随着光伏发电系统快速发展,以及电动汽车充电桩的普及,传统的剩余电流保护器无法满足实际需求。介绍了一款B型剩余电流保护器,采用磁调制剩余电流互感器和零序电流互感器采集剩余电流。根据GB/T 22794—2017标准要求,可识别1 kHz及以下的正弦交流、带和不带直流分量的脉动直流、平滑直流等剩余电流信号。经信号调理电路将电压信号送到单片机进行采集和判断。通过试验测试,该样机在测试精度和速度上均符合国家标准的相关要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper Proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
标签： 电流保护器
上传时间： 2022-03-27
上传用户：
锂电池BMS管理技术是移动机器人的关键技术,本文设计了基于bq76PL455、STM32F103的锂电池管理系统,实现了电池组电压、电流、过压、过流等状态监测;系统配置均衡电路,电池充电过程中若出现电池单体电压不平衡现象,会触发均衡电路,进而提高电池的安全性,延长使用寿命。Lithium battery BMS management technology is the key technology of mobile robot.The lithium battery management system based on bq76PL455 and STM32F103 is Proposed to realize the monitoring of battery pack voltage,current,overvoltage and overcurrent.The system is equipped with equalization circuit.When the battery cell voltage imbalance occurs,the equalization circuit is triggered to improve the safety and service life of the battery.
上传时间： 2022-04-02
上传用户：
为适应双向DC/DC功率变换的电流采样需求,一种高精度高边电流采样电路被提出。其基本思想是在功率电路的高边串入采样电阻,借助电流镜原理并引入偏置电流电路,将双向电流均转换为正向电压输出。通过理论分析与仿真结合的方法对电流镜采样原理及4种不同的偏置电流电路方案进行对比,最后通过实验数据验证了高精度高边电流采样电路的有效性。实验数据表明,该采样电路可在-25~75℃的温度工作范围内,针对-10~＋10 A范围内的电流采样实现优于5%的采样精度。Current sensing plays an important role in controlling,monitoring or protection functions of power systems.To meet the current sensing requirement of bidirectional DC/DC converters,a high-accuracy bidirectional current sensing circuit is Proposed.The Proposed current sensing circuit inserts a resistor in the path of the current to be sensed,while the current mirror and biased current circuit are introduced.Therefore,the bidirectional current can be expressed by positive voltage.By theoretical analysis and simulation,the sampling theory is analyzed and four biased current circuits are compared.At last,experimental results verified the Proposed method.It is demonstrated that the Proposed current sensing circuit can achi...
上传时间： 2022-04-22
上传用户：
本文提出基于AD2S1210的旋变信号转换电路,给出了具体的电路实现方法和配置方法.相比以往的RDC方案,本系统具有精度高,设计灵活,可靠性高等特点,可广泛应用于各种伺服系统中.In this paper, the switching signal conversion circuit based on ADS1210 is Proposed, and the specific circuit implementation and configuration method are given. Compared with the previous RDC scheme, this system has the characteristics of high precision, flexible design and high reliability, and can be widely used in various servo systems.
标签： ad2s1210
上传时间： 2022-05-04
上传用户：
数字频率计是电工电子中常用的测量仪器,数字频率计通过用输入待测信号对一特定长度的信号进行计数,从而得出频率并通过数码管直观的显示出来。本文提出了一种与输入同步的数字频率计的设计,提高了频率计的精度,设计采用Multisim软件进行设计和仿真的过程,介绍了其工作原理,硬件电路设计和仿真的过程。设计采用了Multisim软件进行设计和仿真,设计结果得到的验证。Digital frequency counter is used to measure the frequency of a signal.It is common to use a multivibrator to generate a standard 1 second time base signal and count input signal gated by this signal.However,the asynchronous of this time base signal with input signal will bring errors.In this paper,a high precision frequency counter which use synchronized time base signal generator is Proposed.This frequency counter is designed and simulated by Multisim tools and result is verified.
标签： multisim
上传时间： 2022-05-08
上传用户：
Abstract: A sliding mode observer and fractional-order phase-locked loop (FO-PLL) method is Proposed for the sensorless speed control of a permanent magnet synchronous motor (PMSM).The saturation function is adopted in order to reduce the chattering phenomenon caused by the sliding mode observer. In this Proposed FO-PLL, method, a regulable fractional order r is involved, which means that the FO-PLL provides an extra degree of freedom. In fact, the conventional phase-locked loop (PLL) applied in sensorless PMSM control can be seen as a special case of the Proposed FO-PLL. By selecting a proper fractional order r a better performance may be achieved. The computer simulation results demonstrate the effectiveness of the Proposed method.Key words: fractional calculus; fractional order phase-locked loop; sensorless control; sliding mode observer; permanent magnet synchronous motor; speed controll
上传时间： 2022-06-18
上传用户：
