM according to the calculation of the real-time sampling data, to control the full MOSFET inverter bridge output sine wave. We realized that the output voltage of the simulator can track the frequency and phase of the referenced grid voltage with PI regulation, and the maximum photovoltaic power tracking with constant voltage regulation, thereby achieved the purpose of grid-connected simulation. Additionally, this device has the over-voltage and over-current protection, audible and visual alarm, islanding detecting and protection, and it can Recover automatically. The testing shows that our design is feasible.Keywords: Photovoltaic Grid-connected，MPPT，DSP 目录引言 11. 方案论证 11.1. 总体介绍 11.2. 光伏电池模拟装置 11.3. DC-AC逆变桥 11.4. MOSFET驱动电路方案 21.5. 逆变电路的变频控制方案 22. 理论分析与计算 22.1. SPWM产生 22.1.1. 规则采样法 22.1.2. SPWM 脉冲的计算公式 32.1.3. SPWM 脉冲计算公式中的参数计算 32.1.4. TMS320F2812 DSP控制器的事件管理单元 42.1.5. 软件设计方法 62.2. MPPT的控制方法与参数计算 72.3. 同频、同相的控制方法和参数计算 8
标签： tms320f2812 光伏 并网发电 模拟 protel pcb
上传时间： 2021-11-02
上传用户：ooaaooxx
