虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

RFID-<b>Chip</b>-Manipulation

  • NTC计算公式 温度公式B值计算法

    描述了NTC使用B值计算出实际温度与输出的电压之间的关系。

    标签: ntc计算

    上传时间: 2022-06-15

    上传用户:

  • Quectel Wireless Solutions BC20-TE-B 原理图 V1.2

    BC20-TE-B NB-Iot 评估板评估板原厂原理图V1.2。完整对应实物装置。

    标签: BC20 NB-Iot Quectel

    上传时间: 2022-06-17

    上传用户:

  • ASR M08-B资料

    ASR M08-B设置软件 V3.2  arduino 2560+ASRM08-B测试程序  arduino UNO+ASRM08-B测试程序语音控制台灯电路图及C51源码(不带校验码) 继电器模块设置。   ASR M08-B是一款语音识别模块。首先对模块添加一些关键字,对着该模块说出关键字,串口会返回三位的数,如果是返回特定的三位数字,还会引起ASR M08-B的相关引脚电平的变化。【测试】①打开“ASR M08-B设置软件 V3.2.exe”。②选择“串口号”、“打开串口”、点选“十六进制显示”。③将USB转串口模块连接到语音识别模块上。接线方法如下:语音模块TXD --> USB模块RXD语音模块RXD --> USB模块TXD语音模块GND --> USB模块GND语音模块3V3 --> USB模块3V3(此端为3.3V电源供电端。)④将模块的开关拨到“A”端,最好再按一次上面的大按钮(按一次即可,为了确保模块工作在正确的模式)。⑤对着模块说“开灯”、“关灯”模块会返回“0B”、“0A”,表示正常(注意:0B对应返回值010,0B对应返回值010,返回是16进制显示的嘛,设置的时候是10进制设置的)。

    标签: ASR M08-B

    上传时间: 2022-07-06

    上传用户:aben

  • 基于单片机和基站器件EM4095的手持式低频RFID读卡器

    介绍一种采用单片机技术和基站器件EM4095的手持式低频RFID读卡器方案。首先对整个系统框架进行说明,然后介绍主要功能模块的设计,给出了各模块的原理图。重点描述了基站器件EM4095的性能参数和功能原理,最后描述了该系统的主程序流程图。 Abstract:  In this paper,a handheld RFID reader based on MCU and EM4095 is introduced.At first,the configuration of this system is explained.Then the design of main modules and schematic documents are particularly presented.The parameters and principle of the chip EM4095 are introduced in detail. At last,the main software flow is given

    标签: 4095 RFID EM 单片机

    上传时间: 2013-10-18

    上传用户:windypsm

  • The Original USB 2.0 specification released on April 27, 2000 Errata to the USB 2.0 specification

    The Original USB 2.0 specification released on April 27, 2000 Errata to the USB 2.0 specification as of December 7, 2000 Mini-B connector Engineering Change Notice to the USB 2.0 specification. Pull-up/pull-down Resistors Engineering Change Notice to the USB 2.0 specification. Errata to the USB 2.0 specification as of May 28, 2002 Interface Association Descriptor Engineering Change Notice to the USB 2.0 specification. Rounded Chamfer Engineering Change Notice to the USB 2.0 specification as of October 8, 2003 Unicode Engineering Change Notice to the USB 2.0 specification as of February 21, 2005 Inter-Chip USB Supplement Revision 1.0 as of March 13, 2006 Revision 1.3 of the USB On-The-Go Supplement as of December 5, 2006 Revision 1.01 of the Micro-USB Cables and Connectors Specification as of April 4, 2007 USB 2.0 Link Power Management Addendum Engineering Change Notice to the USB 2.0 specification as of July 16, 2007.

    标签: specification 2.0 USB Original

    上传时间: 2013-12-31

    上传用户:familiarsmile

  • 915MHz超高频RFID阅读器射频前端电路设计

    为了提高超高频RFID系统中阅读器在低信噪比的情况下仍具有较高的识别能力,提出一种基于FPGA系统结合软件无线电方法实现超高频RFID射频前端电路方案。超高频射频识别系统必须符合EPC Class 1generation 2标准,所设计的电路系统以Xilinx公司的XC6SLX16-2CSG324FPGA芯片为硬件基础,将数字基带调制解调和中频滤波电路在FPGA系统中设计实现,重点阐述了射频前端电路的设计结构、AD/DA转换电路,以及数字滤波器的设计。实验结果表明,所设计的超高频RFID阅读器简化了前端电路系统结构,提升了稳定性,增强了抗干扰能力。该电路系统在信噪比较低的情况下,能够较好地实现915MHz频率的射频接收和发送。In order to improve the reader UHF RFID system still has a higher ability to identify,in the case of low signal-to-noise ratio.The UHF RFID systems must comply with EPC Class 1 generation 2 standard.In this paper,the design of the circuit system based on Xilinx's XC6SLX16-2CSG324 FPGA chip,and presents UHF RFID RF front-end circuit with software radio based on FPGA system.Digital baseband modem and IF filter circuit is designed and implemented in the FPGA system,and focused on designing the structure of the RF front-end circuit,AD/DA conversion circuits,and digital filter.Experimental results show that the UHF RFID reader de...

    标签: 915mhz 超高频 rfid 阅读 射频 前端 电路 设计

    上传时间: 2022-04-17

    上传用户:shjgzh

  • sony CMOS传感器 IMX385LQR-C DataSheet

    DescriptionThe IMX385LQR-C is a diagonal 8.35 mm (Type 1/2) CMOS active pixel type solid-state image sensor with a squarepixel array and 2.13 M effective pixels. This chip operates with analog 3.3 V, digital 1.2 V, and interface 1.8 V triplepower supply, and has low power consumption. High sensitivity, low dark current and no smear are achieved throughthe adoption of R, G and B primary color mosaic filters. This chip features an electronic shutter with variablecharge-integration time.(Applications: Surveillance cameras)

    标签: CMOS传感器 IMX385LQR-C

    上传时间: 2022-06-18

    上传用户:

  • sony CMOS传感器 IMX178LQJ-C dataSheet

    sony CMOS传感器datasheet,IMX178LQJ-C_Data_SheetDescriptionThe IMX178LQJ-C is a diagonal 8.92 mm (Type 1/1.8) CMOS active pixel type image sensor with a square pixelarray and 6.44 M effective pixels. This chip operates with analog 2.9 V, digital 1.2 V and interface 1.8 V triple powersupply, and has low power consumption.High sensitivity, low dark current and no smear are achieved through the adoption of R, G and B primary colormosaic filters.This chip features an electronic shutter with variable charge-integration time.(Applications: Surveillance cameras, FA cameras, Industrial cameras)

    标签: CMOS传感器 IMX178LQJ-C

    上传时间: 2022-06-18

    上传用户:

  • 无线电安全攻防大揭秘

        本书着眼于无线通信安全领域,以无线通信距离由近及远的顺序,讨论各种无线通信系统的安全问题。协议分析结合攻防实例,深入介绍安全攻防技术。案例题材囊括物联网、车联网、移动通信、卫星导航及相关的软硬件安全。本书共分 9 章,其中第 1 章介绍作者在无线安全攻防领域多年来的思路、理念及对该领域未来的展望;第 2~8 章分别介绍各种无线通信系统的安全攻防(RFID、无线遥控、ADS-B、BLE、ZigBee、移动通信、卫星通信等)及实例测试;第9 章介绍无线安全研究的重要手段,软件无线电工具GNU Radio和相关硬件的详细使用。希望本书可以为对无线通信安全感兴趣的同学、从业者、产品研发人员提供有价值的安全参考。

    标签: 无线电

    上传时间: 2022-07-11

    上传用户:

  • sky1311读卡芯片最新开发包

    SKY1311T是一款应用于13.56MHz RFID系统非接触式读写设备芯片,支持 ISO14443Type A/B 标准协议。可读身份证。目前国内唯一一颗稳定支持低功耗检卡的芯片,功耗5ua以内。自主知识产权,外围简单,不需电感,已过EMV认证。

    标签: sky1311 读卡芯片 NFC

    上传时间: 2022-07-23

    上传用户: