阻抗匹配 阻抗匹配（Impedance matching）是微波电子学里的一部分，主要用于传输线上，来达至所有高频的微波信号皆能传至负载点的目的，不会有信号反射回来源点，从而提升能源效益。 大体上，阻抗匹配有两种，一种是透过改变阻抗力（lumped-circuit matching），另一种则是调整传输线的波长（transmission line matching）。 要匹配一组线路，首先把负载点的阻抗值，除以传输线的特性阻抗值来归一化，然后把数值划在史密夫图表上。 把电容或电感与负载串联起来，即可增加或减少负载的阻抗值，在图表上的点会沿著代表实数电阻的圆圈走动。如果把电容或电感接地，首先图表上的点会以图中心旋转180度，然后才沿电阻圈走动，再沿中心旋转180度。重覆以上方法直至电阻值变成1，即可直接把阻抗力变为零完成匹配。 由负载点至来源点加长传输线，在图表上的圆点会沿著图中心以逆时针方向走动，直至走到电阻值为1的圆圈上，即可加电容或电感把阻抗力调整为零，完成匹配.........
标签： 阻抗匹配
上传时间： 2013-10-20
上传用户：ZOULIN58
标签： nbsp Transmission Line Ca
上传时间： 2013-11-14
上传用户：defghi010
Abstract: As industrial control systems (ICSs) have become increasingly connected and use more off-the-shelfcomponents, new vulnerabilities to cyber attacks have emerged. This tutorial looks at three types of ICSs:programmable logic controllers (PLCs), supervisory control and data acquisition (SCADA) systems, anddistributed control systems (DCSs), and then discusses security issues and remedies. This document alsoexplains the benefits and limitations of two cryptographic solutions (digital signatures and encryption) andelaborates on the reasons for using security ICs in an ICS to support cryptography.
上传时间： 2013-10-09
上传用户：woshinimiaoye
Have you had the exasperating experience of a laptop orPDA defi antly not responding to your commands? Youfrantically press key after key, but to no avail. As hopeturns to anger (but just before you throw the company’slaptop through the window) you slam your fi nger againstthe on/off power button. Ten seconds later, your laptopfi nally surrenders and the screen goes black in a highpitched whimper.
上传时间： 2013-12-10
上传用户：Vici
Accurate measurement of the third order intercept pointfor low distortion IC products such as the LT5514 requirescertain precautions to be observed in the test setup andtesting procedure. The LT5514 linearity performance ishigh enough to push the test equipment and test set-up totheir limits. A method for accurate measurement of thirdorder intermodulation products, IM3, with standard testequipment is outlined below.It is also important to correctly interpret the LT5514specification with respect to ROUT, and the impact ofdemo-board transmission-line termination loss whenevaluating the linearity performance, as explained in theLT5514 Datasheet and in Note 1 of this document.
上传时间： 2013-11-14
上传用户：l254587896
QX5305 是一款高效率，稳定可靠的高亮度LED灯驱动控制IC，内置高精度比较器，off-time控制电路，恒流驱动控制电路等，特别适合大功率，多个高亮度LED灯串恒流驱动。 QX5305采用固定off-time控制工作方式，其工作频率可高达2.5MHz，可使外部电感和滤波电容、体积减少，效率提高。 在DIM脚加PWM信号，可调节LED灯的亮度。 通过调节外置的电阻，能控制高亮度LED灯的驱动电流，使LED灯亮度达到预期恒定亮度，流过高亮度LED灯的电流可从几毫安到2安培变化。 方框图： 管脚排列图： QX5305的特性 可编程驱动电流，最高可达2A 高效率：最高达95% 宽输入电压范围：2.5V~36V 高工作频率：2.5MHz 工作频率可调：500KHz~2.5MHz 驱动LED灯功能强：LED灯串可从1个到几十个LED高亮度灯 亮度可调：通过EN端PWM，调节LED灯亮度 QX5305应用范围 干电池供电LED灯串 LED灯杯 RGB大显屏高亮度LED灯 平板显示器LED背光灯 恒流充电器控制 通用恒流源。 工作原理简述： QX5305 采用峰值电流检测和固定off-time控制方式。片内的R-S触发器分别由off-time定时器置位和CS比较器、FB比较复位，它控制外部MOSFET管并和功率电感 L、LED、肖特基二极管共同构成一个自振荡的，连续电感电流模式的升压型恒流LED驱动电路（参见图1）。 除了固定off-time控制这点外，QX5305的工作方式和普通的电流模式PWM控制型DC/DC升压电路非常相似。当工作在连续电流模式下时，流过功率电感的电流IL如图所示：
上传时间： 2013-10-26
上传用户：TF2015
a Java program that reads a file containing instructions written in self-defined file (TPL in this case), and executes those instructions. This program should take the name of the TPL file as a command line parameter, and write its output to the console.
标签： file instructions self-defined containing
上传时间： 2015-01-11
上传用户：曹云鹏
8051微控制器上的 DES encryption/decryption used in IC smart cards. Software hasn t been validated and lacks in-line documentation.
标签： encryption decryption validated Software
上传时间： 2015-01-13
上传用户：wangdean1101
项目描述: slsnif is a serial port logging utility. It listens to the specified serial port and logs all data going through this port in both directions. Serial line sniffer是一个串行端口记录工具。它监听指定的串行端口并记录所有通过这个端口的两个方向的数据。 来源：http://freshmeat.net slsnif是一个串行端口日志工具。它监听特殊的串口，记录所有通过这具串口的两个方向的数据。 类别: Development Status: 5 - Production/StableEnvironment: Console (Text Based)Intended Audience: DevelopersLicense: GNU General Public License (GPL)Operating System: LinuxProgramming Language: CTopic: Communications, Debuggers
标签： serial port specified logging
上传时间： 2014-01-17
上传用户：许小华
项目描述: slsnif is a serial port logging utility. It listens to the specified serial port and logs all data going through this port in both directions. Serial line sniffer是一个串行端口记录工具。它监听指定的串行端口并记录所有通过这个端口的两个方向的数据。 来源：http://freshmeat.net slsnif是一个串行端口日志工具。它监听特殊的串口，记录所有通过这具串口的两个方向的数据。 类别: Development Status: 5 - Production/StableEnvironment: Console (Text Based)Intended Audience: DevelopersLicense: GNU General Public License (GPL)Operating System: LinuxProgramming Language: CTopic: Communications, Debuggers
标签： serial port specified logging
上传时间： 2013-12-12
上传用户：silenthink
